Find a trusted local light installation service in VIC

I require an electrician to install 2 large pendant lights,8 a disco glitter ball and electrical spinner.

Need down lights installed at our shop.

This needs to be replaced with a new heating light

Need a pendant light installed in the kitchen. Electrical provision (wiring/point) is already in place — just need noggins/blocking installed in the ceiling to support the fitting, then the pendant light mounted and connected. Scope: Install noggins/blocking in ceiling cavity for pendant light mounting point Install and connect pendant light fitting (light supplied) Test and confirm working Location: Clyde North, VIC

Need a new pendant light installed in my living room. One has already been in the exact same place but unfortunately broke so just need the new one up to replace it. Ceilings are 3.7 metres high

Need a new ring floodlights installed

Seeking a licences electrician two install two bathroom heat lamps (separate switches) and two outside sensor lights (replacing existing lights). Bathroom job will require plaster to be fixed, which we will take care.

Starry light installation. Panel will be provided cost is only for labour. Room is 4x5 total 20smq

3 or 4 pendant lights need to be installed need handyman who have a knowledge or electrician .

Uninstall a faulty ceiling light and install a new one

30 downlight to replace exsisting

Need to install 2 up down coolum lights for our front pillars. Lights have normal plug but the pillar have only sockets with wire provided.

Licensed electrician required to install 2 x Philips Hue Akari downlights in my Melbourne CBD apartment. Scope of works: * Remove 2 existing downlights * Enlarge existing ceiling cut-outs from approximately 63mm to 90mm * Convert existing hard-wired connections to plug-base connections suitable for the new lights * Install 2 x Philips Hue Akari downlights (lights supplied by me) * Test operation and ensure installation complies with Victorian electrical requirements Details: * Apartment with plasterboard ceiling * Existing lights are currently wired directly into the electrical circuit (not plug-based) * New lights require 90mm cut-outs and plug-base connections * Looking for a neat, professional finish with clean cut-outs and no ceiling damage * Licensed electrician only * Please include any parts required (e.g. plug bases) in your quote and advise whether a Certificate of Electrical Safety will be provided

3x white downlights and 2x three spotlight black ceiling lights need to be installed.

Currently has downlight need heating 3in1 heating light installed

Two wall mounted lights installed on wall and connected. They will be installed ons brick wall so there will need to be some conduit run from ceiling. There is easy access to ceiling directly above proposed installation spot. There is also power and a pre existing switches that could also be used

Hi, I’m looking for someone to install some lights in my bedroom. It comes with a remote so i would need that to work and to be connected to the switch as well. You will need to come with your own tools since I don’t have any. The last photo is the current light I have.

Licensed electrician required to install a ceiling light. This is a straightforward job involving the replacement of ONE light fitting only (a single Lexi Lighting fixture with multiple arms, 6 x E27). Existing wiring is already in place, and I will provide the mounting bracket, instructions, and all required bulbs. The job may involve some minor drilling into the ceiling to secure the new bracket. Scope includes removing the existing fitting, installing and mounting the new light, connecting the wiring, and testing to ensure everything is working properly. Please confirm you are a licensed electrician when quoting. If the job is done well, there is potential for further work in the future. Note: I have a ladder available.

Need 2 pendant lights installed in our kitchen and dining area. Pendant lights and bulbs provided. NEED DONE TODAY THANK YOU

I need my old security spotlight removed, and replaced with new unit. Very simple. I would do myself but I think someone who knows exactly what’s going on is important. Ideally I’d like someone to come and do straight away. It’s a 10min job