Find experienced auto electricians in North East Melbourne

Audi Q7 not starting as it shows put gear in P or N to start. We have replaced the Automatic Transmission Neutral Safety Switch but error still coming. Also shows a coil error display in screen and shows a message that Start / Stop feature not available.

Audi Q7 has starting problem, it shows put the dear in P or N to start. We have replaced the Neutral Switch but the error still comes up. Also, shows aa coil error in display screen, and shows Start / Stop function failure.

Hi there, I’m looking for an experienced auto locksmith or mechanic to help with an ignition issue on my car. Vehicle: Honda Jazz 2005 Issue: I recently had a new key cut, and since then I’ve been having problems with the ignition. The key does not turn smoothly, and sometimes the car won’t start at all. I had RACV attend using the original key, and they advised that the ignition barrel is likely worn down due to the newly cut key. Probably need: Inspection of the ignition barrel Likely replacement of the ignition barrel Ensure the car starts reliably after repair Ideally rekeyed to match existing key (if possible)

https://m.alessntials.com/products/sakerplus-4-channel-fhd-dash-cam

To install my dash cam hard wired

Auto electrician needed to install remote lock, Alarm, Immobiliser, reverse camera and repair faulty horn (Auto horn when steering wheel is not centre) + door speaker not working for 1999 Nissan Skyline R34 GTT auto

My car AC is not cold but its still blowing normal to warmer air. Have asked my mechanic and he said AC compressor faulty and replaced it. It was said the old one seized. After changing the new AC compressor, it still didnt work and he said will need electrician to have a look and there is no power to the AC compressor. Car is 2014 panamera S petrol. Thank you

install and wiring an aluminium canopy on my Mitsubishi Triton 2015

I was installing a sub wire thru firewall and believe I’ve nicked a wire in the wiring harness, car no crank/start, no immobiliser flash, no key light, no interior lighting, obd2 port not working, “serv error” on dash, dash lights up. Holden commodore vt 2000

Ring camera purchased. All parts available. Need drilled into brick to install the camera mount. This is a battery powered camera not wired.

Hardwired dashcam installation

I have a 2007 Kia Rio (JB shape) with minor front-end damage after a low-speed incident. Looking for someone experienced (mechanic / panel beater / handy person) to do a cheap, practical repair — not a full cosmetic job. What needs doing: Replace or repair bonnet (I may supply part OR happy for you to source from wreckers) Re-align front bumper (currently popped/misaligned) Secure/re-seat passenger side headlight (may have broken clips) General tidy-up so everything lines up and is safe Important: This is NOT an insurance job or full respray I’m not looking for perfect — just safe and presentable Car has ~300,000km so keeping costs low is the priority Location:Greensborough Budget:Open to offers – looking for a reasonable cash-style job Extras (optional): If you can source parts (especially bonnet in red), please mention If you have experience with similar repairs, let me know Photos attached Looking for someone who knows what they’re doing and can get it sorted without overcomplicating it.

Description: Looking for someone experienced with 4WD electrical installs (auto electrician or experienced installer preferred) to assist with fitting a KickAss 12V 120Ah Slimline Lithium Premium Dual Battery Kit into my GWM Tank 300. The KickAss kit is designed as a plug-and-play system and comes with everything required, but I’d really value input from someone experienced to ensure the layout, mounting, and overall finish is done properly. I’ve already started planning the layout and identified the best location for the battery in the rear cargo area. I’m after someone who can help refine the setup and carry out a clean, professional install. Scope of work: • Assist with final layout/positioning of battery and components • Securely mount the slimline lithium battery in the cargo area • Drill into the floor and install rivnuts/nutserts for solid mounting points • Modify/reposition the factory subwoofer/amp so it doesn’t foul on the battery • Re-secure sub/amp once repositioned • Assist with cable routing and cable management (safe, neat, and protected) • Ensure safe clearance around battery terminals and cabling • General tidy-up to ensure nothing rubs, vibrates, or creates a hazard What’s included in the kit: • 120Ah Slimline Lithium Battery • 25A DCDC Charger • Wiring kit (incl. cabling, fuses, connectors) • Mounting hardware (from kit) Requirements: • Must have experience with dual battery / 12V setups • Must have own tools, including rivnut/nutsert tool • Experience working on 4WDs or custom installs highly preferred • Ability to deliver a clean, safe, and well-finished install Notes: • Space is tight due to factory bolts underneath, so experience with custom installs is important • After a properly thought-out setup, not just a quick install • Happy to assist on the day if needed Location: Preston VIC Timing: Flexible (sooner preferred)

Installation of: apple car play head unit parking camera Dash camera

Looking for an auto electrician to install a Sony head unit and sub

I need someone to come and just help fit the starter motor I have here and remove the damaged one The reason I need help is I have a bad back my neck in the part so it’s been really difficult and so I left it .. preferably someone who’s done this before but so I’m not teaching them as we go I can assist you and have all the required tools

Need a RH side mirror and LH front headlamp assembly installed on a Mazda 3 2014 model. The front bumper assembly is damaged and might need minor adjustment post replacement of the headlamp Replacement parts are available.Happy to lend a hand.

Require professional to replace starter motor on GQ patrol. Already have the part Car won’t start so will need to to be done in driveway at home

I’m looking for an experienced auto electrician or car audio installer to install a Kenwood head unit into my 2015 Toyota Axio Hybrid. Scope of work: • Install Kenwood head unit (proper fit & wiring) • Install and wire a reverse camera • Ensure steering wheel controls (if applicable) work correctly • Clean, professional installation (no loose wiring) Requirements: • Proven experience with car audio installations • Must be able to show photos or proof of previous work • Familiar with Toyota hybrid vehicles preferred • Bring your own tools Please include: • Your experience • Photos or examples of similar installs • Estimated time to complete the job Location: [Reservoir] Looking for a reliable and professional installer. Thanks!

2005 Ford Transit restoration. I've completed about 90% of the wiring loom rewrap. At 64yo I'm having problems getting under the dash and into the engine bay. The Dash and instrument cluster have been removed to gain access to the loom at the back and under the dash. I need someone who can help finish the rewrap in electrical tape. ie. stronger back than mine. Will require getting under the van for things like horn, loom connectors etc. I estimate about 3hrs to complete. But willing to pay as required. Note: Anyone who is car minded and good with electrical tape should also apply.