Hire professional local solar panel installers near you

Need a price for removal of 20 solar panels

Dux Hot water system solar hot water panel sensor install on double storey home. Part provided #H4336

We need to disconnect a solar panel on the car - we realised the wiring goes to the car battery, and then through to the back of the car where the second battery is installed. We want to disconnect the solar panel but maintain the dual battery system.

I need help setting up my new Ecoflow Delta 3 Plus portable power station and, to set up and attach brackets to my 2 new rigid on the ground solar panels. I am in Frankston, Victoria. - I need someone to attach with screws, 4 tilt mount brackets onto 2 portable rigid solar panels that will sit on the ground. The job whole 2 part job should take about 1.5 to 2 hours. - I am disabled and so can’t manage any lifting. • I can afford $250 (negotiable) for the right person with experience in this type of set up. - Note that the panels weigh 22 kilos each and as they have tempered glass and are expensive, they will need careful handling please. - See easy to install brackets, Youtube video before arriving and images. https://www.youtube.com/watch?v=BAfXKVRlipA Recommended Tools (Not Provided): Adjustable wrench (M8 and M12), Tape measure, Safety glasses, Work gloves. - The panels have electrical cables that will need to be attached to my new Ecoflow Delta 3 Plus portable power station. (see very helpful, easy video below). https://www.youtube.com/watch?v=vgJeHiCbco8 - This 2nd part of the job requires experience with electrical terminology (prefer an electrician or someone who has set up rigid solar panels (see image) or who has experience with setting up an Ecoflow portable power station (again, this is not time consuming if you know what to do). - Please send references. - I'd like to have the job done within a week or two, if possible. - I require a warrantee for work done (a text will do), and in case of any damage done during job. - SEE Rigid Solar Panel and Bracket Installation .pdf file. file:///C:/Users/Graphics/Downloads/1%20ECOFLOW%20INFO%20AND%20VIDEOS/AIRTASKER%20ECOFLOW%20JOB/USE%20THESE%20FOR%20ADS/1%20EcoFlow%20400%20W%20Rigid%20Solar%20Panel%20Manual%20YES%20USE%20THIS.pdf - SEE Delta 3 Plus .pdf file:///C:/Users/Graphics/Downloads/AIRTASKER%20ECOFLOW%20JOB/https://manuals.ecoflow.com/eu/product/delta-3-plus?lang=en_US

I want to install bird proofing net on my solar panels. There are 10 panels on one side and 28 panels on other side of the roof. I can provide the material (is net, clips, etc)

I've recently bought a campervan, but unfortunately the van + the roof rack + solar panels is too tall for my parking garage. I think the most straight forward job is to remove the rear solar panel that is knocking the height warning bar of the garage for now. It's attached to the z bracket but for now I don't have the tools or time at hand.

We had solar panels installed a few years ago and only recently found out they missed a section close to a skylight and birds are now nesting underneath it. We need someone to come and install mesh - somewhere between 1m and 2m of it. Note we have a double storey house and it's quite high.

We have taken down our solar panels due to renovation. We are ready to have them reinstalled on our roof. The setup we have is jinko cheetah + sungrow crystal premium inverter.

I need four small solar panel brackets installed so I can charge our outdoor Arlo cameras. I have attached pictures of the brackets and the location of the Arlo cameras. Two brackets need to be installed on brick, and the two other on axon cladding. A ladder will be needed. House is single storey. Max height is 4m.

Have 3 wireless cameras that need installation to exterior of house, normal ladder, they come with solar panels that will also need installation. No programming etc required just installation.

Need help with the following: -Mounting 1 wireless security camera (Swann Xtreem4K Wireless Security Camera), to be mounted on the spot outside the front door, refer to the left 'X' mark in the 1st photo for the approx position. Making sure the angle when securing is the right angle for viewing the camera feed (I will help by using the app) - Mounting 1 solar panel that is attached to the camera by cable (Solar Panel for Swann Wire-free Cameras) to be mounted further apart from the camera, refer to the right 'X' mark in the 1st photo -Taping the extra cable to the wall if needed Note the setup of the camera is in an app and is already Done, the solar panel also works, see 2nd photo for the camera and solar panel. You will need to bring your own tools (drill, drill bit suitable for masonry ideally). Required screws/ wall plugs come with the camera and solar panel. Ladder in the picture can be provided, and I can also provide help when needing to secure things in place, checking the angle of the camera etc.

