Find trusted local electricians in Windsor QLD

Install a small wall light in kitchen

Licensed electrician needed today in Windsor 4030 for a ground floor apartment. It is a short stay rental with a guest currently in residence, so it needs to be completed today and worked tidily around them. What we need Supply and install hardwired downlights in the bedroom to serve as the main lighting for the room. Hardwired only, no plug in or battery fittings. The room currently has a ceiling fan with an integrated LED light. That light has failed and we are not repairing it. The fan itself runs normally and is to stay in place and keep working on its remote. Scope of work Assess the room and advise how many downlights are needed for even coverage, and where they should sit around the existing fan. Supply and install hardwired LED downlights, warm white, mains wired into the existing circuit. Wire them to operate from the existing wall switch in the room. Isolate or disconnect the failed light on the ceiling fan, your recommendation on which is cleaner. Leave the ceiling fan in place and confirm it still runs correctly on the remote before you finish. Make good all ceiling penetrations and clean up before leaving. Photos of the room before and after, and a certificate of electrical safety on completion. Before you start Send us your price and the number of downlights you propose, and wait for our written confirmation before purchasing or installing anything.

Licensed electrician needed today in Windsor 4030 for a ground floor apartment. The property is a short stay rental with a guest currently in residence, so this needs to be completed today and done tidily around them. The problem The light built into the ceiling fan has stopped working. The fan itself runs normally on the remote. The light does not come on. What has already been tried The wall switch has been tested in both the on and off positions, by the guest and separately by our onsite handyman. The remote has been tested with the wall switch on, which is the correct operating sequence for this unit. It is an integrated LED, so there is no replaceable globe. Our handyman removed the faceplate to look at the exposed wiring. When he moved the wiring slightly the light flickered on briefly, then went out. He could not reproduce it and stopped there as he is not licensed. That points to an internal wiring or driver fault rather than a switch, remote or globe problem. Scope of work Diagnose the fault and repair it if it can be repaired on the day. If a same day repair is not possible, we want the option to replace the ceiling fan and light unit outright in the same visit, so please come prepared to advise on that. Before doing either, send us a price for the repair and a price for supply and install of a replacement fan and light unit, and wait for our confirmation. Photos of the fault and of the completed work. Make good and test the light and fan on the remote and the wall switch before leaving. Background that may help The ceiling fan was installed by an electrician around six months ago.

Licensed and insured electrician required for kitchen renovation in a Windsor QLD unit. Target October 2026; two coordinated visits. Indicative budget $750 for existing-position kitchen services. Quote incl. GST if applicable. BEFORE DEMOLITION: isolate/disconnect the existing freestanding cooker and affected kitchen electrical fittings as required, making the area safe for cabinet/splashback removal. AFTER INSTALLATION: refit affected kitchen electrical fittings, test and provide required completion documentation. Retained stove is assumed GAS, with gas disconnection/reconnection and appliance securing in a separate plumbing/gas package. No new cooker supply. Include fit-off of affected existing-position kitchen outlets and installation/connection of our supplied compatible rangehood to existing suitable provisions. Cabinet/hood cut-outs by cabinet installer, coordinated with you. Include minor connectors, fixings and ordinary consumables. State how many outlets your offer covers. Verify retained stove/oven model. Include safe treatment of existing ignition power where applicable. If the unit has a hardwired electric oven, separately itemise its disconnection/reconnection; that extra oven work is outside the $750 base allowance. Gas work is by the separate licensed gas fitter. Retain service positions where practicable. New circuits, switchboard upgrades, major rewiring, masonry chasing, new ventilation duct routes and building penetrations are outside base allowance; inspect and quote any necessary additions separately before work. No under-cabinet lighting requested. Existing kitchen photo and proposed Kaboodle 3D image attached; verify dimensions on site. Check appliance dimensions, clearances and rangehood compatibility before work. State licence/insurance, availability for both visits, inclusions, testing/documentation, exclusions and any return-visit fees.

