Find experienced local carpenters in Belmont

Repair and paint outdoor timber chair and attached arbour

Looking for cabinet maker to cut/build two shelves by attached size. Material - black Melamine Thanks

I would like this shed put together and bolted on to my concrete slab with the kit fittings provided. Link to the shed is below. https://www.easyshed.com.au/tall-gable-roof-garden-shed-3-00m-w-x-2-25m-d-x-2-35m-h-in-colour

Install overhead cupboards and hanging rail, and install a bench top in a small laundry.

Hey there, my name is Luke. I need to hire a handyperson to help me in Belmont QLD 4153, Australia. What do you need done? Carpentry What is the type of property? House Which areas of the property need work? Pool area What would you like the handyperson to work on? Design build and install a timber above ground spa surround, complete with two steps into spa, six inch shelf on two sides. Stain timber to same colour as other furniture. Timber to include floorboards currently on site. Framing timber to be purchased by us as directed by airtasker.

Squee set plaster in new house construction in Belmont Qld

2.4sqm Stratco shed installed. Already have slab. Parts on site.

Hi there. Looking for someone to cut my new pool cover to size plus attach the straps to the reel.

Hi, we are wanting to remove these small rocks and replace with a floating deck Approx measurements 5x3 Thanks so much

Low timber wall required to cover end of slab. Existing dropped. Approx 4330 length x 200-250 high. Need to replace three small posts, four sleepers and one end trim piece. Open to alternative suggestions. Site shown in photos. Cement required to fill any gap between back of new work and existing slab/tiles.

I need someone can install a panel garage door. I have the complete pieces rails panels etc. Please see the attached photos the sizes. Car port clearance: Ceiling: 2400 Front Height :2300 Width post to post :2950 Panels: Height 2200 Width 4890 ( requires cutting on one side to 2950 ) Location: Belmont ... Near Carindale Shopping centre

2 set of kitchen joinery with stone bench top few toilets cabinet stone top wine bar, robe, store cabinet removal picture will provided after you request.

Stratco galvanized shed. 1860 X 825. To be assembled and fixed onto concrete pad. Pad is poured and location of shed will be marked out. All fittings and fixings are onsite.

We need a drafts person to create a plan for a building certifier for a deck extension off the front of granny flat. Approximately 2x 8m.

Brand new shed installation, 3m×3m×2.4m gable roof shed. On concrete slab. Competition date might be changed based on Shed shipment date.

Need someone to cut a piece of acacia teak timber

Our existing shelves in our pantry are not of suitable spacing so we want get them redone.

New Absco 1.5m x 1.5m x 2m (LxBxH) garden shed needs setting up. Already assembled most of the parts. Needs help to install and fasten to ground. Need power drill and masonry drill bits and other tools.

Hi, looking for an airtasker to supply materials and build a shed - size to be about 1800mm wide by about 3-4 mtrs long