Find a fence repair professional in NSW

I have a gate that the lock has come off. The bracket has come off the gate , a pailing has come loose,needs a piece wood for the bracing of the gate .

Front gate, repair gate paling and reattach hinge. Gate will need to be taken down, squared up and re-installed. Screws missing. Side gate needs to be rehinged, screws available

Need to repair fence extender on timber lap and cap pine fence. These fence extenders were from bunnings and were damaged recently in high winds. Approximately 4 sections need replacement or repair.

1 of the 3 Post in front of the house was detached due to an accident. The post is half brick half wood (top) and was attached to the ground by a metal rebar.

4 issues need to be resolved so the pool passes compliance testing. Issues are: 1) side poop gate (this is a standard backyard colourbond gate) gets caught on bamboo screening and doesn’t swing through its full arc of operation. This gate also does not self close and latch. 2) glass pool gates (x2) need to be adjusted so they properly self-close and latch. 3) glass pool gate (x1) is 10mm short of regulation height and needs to be raised. 4) glass pool gates (x2) need installation of 60 degree safety cap to top of each hinge.

Fence needs to be stablised or the 2 panels that are damaged need to be replaced.

Fence has been hit and knocked out of place. Need fixed

Colorbond fence gate collapse after strong wind. Reuse existing frames and sheets since it is still in good condition. Screws all gone and need to be replaced. Reattached the gate.

The joint of fence has broken. The fallen fence needs to be re attached. Please see photos attached.

leaning colourbond fence

A pool gate needs to be converted to a fence panel. This needs to be done so that it is just fixed to existing posts on either side. This is likely to require modifying pool fence brackets to hold the gate panel in place. Any other experienced solutions will be welcome.

1. repair gate where timber is cracked (see photo) 2. re-attach the gate latch to the repaired timber (see photo)

Need to fix the gate please. Install it into the ground properly with cement and fixing the fence part properly to the perpendicular fence.

Repair 1 section of detail rail fence, remove old concrete, bend rail back into shape, set new concrete. (I accidentally reversed into the fence)

Dog has chewed side gate wondering if gate can be saved or if whole gate needs to be replaced looking for quotes

Truck damaged metal fence panelling - replace damage sheets with matching 2 sheets required

Our ride on Mower slid sideways down a slope on damp ground and lodged itself inside a wire fence panel. Task is to get the mower pulled out, and the fence fixed. See pics for details. I have a pre-made panel of dog mesh to repair it with.

Need infill sheet replaced for colorbond gate. 2.8m W x 1.8m H. Install drop bolt, safety latch keyed lock. Gate to be raised by 50-60mm while refixing. End posts, stiles, frames etc are all reusable.

The timber on our side gate has rotted from all the rain and needs replacing. Please see attached the photos.

Our wooden gate has been damaged; the frame has come undone. It needs rescrewing and reseating against the fence line. The hinges etc are ok - just needs to be reattached