I need an experienced auto-electrician or caravan/solar expert to help me diagnose/check/remedy my portable solar panel setup. I want to increase solar power input and battery storage to my caravan when I'm travelling 'off grid', so I have setup a portable solar panel system; this is fully separate to the caravan's existing 400w roof-mounted solar panels. The solar power setup that comes with the caravan has 400w solar roof panels that feed directly to the van's lithium batteries via a Redarc Manager 30 BMS. To augment that supply, I have 3 x separate portable solar panels (with a total output of 590w), that I setup when stationary/camping. These panels feed to the caravan batteries via their own regulator/controller; the feed is direct to the batteries, bypassing the van's Redarc management system, so the two systems are not connected. The problem I have is that the portable panels work for a while (delivering increased amperage to the batteries over and above that generated by the van's roof panels) but after a while they seem to cut out and I get zero amps delivery, even in full sun. Could be the MPPT controller/regulator is acting up or some of my connections, not sure! So - I need help with isolating the problem and remedy! If you are good at diagnosis and know one end of a multi-meter from the other, an hour or two on-site should be sufficient for the task. I will have the panels setup ready for inspection.

We have recently moved to a house with solar panels. Photonof inverter attached, but it’s not sending anything to grid and I need help to figure out what’s wrong and what we need to do to fix it,

I would like the solar panels on our roof cleaned. Small solar system, 12 panels.

Need solar panels taken off site and disposed of correctly (panels have been removed off property and stacked)

Install 6 solar panels tiled roof. All components supplied.

Job Title: Installation of 3x Ring Spotlight Cam Pro (Solar) – Two-Story Townhouse Location: Bayswater North, VIC Two-story townhouse – address to be provided upon job acceptance. Scope of Work: Install 3x Ring Spotlight Cam Pro (Plug-In) units, each with its own Ring Solar Panel. Preferred mounting locations are under second-story eaves – installer must have a ladder tall enough to safely reach and work at these heights. Cameras and solar panels are brand new and pre-charged. Cables will be routed according to best practice to maintain neat appearance and secure connections. Installer must bring all necessary tools, brackets, fasteners, sealant, etc., to complete a clean and secure installation. Requirements: Proven experience installing outdoor Ring cameras, especially the Spotlight Cam Pro with solar panels. Familiarity with Ring’s product specifications and installation process. Product Page Installation Guide: https://ring.com/gb/en/support/articles/cr9u7/Physically-Installing-Spotlight-Cam-Pro-Solar?utm_source=google&utm_medium=cpc&utm_campaign=pmax&gad_source=1&gad_campaignid=20930702809&gbraid=0AAAAADI_e5szY4DoUvdrUBgUk1XFsfeB2&gclid=Cj0KCQjwgIXCBhDBARIsAELC9Zi1JTudYXMvXI-pPjV06vAwLsDk17m0qBEmWbJnGfd7T_Ea4zr0UDsaAk1nEALw_wcB Confident working at height and complying with safety standards. Must verify Wi-Fi signal strength at install locations (if required). Assist with app pairing and testing live view once physical install is complete. Timing: Installation date is flexible but ideally within the next [insert your timeframe – e.g., 7 days]. Expected job duration: 1-2 hours depending on access and complexity. To Apply / Book: Please provide: Examples or photos of previous outdoor Ring camera installs. Confirmation of required tools and ladder. Your availability. Flat rate or hourly quote (specify which).

I have a cracked roof tile which I situated under a solar panel that I need replaced

Would need some help in removing 5 solar panels so I can have another contractor to fix my roof leakage. After the roof fixed, would need help to put the panels back and reconnect it and ensure everything works the same as before

I need to remove 14 solar panels on good access flat roof so that roof can be repaired . The panels then need to be re-installed a few weeks later