Find experienced deck builders in VIC

After composite decking for rectangular 28m2

Composite decking supply and install

I want to get composite for my alfresco. PleasE share the quote for an area of 4.1m*5.2m which is approximately 22 sqm. I'm looking for labour only, I'lI will get the required material. Thanks!

I had some composite decking done a few years back and this gap wasn’t filled. I need someone to fill it - I have the spare decking pieces.

Looking for an experienced handyman or carpenter to demolish an existing small timber landing and staircase and build a new composite deck in my backyard. : Deck size: approx 10.5m × 2.7m Deck height: approx 300mm from ground : I will supply the composite decking boards and clips. Installer to supply treated pine framing materials, tools, and labour. : 💡💡Scope of work : 📍Demolition & Preparation - Remove existing timber landing and staircase - Remove small trees/obstructions in work area - Dispose of demolition materials and waste (including tip fees) - Prepare ground for deck construction : 📍Deck Construction - Install deck supports (posts or pavers depending on method) - Build treated pine subframe suitable for composite decking - Install composite decking boards (supplied) - Ensure deck is straight, level and structurally sound : 📍Steps - Build steps from kitchen sliding door down to deck - Build one long step along deck edge leading to garden : 📍Clean up - Remove all construction waste and leave site tidy. : 📝Notes - Composite decking materials supplied by owner - Installer to provide framing materials and tools : 🌆Please include in your offer: - Brief description of your decking experience - Estimated time to complete the job - Photos of similar work if available

Experienced Carpenter Needed to Assist with Composite Deck Installation Looking for an experienced carpenter or decking installer to help build a composite deck at a residential property in Oakleigh East VIC. I will assist with labour but need someone experienced to guide the installation, bring tools and handle most heavy lifting. PROJECT Rear deck approx 37 m² Front deck approx 7.5 m² Total approx 44–45 m² Raised platform about 300 mm high with one step down. Composite decking boards with straight runs (no picture frame border). Likely freestanding frame over existing hard / soft surface. SCOPE • Build and set out timber subframe • Ensure frame is square and level • Install composite decking boards with clip system • Assist with step framing and finishing TOOLS Please bring standard carpentry tools (drop saw, circular saw, drill/impact driver, level/laser). MATERIALS I am sourcing boards but happy to purchase through you if you can get better trade pricing. TIMING Approx 2–3 days work. Please respond only if you have installed several composite decks before. Include experience, photos of previous decks and your day rate.

I would like to get the alfresco area done . Would like to get a quote for tiling and composite decking . Not decided which one to go for yet . It’s a concreted area /exposed aggregate. Measurements- 6.660 meter length and 3.760 meters wide

I need an experienced handyman/carpenter to install curved aluminium stair nosing on my outdoor composite decking steps. There are 3 semi-circular/curved steps leading up to a deck. The decking is composite. The structure is fine, but the front edges and joins look untidy, so I want aluminium stair nosing installed along the curved front edge of each step to create a clean, modern finish and improve safety. I am happy to consider other options if you think would be appropriate Looking for: • dark powder-coated aluminium • Anti-slip profile • Neat, precise finish • Weather-resistant outdoor installation Experience with curved applications is important. Please only respond if you have installed stair nosing or worked with curved decking before.

I want to get composite decking at the front including steps and backyard surrounding Alfresco . I am looking for a labour with tools. I will order the required products.

Hi my composite deck has come off loose in couple of areas, so they need fixing. See the images.

Alfresco and front porch composite decking. Please provide a quote with and without materials

Need old decking removed New composite decking installed approx 5.7 m x 5 m Need weed mat and crushed rock on the bottom to prevent weeds Need the decking to be level with the back door Looking for a quote

Task Description: I need two damaged composite decking boards replaced on my outdoor deck. The job includes supply and installation of matching composite boards in monument colour. Details: • Quantity: 2 boards • Material: Composite decking • Colour: Monument • Length: approx. 2.1m (2100mm) • Width: approx. 140mm Scope of Work: • Remove damaged boards • Supply matching monument-colour composite boards • Cut to size and install • Secure and level the boards • Remove and dispose of old boards Budget: $350 total (includes supply and installation) Note: Please only make an offer if you can supply the matching composite decking boards.

Please quote 5.5x3 mt composite decking 30cm above ground. Currently brick paving on soil St kilda east Please quote

I would like composite decking installed in my alfresco area. The approximate size is 4.38 m × 3.85 m. The property is located in Werribee. Supply and installation required

I need to get a composite decking done for an outdoor area around 9*4 m

Build a new deck made of composite material. Size is 3x2m (existing deck in image has been dismantled). Must be licensed and will require a tax invoice. Must be available to complete prior to end of 2025. Budget of $1000.

I need to build composite decking over concrete area in my backyard. Also cover the stairs in the picture with the same composite decking material. Also need to build two benches over the black mulch area in the picture. If possible , buy and put some pebbles amd some paver tiles as well in the garden if possible. Decking area is around 3.2m *2.7m. Area to deck and build 2 benches are provided in the image. Benches can be made of wood. Please reach out for more details.

24foot by 8foot long by 1.32m need the composite decking layed as im setting up my above ground pool but want it all done right

We have existing modwood path that we want to extend all around pool including replacing the current pool coping with a modwood frame

Chainsaw a pile of old timber deck into pieces to fit into fireplace. And then stack the wood.

