Find a local network troubleshooter in Outer East Melbourne

🚨 URGENT – Needed TODAY Experienced IT/network technician needed ASAP for a home office in Rowville, just off Wellington Road. Our computers have been losing internet connection intermittently and now won’t connect at all. Wi-Fi on phones and cameras is also dropping in and out. Work required: * Diagnose and fix internet connection problems. * Check modem, NBN equipment and network cabling for faults. * Organise, tidy and secure messy cabling. * Restore stable internet and Wi-Fi across all devices. Business operations are affected. Urgent attendance required TODAY. Please advise your earliest arrival time. Ready for you to start immediately.

We have a shop at Eastland Shopping Centre. We are getting a drop out of internet at one point- Telstra needs to check if that port cable from back office to counter is not damaged. Their comment is as below: “We need cabling checked from ntu to the cisco router, coving ntu to patch point > internal patch point to patch point > patch point to cisco router. We believe the fault to be between the internal patch points. Collecting photos of these connections could also be helpful.” They want electricians to check and confirm if that is not damaged We also have multiple port going on if one is damaged Shop open 9:00 to 5:00 everyday

Configure UniFi access point to network, configure Dahua intercom to connect to 2.4ghz

I need an electrician or data cabler to install 3x ethernet ports in a single-story house built on concrete slab and Tile roof. See attached image The NBN router is located in the living room. I'll need: (1 x port) in Living to pass through to Lounge Room (1 x port) and (1 x port) in study (direct connection to router in living) See image. PINK spots for the new ethernet ports. Please provide a quote for all materials and labor, including running the cables and installing the wall plates. thanks

Hi, I need help finishing a home network setup at my house. The house is already wired with Cat6 LAN points. I have a rumpus/living area panel with 5 LAN ports, and I’ve identified that 4 of them connect to rooms in the house. There is also an NBN-labelled port, a garage LAN port, and a loose Cat6 cable near the old NBN/garage area that need to be identified and tested. Looking for someone experienced with data cabling/home networking to: * Identify and test the mystery Cat6 cable/garage/NBN link * Terminate loose Cat6 cable(s), likely T568A * Confirm which port goes where * Connect the incoming line to the rumpus distribution panel NBN FTTP is already active and working. I just need the internal LAN cabling finished properly so the room ports can be used. Should be a straightforward job for someone with the right tools/tester.

Test and connect data ports to nbn, plus create a new port in one of the room. House is a new build. I have a switch and about 8x1m Ethernet cables. Nbn is connected and Vodafone modem is operational

I’m looking for an experienced cybersecurity / network intrusion specialist to attend my home and carry out a full security audit. There are strong indicators of a man-in-the-middle (MITM) attack and possible misjumpers on the network, so I need someone who is capable of identifying the exact entry point and locking everything down. *Full audit of router, modem, WiFi access points, and any mesh/extenders *Checking firewall rules, DNS manipulation, ARP spoofing, and unusual routing *Eliminating backdoors, hidden SSIDs, or duplicated networks *Reconfiguring and hardening the entire network *Providing a simple summary of findings + recommendations

I need someone to help me setup my own VPN server and configure the home network (including modem and router) and teach me how to connect to my home vpn while I am using an external network. I have a Synology 218+ NAS, which has OpenVPN. I also have computers that can be used as a server. I managed to set up the OpenVPN server and was able to connect to the server from the client, but I have not been able to use the internet once connected to the VPN. I suspect there is a DNS issue and a port forwarding issue. Not sure.

We have an opticom/uniti network (NBN) and as well as Optus 4g. Connecting directly is working, but when the network is plugged into the rack which supply network to access points etc it’s not working need this fixed

I have a Cisco network switch that needs to be configured and connected to my ISP router.

Ethernet computer network issues. “Can’t reach default gateway” “No DHCP server found” “Multiple computers on the network using your computers IP??”

Issues with connecting to internet with wifi extenders

Have had Unifi network running for 5 years - including security cameras - now having issue with corrupted cloud key, would also like to optimise set-up - Due date: Flexible