Find a shower installation professional in NSW

There is a Leaking shower head in the ensuite bathroom The shower tap handles are tight it may need a reseal or need a new shower head and handles need someone for next Friday 13th June

I need help getting the old shower head off the wall. There is a glass corner shelf in the way, which is adhered to the glass wall.

Fix shower head x 2 -low water pressure Fix water leaking from bidet head

Need hot and cold washers/o rings replaced and also needs to be reseated. Plus install new shower head (supplied by me)

I need a dual showerhead installed to replace an existing single showerhead. It will require drilling into tile. Bathroom images and schematic supplied.

Got a shower head hand held with the hose need installed also the old is Leaking probably need a washer couldn’t be bothered doing it my self looking to pay $100 Campbelltown area

Install a new shower head

Shower head broken Water leaking continuously

Removal of old and install of new tapwear

I’ve got a new all directional shower head and need the old one replaced.

Plumber to Install mini laundry tub- and remove and replace shower head, laundry taps, laundry spout and mixer in bathroom

Just need a new shower head connected up in bathroom

Leaking shower head, keeps dripping when tap is turned off

Install a new shower head

Bought 2 new shower heads from Bunnings and need installation. Flexispray WELS 3 Star 9L/min Chrome Havana Short Twin System. I/N: 0307305

Shower head is leaking.

I’ve been gifted a shiny new filtered shower head (the Afina Filtered Shower Head, for reference — I’ve included a photo). Very excited to use it… except my current setup is an ancient brass shower system, and sadly, the new head won’t fit. So here’s what I’m looking for: Someone who can replace my entire current shower system with something that will allow me to use this new head. I don’t know anything about plumbing, fittings, or what’s involved (humble non-plumber here), so I’m hoping for guidance on the simplest, most cost-effective way to make this work. We plan to fully renovate in a few years — so I’m not after high-end finishes or a luxury install. Just functional, tidy, and good enough to get me through until the reno. I’ve attached: Photos of the current system. A screenshot of the new shower head. The shower head is also listed on Amazon as “Afina Filtered Shower Head” if you want to check specs. Timing: Flexible on when this gets done, but sooner is better (especially as I have small children who make life noisy and chaotic). I’ll make sure you have a clear run at the job without tiny humans underfoot — I want this to be easy for you! If this sounds like your kind of gig, I’d love to hear from you with a quote. Thanks in advance for helping me live my filtered water dreams!

Have purchased a new shower head and need it installed asap

Cut out the current gyprock/plasterboard around the shower head approx 40 cm2, check there is no leak in the water lines that feed to the shower head, replace with a new piece of white gyprock (you will need to supply) that is water resistant/rated to use in bathroom, and replace the shower head (I have already purchased the new shower head, see photos).

Leaking shower head and a leaking washing basin faucet. Have to lay the shower head flat but even then it leaks - the shower head also stays warm.