Find a fence installation professional in South Brisbane

Need a new side gate. Width is 3m height 1.8m timber.

Timber Fencing - replacement of entire 20m front fence. Supply of materials required, as well as installation of fencing and two gates: one path gate and one driveway gate. The existing fence will need to be removed. Fence palings are 1.2 high. Quote should be for treated pine. And would be helpful to know a price with/without painting (paint and primer supplied).

I need a fence built that is about 5m in length. I have most of the materials with ezi slate panel frames.

Remove the existing timber fence. Replace with new timber fence Paint fence Remove rubbish and clean up

Looking for quotes to install a Fence with Sliding Gate. Please include labour and material cost in the quote. Frontage: 10 m Fixed Fence : Left of Driveway: 1 m Right of Driveway: 5.5m Sliding Gate on Driveway: 3.5 m With motor and remotes

Hi, needing someone to finish this fence (palings all on site) just straight flush timber fence with a cap. Posts and concrete already done

Need to install 3 driveway kerb edge ramps of 1.2 metre each. See product and installation details at https://esafetysupplies.com.au/products/driveway-guru-kerb-edge-ramp-1-2m-section Material will be supplied by me

Source and install fence. 8.5m and 5.5m including one gate in each section. The 8.5m section is on a slope.

I need two pool fence type gates supplied and installed on both sides of the house gap 860mm one side and 1530mm otherside. Need to keep pets out

Looking for someone to put a wooden fence with a gate from the house to the existing fence. Want it done asap. You will need tools and to source the materials for the job.

Need supply and install colorbond side gate ,

Drop the gate post into the ground and swing the gate.. level the ground and spread 3 m3 of wood chip. Gate supplied.. Can supply the wood chip and gate post..

We need to install a gate and small fence panel to create a dog safe area beside the house asap. Would need to be at least 1.5 high. The area is approximately 2 m wide. Thanks.

Supply and install new Colourbond fencing, approximately 1800mm high. Colour: Surfmist (posts and rails also Surfmist). Include timber sleeper (200x50mm) at the base. Complete removal and disposal of the existing damaged fence (partially broken due to recent cyclone - photo attached for reference). Site clean-up after completion. We have received a quote of $4500 for this work (including $500 for rubbish removal). The contractor who provided is busy and cannot make it in the next few weeks and hence reaching out to Air Tasker. Please provide your best quote. Thanks for your consideration.

Need this gate replaced, dimensions 1.40m wide by 1.80m high. Thanks

I am after someone to install a colour bond fence, it’s 11.5m worth and I will supply the fence. It’s just down one side of the house Would also like two gates to be bad opening in 3m. See pic attached

Hi guys , I need someone to help me install sliding gate and side gate . I have got all the materials . Only need an install

Need the 4x single fence palings shown in the photos to be repaired/replaced

Need someone to supply and install a new replacement panel after 1 broke on me over weekend Size 10mm thk 1380mm wide and 1200mm high

Collect eight fence panels from job site at Wellington Street Coorparoo and transport them to another job site a Allambie Street Carina and set them up on their footings so the fence boundary is secure. Needs to be done by 6 pm today.