Find a fence installation professional in North West Perth

Install fencing on limestone wall.

Hello Contractor, This is a two-part job: **Part 1 – Garden Clean-Up** Sweep and remove all sand from the footpaths and pavers, returning it to the existing sandy areas. Fill in any holes dug by the dogs and tidy the sandy areas so the garden looks presentable. There is no requirement to replace sand or completely level the garden, as these areas have always been sandy. Previously, this has only taken a couple of hours. **Part 2 – Installation of Fence** Install a fence approximately 1 metre high to enclose the pergola area, returning into the garden at one section, as shown in the provided image. The purpose is to restrict the dogs to one designated area rather than allowing them access to the entire backyard. We are open to different materials, although wooden lattice fencing may be the easiest and most practical option. I am happy to meet you at the property to explain the requirements. **Timeframe and Costs** We anticipate the entire job taking a maximum of one day. The quoted labour price should include collecting the required materials and transporting them to the property. All material costs will be paid separately, in addition to the agreed labour price.

About 12m of pool fence to be installed

I'm looking for someone to install a diamond-pattern stainless steel wire trellis for climbing plants on two garden walls in Burns Beach, Perth. A fully dimensioned drawing is attached. It shows every fixing position, wire run and cut length. Scope: Wall 1: 6.5 m long × 2.0 m high. One continuous diamond lattice with wires at 45°. Wall 2: 17.5 m long × 1.8 m high. Two lattice panels, stopping 100 mm either side of an existing glass pool fence. Fixings: 75 eye screws in total, set out at 750 mm centres along the top, bottom and ends of each panel, per the drawing. Wire: about 170 m of stainless wire rope. It's threaded through the eyes in 22 runs, each tensioned with a turnbuckle and secured with wire rope grips. Walls: [rendered masonry / brick / Colorbond fence]. Fixings into the top of the wall and at ground level, so please allow for suitable edge distances. Materials: I will supply the 20 × Garden Zen 10 m Tensioned Wire Wall Plant Trainer Kits from Bunnings Please include in your quote: All labour and tools Setting out and installing all fixings, wires and turnbuckles to the drawing Tensioning the wires neatly, with no visible sag Please tell me in your quote how long the job will take and whether you've done wire trellis or balustrade work before. Photos of similar jobs would be great.

Looking for an experienced handyman, fencing contractor or pergola/shade installer to help install 8 steel posts around a pool in Sorrento. The posts and holes are already prepared: * 8 × 90x90mm powder-coated steel posts * 4 posts each side of the pool * Posts are approx. 3.2m long, with about 1m going into the ground * Holes are already dug, approx. 300mm wide × 1m deep * Posts need to be set straight, level, evenly aligned and concreted in I’ll arrange a Concrete Taxi with approximately 0.5m³ of concrete. They mix onsite and include 45 minutes onsite, so ideally everything would be positioned and braced before they arrive so the pour can be completed efficiently. I mainly need someone with experience setting posts accurately who can help with positioning, levelling, bracing and the concrete pour. All steel and concrete supplied. Located in Sorrento WA 6020

I need an experienced fencing, pergola/shade-structure installer or capable handyman to accurately set and concrete 8 powder-coated steel posts around an existing pool in Sorrento. The budget/offer is for labour only and doesn’t include concrete. I’m aware this will be an additional cost. The preparation is largely done: * 8 × 90 × 90 mm steel posts, 3200 mm long, already supplied * Posts to finish approximately 2200 mm above ground / 1000 mm below ground * 8 × approx. 300 mm diameter × 1000 mm deep holes already dug * 4 posts each side of the pool * Each row is 5 metres long, with approximately 6.7 metres between the two rows * 2 × 5 m horizontal steel rails are also onsite and can be used to help establish accurate alignment * concrete can be arranged. The main job is to: * accurately set out the posts * ensure both rows are straight, parallel and square * get all 8 posts plumb and at a consistent finished height * securely brace them before the concrete arrives * assist with placing/rodding the concrete and rechecking alignment during the pour No post-hole digging, welding, electrical work or paving required. This needs someone comfortable with precision steel-post installation, not simply filling holes with concrete. Please mention relevant fencing/pergola/shade-structure experience and whether you can supply the temporary bracing/set-out equipment required. Location: Sorrento WA 6020.

