Find skilled builders in VIC

Pergola with slope to gutter and side fence screening

We want to move and replace the side gate and fence with something like a rapid fence 1130 x 1800 classic white PVC gate and side panel available at Bunnings. Replace a section of the retaining wall in a couple of sections. Section 1 would be in a bin enclosure space, being 800mm deep on either side and 1900mm wide at the back and 600mm high. Section 2 is a retaining wall off the bin enclosure space approximately 5000m long and 400mm high. Section 3 is at the edge of the alfresco that would have steps on one side approximately 1200mm wide and 3-4 steps, and then a floating bench seat with a planter box on either side. We would like remove a small section of the pergola roof to straighten the alfresco roof line up and then over section 2 of the retaining wall add an open roof pergola from the fence or retaining back to the house - refer to pictures with the white open roof pergola as an AI generated image as an example. All rubbish removed from site after completion

Hey there, I need to get my shed installed in my backyard please on concrete floor. The shed is 3m x 2.25m Gable Roof Shed (high roof) SKU: EG-D3023-ZA Please let me know if u need any other details thankyou

Paint the timber beams under our pergola. Paint supplied. You would need to prep the area also.

Need someone to put together a flat pack garden shed. L-3m w-2.5m H-2.1m

I need an experienced tradesperson to correctly prepare existing electrical conduits that currently sit on top of the crushed rock base, so the area is ready for concrete pouring. Works required: • Carefully lift and lower existing PVC electrical conduits so they sit below the finished concrete slab level • Provide proper sand or fine crusher dust bedding under the conduits (no sharp aggregate) • Ensure minimum 50–75mm clearance below the concrete slab • Cover conduits with sand (minimum 50mm) before re-instating crushed rock • Re-level and compact the crushed rock base to a clean, even finish suitable for concreting • Ensure conduits are protected from crushing and movement (sleeving if required) Important notes: • This is a driveway slab area and will carry vehicle loads • Conduits must not be visible at finished base level • Work must comply with standard pre-concrete construction practice • Area must be ready for immediate concrete pour once complete

I am looking Fwd to build 2 merbau deck 1. 6M X 3.8M 2. 2.8M X 2.8 M

Garden vine needs removing from top of pergola. Has been cut at the base. So it has now died.

We have an eazyshed flatpack delivered and we need your help to install it on concrete. Its dimensions is 3mx3m.

Assemble and place 2.08m x 0.97m Wheelie Bin EasyShed

Hi there, I need to get a redundant piece of concrete driveway removed from my backyard ideally this week. Please include to cut, remove and dispose of the concrete including cutting and removing the small corner near the entrance to the garage. Sizes are on the photos and it is the red hatched area that needs cutting and removing I need to get this work completed this week, please only price If you can complete this week by Sunday Easy access to rear gate to almost drive up to Thanks

I have a ceiling in my new pergola all prepped, just need a hand painting the ceiling. I have the paint and rollers. It is all masked up ready to go Pergola is 7x7 metres Scissor lift is onsite

I have a faulty motorised gate to the driveway that needs to be replaced. The doors are misaligned and we want to change it to a sliding gate door and make the gate opening wider. And also we have a garage roller door that doesn’t open properly this needs fixing. Quote please.

Pergola installation Aluminium kit. With 4 zip blinds.. 5m X 3.8m In a pool area. All parts are adjacent to the installation area. But need to be brought into the pool fenced area. Might required the porcelain pavers to be cut out at the feet of the pergola, or bolted through the porcelain with appropriate drill/core drill. Gm-outdoor dot com will show you the product. It's a gumei 220 series.

We have an outdoor shed (metal sheeting) measuring 3m wide x 0.78m x 1.7m high (brand Easyshed). It has been assembled, but the walls need to be erected. This is likely a two person job or else 1 person who is skilled at holding the walls to drill them together with nails. It should be a straightforward job IF you have experience at assembly or are a skilled tradesperson. Please don’t apply if you don’t have this direct experience - we have been stuffed around before on this task and just need to get the job done. Thank you.

Need shade cloth and tarp (already purchased) installed to already built pergola.

Need to move 6 cubic metres of soft fall/play bark from driveway into the backyard and spread around Type of gardening: Other Size of garden: 50m²-150m² Has green waste bin: Yes

Looking for good Demolition labourer . Removing tiles .

Need to install garden shed there wont be any help

I would like to help you again - View all the details of this offer: https://www.airtasker.com/offers/01KCJNJ7FWMANW7H35HX4HQKQM