I have 2 old table lamps. The electrical cords in both are thick and clumsy and the switch in one is right near the base of the lamp which makes it unstable

I need a qualified electrician to swap over 3 light fittings and check a 4th that keeps blowing globes . Please provide your guide (and ignore the $10budget). Thanks

A fan to be installed, and three power points. Power is just behind all new power points

Please make me some offers. 90$ an hour. I have rooms upstairs and downstairs where I would live calling fans. 5 in total. We just got the house. Settlement was today so it’s empty. The ceilings upstairs are high. The ones downstairs are lower. I would also like a fabulous light on the dining area. So 6 jobs in total. Also- I have some light switches that I want replaced too.

I’m having a new fence installed and I need a registered electrician to disconnect the exisiting electrical which is mounted on the current fence so the builder can put the new fence in and then reconnect the pump onto the new fence.

We need a licensed electrician to attend Windsor, QLD tomorrow, 4th November, to install a new ceiling fan/light combo unit. Details: • We will supply the new fan/light combo (purchased from Bunnings). • The existing unit has stopped working. • All other electricals in the property are functioning normally. • We have replaced the bulb, but the issue persists. • The switchboard shows a red indicator light suggesting a connection issue, but all breakers are on and other lights/powerpoints are operational. Task Requirements: • Remove the existing ceiling fan/light combo. • Install and connect the new Bunnings unit. • Check switchboard and confirm safe electrical connection. • Test functionality after installation. Ensure the fan and light is fully functional at the of the job.

Smoke alarm needs new batteries. Chirping in one of the rooms. We have high ceilings so can’t reach and need a tall ladder

Remove old fan and install a new one. Replacing fan with compact version. Refer to photos: Example of new fan in the 1st two pics , last pic existing fan. My New Fan will be purchased prior unopened and ready for installation. Job Location is Windsor 4030.

We need to swap out two breakers with RCDs (we have these already) and connect them to new lines that have been run to the power board already. The location is in Windsor. I expect this can be done in under an hour. Please quote for an hour of time. We prefer to do this before or after work hours (before 8am or after 5pm). Sooner is better.

Urgent – Instant Hot Water System Not Working (Windsor QLD) – Handyman/Plumber Needed Description: Our instant hot water system has stopped working and we need it diagnosed and fixed urgently today. We are also looking for a reliable handyman we can use on an ongoing basis for maintenance and repairs. Job Details: • Location: Windsor, QLD • Task: Diagnose and repair instant hot water system (restore hot water today) • Ongoing handyman work available for the right person Budget: Open to quotes (please include call-out fee + hourly/repair rates). Requirements: • Experience with instant hot water systems (electric or gas) • Must have tools and be available today • Reliable and professional

Looking for a qualified electrician to complete the following tasks in an apartment located in Windsor, QLD: • Replace all oyster lights (approx. number can be confirmed onsite) • Install a new PowerPoint in the kitchen for a microwave • Replace/install bulb on patio balcony • Fix kitchen light switch that has popped out • Advise and assist on running the antenna connection directly to the TV (current setup unclear – need inspection and simple solution) Please bring necessary tools and fittings. Access is available during weekends and weekdays by arrangement.

2 kitchen power points to be replaced. I have 1 new power point will need 1 other supplied. 1 light fitting to be replaced and new fitting installed.

Need a licensed electrician for the following at a home in Windsor, QLD: • Fix non-working bathroom light • Rectify issue with patio light • Test all other internal/external lights to ensure they’re working correctly Details: • Residential property • Must be done Monday • Licensed electrician only – bring necessary tools • Easy access and on-site parking available

Need a split aircon repaired. It's not cooling enough. It's an actron 2.65kw reverse cycle unit. Thanks.

Need a new oven connected and a line to switch board need a quote asap come to discuss cost in person not online thanks

Looking for an electrician to repair the garbage disposal that shorts out the house when used, install 3x indoor power points and 1 x outdoor power point. Put up 2 x flood lights (already have the lights). House is a queenslander with good under house access and power is already at the points where the lights need to go.