Looking for a handyman or fencer to install approx 280 metres of 120cm high mesh onto an existing boundary fence across three sides of a property (Southern, Western, and half of Northern perimeter). The Setup: • Materials: All mesh rolls are already purchased and on-site. • Existing Structure: The fence is in good condition with a mix of timber posts and steel star pickets. It already has a 900mm mesh fence with two plain wires above it (the top wire sits perfectly at 1.2m high). • The Job: No heavy wire tensioning, post-digging, or concrete pouring required. You just need to unroll the new 120cm mesh, hand-stretch it taut to prevent sagging, and fasten it to the existing structure, timber posts, and top wires.

To replace the broken lattice panels with the new ones

I'm looking for an experienced tradie or fencing contractor to supply and install a side fence and gate at my new residential property in Eglinton, WA. Project Specifications: Location: Eglinton, WA Opening Width: Approximately 1.75 metres Height Required: 1.9 metres Scope of Work: Supply all necessary materials (posts, framing, panels/slats, gate, hardware, etc.) and complete the professional installation of the fence and matching gate to secure the side access of the house. Please see the attached photo showing the side passage/opening space where the work needs to be carried out.  When offering your quote, please let me know: 1. Your total price (including supply of materials and installation labor). 2. What style/material options you recommend or provide. 3. Your earliest available start/completion date. Thanks!

I'm looking for someone to install a gate, similar to the one in the neighbours photo, dimensions are in photos, would be 1.33m by 1.2m.

Looking for someone to install a mesh barrier along approximately 12 metres of our existing metal fence to prevent rats getting underneath. Work required: * Dig a continuous, narrow trench approximately 200mm deep along the fence. * Install the supplied mesh against the fence, extending at least 200mm below finished ground level. * Secure mesh every 300–400mm and at posts, corners and ends using suitable corrosion-resistant fixings. * Overlap mesh joins by at least 150mm and secure firmly. Close gaps around posts, ends and uneven ground. * Fold or cover cut edges so no sharp wires or fixings are exposed. * Backfill with the supplied gravel and soil, compact and leave the area neat and stable. * Remove offcuts and clean up on completion. We supply the mesh and gravel. You must bring all tools, including a trenching shovel, mesh cutters and drill, plus suitable screws, washers, clips or ties. Access is through a garden bed with established palms and plants. Care is required around roots and irrigation, and to avoid damaging the fence. Please check the attached photos. Preferably completed within the next two weeks; flexible on the day. Please include labour, fixings and any additional materials in your offer, and confirm your availability.

Hi, we are looking for a reliable tradesperson to supply and install a gate to close a gap between our house wall and the existing fence. Task Details: Gate Installation: Supply and install a gate to close a ~2m wide gap. Site / Materials: colorbond to match fence colour Additional Quote Requested: We would also like a separate estimate/quote for installing an extra fence panel on top of our existing retaining wall while you are here. . Thanks

Replace current balustrade with a new aluminium balustrade with vertical slats, at the front as well as side balustrade. All pieces to be in surfmist colour

Source and installing security gate

Need to design and install fence or gate for dog near laundry Photo provide regarding area If want can come and take dimension Roughly 1-1.2 m width and. 1.5 m height

The security gate securing a loading dock door is jamming. We think a truck has bumped it and damaged the gate and tracks.

I need a 5 meter pool fence with one gate Photo with a chat gpt design for reference

6 1200x1200 glass panels 2 x in ground(block) saddles per panel(required) Limestone boring (50mm) required Chemical-Set adhesive binding

approx 25metre fence of aluminium slat fencing to front house including a gate

Need gate fixed or replaced