6 metres by 1200 treated pine deck to go in front of a caravan and a annex only coming up about 300 mil off the ground

A 4mx4m timber deck on/over a 2mx2m concrete water tank using 150x30mm Merbau planks fixed with SS decking screws on Cyprus or concrete stumps, treated pine bearers & Joists. I’m happy to contribute my labour to digging stump holes, laying decking etc

Looking for someone to build a simple, low-profile timber deck along the left side fence of a paved courtyard (see photo). Scope of works: - Build a straight timber deck approx. 800mm wide - Length approx. 3m (along existing garden bed) - Deck to be built over current soil/garden strip - Low height - ideally flush or slightly above existing pavers - Clean, simple finish Construction: - Timber frame with decking boards on top - Deck should be supported independently (e.g. small pads/feet), not relying on existing pavers Site conditions: - Existing area is a narrow garden bed next to pavers - Soil base (will need minor prep/levelling) - Easy access via side path - Timber fence alongside Materials: - Please include materials (treated pine or similar suitable for outdoor use) - Open to hardwood upgrade options depending on cost - Basic ground prep (weed mat / crushed rock) Interested also build bench seat. Please include: - Your proposed approach - Whether materials are included - Any similar work/photos if available Photo attached for reference.

Clean wooden deck approx 30m2. Will require a pressure cleaner.

Looking for timber restoration for the front entry area including the timber steps, planter boxes and the front door. The timber has faded and become patchy due to weather exposure. The job would involve pressure cleaning, light sanding and re-staining or oiling to restore the timber to a rich merbau colour and make it look new again.

Timber decking requiring surface preparation and staining or oiling. Approximately 32 m².

Replacing the 4 deck , as it is burned down

If it’s easier you can offer to come and provide a quote but give me a ballpark of the cost in your offer. Hi, I’m looking for an experienced decking contractor to supply and install a Spotted Gum timber deck in my backyard. Details • Location: Oakleigh South, VIC • Size: ~28² • Finish: Picture-frame border Finish: Sand + apply UV-protective penetrating decking oil (tinted to match the attached brown colour reference). No film/varnish coatings. • Area: Existing patio area, decking to be extended up to the shed • Steps: Will need some steps included Photos attached • Colour sample/reference photos (brown tone I want) • Photos of the patio area and where the deck will go Task includes • Measure up and confirm final size/levels • Supply all materials (boards, subframe, fixings, etc.) • Build/install subframe + decking • Install steps as required • Sand and oil to match the colour reference • Remove all waste/clean up Please comment with: • Your quote (materials + labour) • Estimated start/finish timeframe • Photos of similar decking jobs you’ve done

Deck needs to be oiled, about 15sqm in total, not a large area.

I have one ripped Merbau decking board that has lifted. Need a handyman to re-secure the board flush with the deck. Please bring a drill, bits, and appropriate decking screws. May need to pre-drill and countersink to prevent splitting the thin board

5m x 1.4m timber decking at front of house needs to be sanded back before I have it painted. You must have experience and have the sanding equipment. Flexible with timing.

Deck is due for another coat. Its approximately 10x1.5-3.5m. Ive set the advertised price lower so I get quoted your actual prices rather than just matching the advertisement

I will build a drainage under the decking, so need a carpenter who can do work to remove and reinstall back timber decking (using the same materials). Decking size approx 5m x 4m after the basketball hoop and 5mx1m before the basketball hoop. It required 2 different days, because needs my plumber to finish the work before can reinstall.

Looking at getting a timber deck installed at the back of a town house - Roughly 5m x 3.5m in size or 17 sqm - Picture frame edge and mitred - similar to one in picture

Sand, clean and recoat back yard timber deck using specific products (ie approved deck cleaner, feast Watson stain etc). Minimum 2 x coats of feast Watson stain required. Top section of Deck is prob 10m2 approx. Would also need the deck upstands (low height walls) and the deck steps done.

Clean and repaint timber deck 3x5m

Details: Deck Size: 6.5m x 4.5m Condition: Mostly in good shape, just needs a fresh coat to restore colour and protect the wood

Timber decked entry walkway needs staining and sprucing up and retaining walls need painting

Looking for someone with experience and expertise in staining timber and painting to: 1. Stain a new 6m X 4m timber deck in our backyard made of treated pine (refer to image) to preserve the timber and keep it looking fresh, including supplying the stain (I'll pick something from Bunnings), prepare the surface and stain the timber with a brush and applicator. 2. Paint the white timber post and small section of the roof circled in red in the photo, including supply the paint (I'll choose something from Bunnings), sanding down the timber and 2x coats of paint.

Circa 30m2 decking required, budget options would be preferred but discussed. Concrete will be removed

- stain 4m x 3m garden decking (blackbutt decking) including a sealer plus an additional 3 coats - stain the eaves and timber front door standard size (hardwood - Vic Ash) - stain timber on back door (standard size). See photos for all. Please include all materials. Timber stain to use is Intergrain UltraDeck Timber Oil.

Small garden deck extension.

I’m looking for an experienced carpenter to build a low rise garden deck off an existing hardstand, with a small extension into the grass area. 📐 Size: approx. 4m x 7.5m 📏 Height: only ~300mm above current hardstand level I’m open to using composite decking materials (such as Woodevo) or a hardwood timber like spotted gum that will naturally grey and remain low maintenance over time. 🔨 What I’m looking for: • Proven experience building similar low-rise decks • Knowledge of both timber and composite decking materials • Quality workmanship and attention to detail 💬 Note: No pricing required at this stage — you’re welcome to visit my home before confirming a price. If you’ve completed similar projects, please share photos and references in your response.

Need a carpenter to restore garden decking - garden seat with planter box - uneven garden deck Happy to discuss further on the job and scope to refine the quotation Due date: Needs to be done by late June