Find skilled builders in WA

Build decking 5m x 4m and timber frame for deck, with roof using color bond sheet (woodland Grey or Monument) roof sloped 2500mm high, to 2400mm high on back side. 2400 side to be sheeted with same color bond panel. This is built for an outdoor Sauna we have bought. I’d also like to get shower and LED lighting, similar to the picture attached. It doesn’t have to look exactly as per design but similar with matching design intent. Decking to be in wood/plastic composite Dark colour.

Assembly easy shed 1.5*3 meter gatden shed

Re-attach pergola ceiling panels that have fallen off/come unglued. There are 2 that have come off completely that need reattaching and a few more that are hanging on and will need looking at.

Adjusting pergola size and moving footing

3.75m x 1.9m shed assembly on a concrete slab. Shed has been delivered. I have included a photo of location.

Looking for someone to supply and install flashing on my shed. The connection between the carport/shed needs to be fixed so water doesn’t get through. Roughly 8-9m long.

Installation of insulated roof panels X6

Move outside aircon unit 2.5 meters out of new pergola area.

Need the shed frame pulled apart and emptied to skip bin. Frame is steel to be cut to the ground. Will need tools to cut it up to size to be stacked or placed in a skip/back of ute. Plus tear down a wooden pergola attached to the side of the house. This requires a team of 2. Should not be more than 3-4 hours for an experienced team.

I have purchased a garden shed 3m x 1.5m Gable Roof form easy shed and require is to be installed out the back on pavers and anchored down with the bolts provided

I require someone to remove all cupboards and remove the floor and wall tiling. Floor is approx 13sqmt, wall tiles is approx 8sqmt. Thisis an apartment on the first floor, there is a stair case next to the door and a walkway to the driveway. You remove all rubbish. I will be onsite to assist with the job as a labourer. No plumbing or electrical work is required. I have reposted the job as I left out it was on the first floor with stairs.

I need a trailer load of brick that has already been demo’d taken offsite. Little bit of sand as well. Must be done tomorrow, Wednesday, around lunch time.

Help to Dissemble a 3×3m - mimosa louvred pergola. I bought online, mert at sellers house in Nollarama today. Please bring: Drill, ratchet set, Hand tools, Ladder, I dont know if bolts in concrete need sawn off, if you have grinder also would be useful. Work involves, undoing lots of Nuts/bolts each louvre, screws/Allen keys to undo fram connections. Its Aluminum frame, so careful not to thread. (Its happened before ). I can assist with my tools also and have a 1 x collapsable platform ladder. I would like your help to load into/onto my Van roof racks also. I'm 1 hr drive from location. So rbc a time with yourself and the place picking up from. Need completed Today. Thanks you

There is a bunch of rubble, gyprock, old wardrobe panels and general demolition waste that needs to be gathered up and placed in the skip bin on site. I estimate about two hours work for one person. There is a wheelbarrow on site to make this easier.

Need yellow sand delivered and fill in excavate section's either side of driveway and crossover to make level ready for paving to be done and dirt pile currently on driveway removed and disposed of Measurements are in hand drawn picture

Assembly of shed, following instructions from supplier. Absco shed ordered through Bunnings. Floor platform will be built beforehand. Need to be assembled against wall.

Need a shed assembled on a concrete slab. Shed is : 3.75m x 0.78m Narrow Slider Shed Arriving 6th Jan. So need assembly after that.

Looking for a skilled handyman or roofer to repair or replace a damaged transparent roof panel in my outdoor pergola/patio area. One clear corrugated panel is cracked/aging and needs to be securely fixed or replaced to prevent leaks and improve weather protection. Timber beams are already in place. Task includes: • Inspecting the existing transparent panel • Supplying and installing a replacement clear panel (polycarbonate or similar) or re-fixing if reusable • Ensuring it’s watertight and safely secured • Cleaning up after the job Details: • Access is straightforward • Prefer someone with experience in pergola/patio roofing • Please bring your own tools • Tasker will purchase panel on our behalf When: Flexible – ideally within the next 1–2 weeks Budget: Open to reasonable offers (please quote) Notes: Happy to share photos (see attached) and answer any questions before accepting the task.

Assemble a 2.25m x 0.78m Narrow Slider Shed on pavers and anchored to the wall and floor - it’s a flat pack - https://easyshed.com.au/products/narrow-slider-garden-shed-2-25m-w-x-0-78m-d-classic?_pos=1&_fid=1b0c3accf&_ss=c

Bought an 3mx3m EasyShed and need someone to put it together https://easyshed.com.au/products/gable-roof-garden-shed-3m-w-x-3m-d-classic