Find a fence installation professional in North East Melbourne

Need to replace old wooden fence with Colorbond fence about 20 meters long

I have two sets of gates that require sandblasting and powder coating looking to have these gates installed plus completion of front fence supplied steel panels . Property is on elevation requiring someone with knowledge and experience to do this job . Photos will be provided of the property .

The backyard fence is deteriorating a little bit, it needs to be reinstalled. I need someone who has done some fences before and has experience in that field

Colour bond fence need to be installed

Need a 13m brick fence built on our property with double swing gate, pedestrian gate and secure parcel box.

Looking for a quote to install gates at our property. We had recently redone the fence and existing gates needs to be replaced. We are looking to use our existing gate frame and install new meribu battens ( will be provided ). Need new post for the gate ( one side ). The post needs digging to 700 mm deep. All necessary items will be sourced. Requesting quote for install. Thank you.

I am looking to remove my wooden side gate and replace it with a white colourbond gate. I have included a photo of the type of gate I would like, plus a photo of the old wooden gate (which will need to be removed) and the space. Approximately width of gate is 1200mm.

Install an above ground pool. Size 16m x 6m. Need done asap

Fence Side gate install required

There is a small fence between two units falling down, needs to be replaced with either timber or colorbond, all rubbish must be removed.

I would like to install a brick fence on my frontyard with 1.2 m height. Length 15m. Brick with steel panel also being considered. Thanks

I have gate gate and remote ready just need to install

I would like to block off the side of my house with a fence panel or something similar. It doesn’t need to be a gate, it can be fixed and immovable. When referring to the photo, it needs to be down the other end of the house, it would need to be approx 1m wide by 1.4 high.

The bottom of the fence needs a sleeper installed - it's about 20cm high and 2.5m wide.

Replace timber with colourbond . I can get colourbond or you can whatever easier. I will get rid of timber. Whole needs to be done in continuous days. Easy access to both sides . Must be 2.0-2.1 high

I require a replacement fence/gate to replace existing aged fence/gate leading from carport to backyard. Photo will be posted tomorrow. Approx 1 m x 1.5 metre gateway with 2-3m in total. Material negotiable but suggest plain timber. Possibility of further work painting carport posts and gutter to give a clean finish (this aspect not included in budget quoted). Prefer a quote for job after attending to view or viewing of photos. Quoted budget does not include materials. Edit: I have posted pics of existing gate which has been fixed many times and is old. I don't have a particular kind if gate in mind - this is an investment property so I would like practical and effective. The galvanised options sounds good, and timber as well if a lot cheaper.

Timber material 14m back of the house and left side front of the house with gate.

Remove 5 old fence posts and replace with 5 new and some sections of pailings.

Fence palings 1800 Plinth board 150 Fence 8 meters then 8 meters then 2 meters then pedestrian gate 900 then fence 2 meters roughly all the measurements and remove and get rid of old fence

Remove and replace 6 fence palings. Cut tops to match existing length (approx 165cm) I will supply the fence palings.