Find a local Tasker to inspect your Mazda near you

require replacement of starter motor of mazda cx7. Labor only required. have car in powered garage.

Install DDPAI Z60 Pro front and rear cameras. • Preferred power: DDPAI Type-C intelligent hardwire kit (enable 24-hour parking mode with battery protection). • Power source: Fuse-tap to ACC and BATT (installer to verify with multimeter). • Typical CX-8 map: ACC via F.OUTLET in cabin; BATT via ROOM in engine bay — confirm on-site. • Neat, hidden cable routing: A-pillar (airbag-safe), headliner, through tailgate grommet to rear glass. • Clean mounting of both cameras, set correct lens angles, tidy excess loom. • Ground to suitable chassis point. • Configure app, verify live view, loop recording, parking mode and low-voltage cutoff. • Demonstrate event clip save and time/date sync. Deliverables (acceptance criteria) • Front and rear cams firmly mounted; trim refitted without rattles. • No airbag/SRS interference; no warning lights. • Hardwire works: camera switches between drive and parking correctly; no accessory-port obstruction. • Fuse taps labelled; wiring secured with fabric tape or loom (no buzz/rub). • Brief handover: which fuses used, cutoff voltage set, and basic troubleshooting. What I’ll provide • DDPAI Z60 Pro dual dash cam. • DDPAI Type-C hardwire kit (or OBD kit as fallback if you advise). • MicroSD card (high-endurance 256–512 GB) — or purchase from you at cost if preferred. What you provide • Professional installation and tools (trim tools, test light/multimeter). • Add-a-fuse taps and spare fuses — likely low-profile mini (ATM-LP) for cabin and mini for engine bay, but please bring an assortment and verify profile. • Cable sleeves, fabric tape, zip ties, alcohol wipes for glass prep. Please share experience and any photos of previous installs.

Oil and engine lights are showing. Car went into limp mode so I don't know if it's possible to save the car.

Replace old motor assembly of left front window with 2nd hand parts which I will pick up today.

Have 6x8 component speakers to be installed in Mazda 3 2009 in front & possibly re-wire & check that rear speakers are installed correctly as I think they may not be working to their capacity. The Alpine are rear & the Kicker are the ones for front.

2011 Mazda BT 50 engine needs to be removed from vehicle, ancillaries removed ready for reconditioning. Then return, refit ancillaries and reinstall engine. Qualified or someone capable and experienced please This is for my sons first car and hes paying so cant afford huge amounts but just need fair

I would like some helps from experienced professional to install the DashCam neatly and safe. Thanks

I have a canopy to be wired to a Mazda bt50 2025 model

Hello, I’m looking for someone reliable and knowledgeable to carry out a pre-purchase inspection on a used 2016 Mazda CX-5 before we decide to buy it. What I need checked: General mechanical condition (engine, suspension, brakes, steering, transmission) Body condition (accident damage, rust, leaks, etc.) Interior features and electronics Tyres, lights, safety features Quick road test Summary report (can be a few photos and short written notes) Preferred timing: Friday or sometime on the weekend. Can organise with the seller. The seller is aware an inspection will take place. Thank you.

I’m interested in buying a secondhand 2016 Mazda CX3 located in Double Bay, NSW and would like to arrange a pre-purchase inspection by a qualified mechanic. Inspection would be this evening around 6.15pm.

I need a prepurchase inspection for a 2017 Mazda CX5 done today

Need a service for car. Preferably done today.

I have an Alpine stereo system in my Mazda 2, 2008 hatch. Just bought a Golf GTI 2010 hatch. I'd like the stereo system taken out of the Mazda and installed into the Golf. And the old Mazda head unit installed back into the Mazda to sell the car. Photos show head unit and all parts purchased from Autobarn as advised by install guy.

I have a dent in the rear bumper on my 2012 mazda 6 sedan. I'm in pooraka is this something you can remove?

Installation a amp and slimline subwoofer in my 2018 Mazda BT 50 extra cab Ute Only cables included is power. Happy to pay for cables needed.

Pink slip required for Mazda 626 asap

Im buying a VIOFO A229 Plus 3CH 2K+2K+1080P and would like a price for installation with hidden wires

Replace lower harm on2014 Mazda CX-5 . I have the parts ready

Mazda3 Maxx sport bk 2009 apparently the bottom engine mount is broken and I need it replaced. I'm after quotes please

Fit CV JOINT to Mazda 6 2005 Right hand side! (Sorry my task disappeared prior to reposting now)