Find experienced auto electricians in North East Melbourne

Alphine halo 11 head unit read adjustment and handbrake connection to stereo deleted

Install of XRS370 4wd pack. Head unit to be installed behind console or glovebox. Antenna mounted to bonnet or mirror. Neat and clean install needed by experience people only. Vehicle - Nissan Patrol Y62 2024

Looking to wire and Orginal classic car radio and taco into car All wiring loom is there as it was swapped out of another car I own Both radios were working just need it reconnected with existing wiring

Attached OBD2 output shows all codes

Need a RH side mirror and LH front headlamp assembly installed on a Mazda 3 2014 model. The front bumper assembly is damaged and might need minor adjustment post replacement of the headlamp Replacement parts are available.Happy to lend a hand.

Hi, I’m looking for someone experienced with motorcycle accessories/installations to fit a windscreen/windshield onto my Yamaha R3. I already have: • The new windscreen • The bike is in my garage with clear access Job involves: • Removing the existing screen • Correctly aligning and fitting the new windscreen • Ensuring all bolts/clips are secure and tightened properly • No rattles, no scratches Tools not provided, please bring your own basic tools. Thank you

I have a Stedi STEDI ST3303 Pro that needs to be installed on the front bar of my Jeep Grand Cherokee. Comes with wiring loom and instructions.

I'm after a redarc tow pro elite v3 installed on A Toyota Hilux 2019

Needing parking sensors and to replace the reverse camera I have already installed. Vehicle is a 2009 Nissan xtrail t31 I have the sensors and camera already.

To install my dash cam hard wired

Hi, I’m helping a friend with a 1994 Toyota Corolla AE92 automatic and I’m hoping to get some experienced auto-electrical advice or if needed assistance to make sure we’re approaching the repair the right way.Budget is for diagnosis and advice only. Happy to increase for the right expertise The car has wiring damage from an earlier cigarette lighter circuit repair that overheated and burned back into the loom. That work wasn’t done by the owner. While driving, smoke came from the dash, the car lost power, and it now won’t crank. There’s visible heat damage to several ground (earth) wires and nearby wiring behind the dash. The cigarette lighter itself doesn’t need to be reinstalled. I’m doing the hands-on work and I’m purchasing a complete compatible donor wiring section/loom now (from Pick-A-Part or similar). Before installing it, I’d really like to sanity-check the approach with someone who knows these older Toyotas well. I’m hoping someone can assist in some practical guidance or if needed possible work. This could be reviewing photos, confirming likely causes of the no-crank, and advising whether full replacement versus targeted repair makes the most sense and if so possible assistance to help Happy to pay for phone advice, photo review, or general diagnostic guidance. Photos are available and I’m easy to work with. Thanks in advance, and please get in touch if you have solid experience with older Toyota electrical systems. Location is 19-33 Murray Rd, Preston VIC 3072

Require professional to replace starter motor on GQ patrol. Already have the part Car won’t start so will need to to be done in driveway at home

Needing led lights put in car

I’m looking for an experienced auto electrician or car audio installer to install a Kenwood head unit into my 2015 Toyota Axio Hybrid. Scope of work: • Install Kenwood head unit (proper fit & wiring) • Install and wire a reverse camera • Ensure steering wheel controls (if applicable) work correctly • Clean, professional installation (no loose wiring) Requirements: • Proven experience with car audio installations • Must be able to show photos or proof of previous work • Familiar with Toyota hybrid vehicles preferred • Bring your own tools Please include: • Your experience • Photos or examples of similar installs • Estimated time to complete the job Location: [Reservoir] Looking for a reliable and professional installer. Thanks!

I need to install reverse camera in my Mazda 2 2008 model. We can do any day after 5pm or Tuesday 20th January. Let me know if you can do the job. Thanks

car trailer connection not fully working. some lights do but brake light isnt from connector

2005 Ford Transit restoration. I've completed about 90% of the wiring loom rewrap. At 64yo I'm having problems getting under the dash and into the engine bay. The Dash and instrument cluster have been removed to gain access to the loom at the back and under the dash. I need someone who can help finish the rewrap in electrical tape. ie. stronger back than mine. Will require getting under the van for things like horn, loom connectors etc. I estimate about 3hrs to complete. But willing to pay as required. Note: Anyone who is car minded and good with electrical tape should also apply.

Nitro Vrx river Hobby N2 remote control car won't start. Anyone with knowledge I would like to pay for your time to bot only get the car going but learn( 1 hour of your time) being that the car is brand new it won't need parts just smarts

I will provide starter motor just need someone to fit it . only a thirty minute to sixty minute job .

Would like to get a quote from you for the hardwired dashcam (VIOFO A229) installation to my 2023 Mitsubishi Outlander.