Find local power point installers in NSW

Power point on wall in my house, all of suddent doesnt have any electricity

Need the following done - will aim to supply however for offers please note addition if you were to supply below Note: white sensor light seeking/white covers for PowerPoints Amounted budget not fixed open to best offers - 1x double PowerPoint + 2 switches (dining room) - 2 light switch (back door) - 1x power point + switch (back door) - laundry light switch 1x power point - 1x double PowerPoint and switch laundry - Kitchen double double (switch and plug) - Kitchen two PowerPoint -3 switches - One switch (study) - Double switch hallway - One switch Hallway - One switch lash room - Changing lahs room floor plug to a double plug and double switch ***** - 1 x switch main bedroom - Main bedroom double switch and plug - Double double main room - Front door double switch - Garage double PowerPoint bottle right corner of wall (for machines) - get rid of the middle wall PowerPoint not needed anymore) - Bathroom single power point and single switch - Single light switch cover bathroom - Four light switch cover - 3 down lights in backyard along yellow - 3 SENSOR light side of house (black) right (white) - 2 sensor light black side of the left (white ) - Ask him to swap two front ones to white not black

I have 3 power points that need replacing

Need a qualified electrician to complete electrical work at a residential property. Please inspect the existing electrical setup, complete the required installation/repairs safely, and ensure everything complies with Australian electrical standards. Please provide your own tools and advise if any additional materials are required.

Create new Power socket in balcony

Add a power point for the TV mount

I have low voltage power circuit that can be converted into poser point to connect faoutain Buddha

Hi, I need 3 power points installed outside around the house.

Need three power points to hang the tvs. Ones is downstairs. The other two upstairs with easy access to the roof.

Hi I need an electrician to add a back to back double power point on gyprock. Currently there is a power point on the garage wall on gyprock need to add a double power point opposite side thru gyprock. Must provide the double power point and it needs to be a specific brand check my photos of what it needs to be.

We need 5 power points installed! 5 pcs of brushed wall plates, as we want the power points hidden behind the wall for each screen on display We have two existing power points which are 10AMP

I have an external power point that I need installed by a licenced electrician. I will supply the materials (external weatherproof power point)

Looking for a licensed electrician for a few small jobs in one visit: 1. Replace 2 existing wall sconces with new light fittings (new fittings will be supplied) 2. Install a new backlit mirror (power connection required) 3. Fix a double power point – one socket isn’t switching on All fittings/fixtures will be on-site and ready to go. Looking for someone with the right licence/certification who can provide a compliance certificate if needed. Category: Electrical Location: Allambie Heights, NSW 2100 When: Flexible – within the next week Budget: $300

We're looking for a licensed electrician to install a new power point above our shelving. The cable can be run down from the ceiling cavity directly above, so it should be a straightforward installation. We expect the job to take around an hour, and our budget is approximately $500. Please send through your offers. **Licensed electricians only, please** Thanks!

I need to replace 2 power points and 2 light switches. 1 set is in the bathroom on a tile and the other is in bedroom. I have the replacement parts. Just need to replace them and fit them on the wall/tiles

I am looking for a fully licensed NSW electrician to supply and install one new extra power point in a bathroom at a single story house in Padstow and able to provide CCEW. Just take extra care of the wall tiles.

We are looking for an electrician that can install 6 x power into joinery and 5 power points into plaster wall. All holes are already cut in plaster and joinery. Labour only. Materials are on site. We have installed some new desks into an office and there is existing power from old desks so there is a loop from an existing power point through the joinery already. You will need to. Fit off of power points. Wire 3 loops into existing power points. To liven up. Must have electrical licence. Easy access to job. You can park 10m from the work location. Plenty of parking. No stairs or lifts.

Need a licensed electrician to replace 3 light switches, 3 double power points and 1 bathroom batten light fitting. I have already purchased all the replacement fittings. Please install them and test that everything is working properly. Photos attached

Install the power point at the back of the house when the electrical box is at the front. It needs to include parts and labor.

Screw in 3 light switches 1 power point 1 light