Find experienced local carpenters in Mornington Peninsula

Set of 4 Corinthian timber bifold doors that are scraping the floor. The track and door hinges were replaced early in 2026 and the track slider/connector to the top of the door is very temperamental. Only experienced tradie with previous experience of fixing these types of doors wanted. Paid an arm & leg for the earlier repair work and its only lasted 5 months:) 4 doors have opaque glass in top half. Stained timber.

Hi there *PLEASE OFFER YOUR QUOTE* I have a food caravan that has some timer windows on it. I’m needing them sanded, and stained. Someone with experience in this only. I can provide the stain. Must be completed by a Thursday as I use it Friday and weekends for work. I do have three vans if you wanted more work, this is just for one we can quote. In Rye The window you see in the picture, the back and front are smaller windows. Can be 2 vans if wanted

A cabinet for A bar and pantry Similar to photo without the sink. Height 950mm, Deep 700mm, Wide 1200mm, same look. Pantry two door overhead to ceiling above washing machine.

Wash mossy area of saunas and re-stain external. Give internal a clean

Calling all carpenters / handypersons, to create a new attic hatch/door into attic area. Current door is impossible to access safely. Hope to have one created into wall next to family room. Photos show existing door, plus blank wall where new proposed door will go.

2 door overhead cupboard for laundry and 2 door bar cabinet with marble top

Rotten windowsill, there’s a window on a 45 degree angle that also needs repair

Cabinet maker to make draws

Looking for someone with cabinet making experience to build draws into existing cabinetry

We require a carpenter to install skirting boards & architraves 2 bedrooms & hallway - Material provided

Need someone to sand back small section of damaged board outside. Refill and then add coating.

Hi, we need to fix a few things and will need someone to purchase some of the materials (will be paid for separately) depending on what your recommendation is. 1. Raising top of shelf so our washing machine can fit under it (see photos) 2. Mounting 65 inch tv on wall. 3. Patching cat run wire with whatever safe material you recommend. (See photos) Please reach out with any questions you may have.

Looking for someone experienced with cabinet hinges to fix a kitchen corner cupboard door. • Bifold cupboard door (2 panels) • One hinge/bracket is broken and needs repair or replacement • Door is slightly misaligned and needs adjusting so it closes properly • Photos attached Prefer someone who has done kitchen cabinetry repairs before. Flexible with timing but sooner is better. Located in Rye.

I need this gap covered under my oven with still a little bit of gap left for air flow. My kitten tried to climb in the gap the other day and nearly got stuck. Need it covered asap!

On our bathroom quartz engineered stone bench top it appears the surface has approx 6 small round white bleach stains. We would like these repaired professionally so that they are not visible.

We need a painter to stain our new very large front door, 2 sliding glass doors, and one large window. Inside and outside. All Tasmanian oak. I have the stain and the brushes already.

We have a piece of Tasmanian Oak from Bunnings - needs to be cut to length, including angle tips, and fixed between wall and door. https://www.bunnings.com.au/porta-22-4x22-4mm-2-4m-quad-tasmanian-oak_p0080711

We have some new soft close hinges to go on 9 refreshed cabinet doors. Would like them to line up etc. Have hinges and tools. Just need someone who may have done this before. Is good at measuring accurately and drilling. Photo of old hinge, then of new hinge.

After custom cabinetry, similar to photo below with these dimensions built and delivered to Frankston South needs to be a freestanding piece that can be bolted into a wall 2000H x 1800W stained timber If happy to deliver to Mount Buller extra money paid.

Need two support braces attached to upright posts attached back towards the house for a shade sail. Need two 3m treated pine lengths 90 x 35/45 (please supply) and a nail gun preferably.