Find a trusted local light installation service in VIC

Looking for a licensed electrician to install 3 ceiling fans with integrated LED lights in our single-storey house in Point Cook. * We will supply the 3 ceiling fans. * Each location currently has an existing ceiling light/fitting, so the fans will be replacing the existing lights. * Existing electrical points are already available. * Need the fans securely mounted to the ceiling with appropriate support/bracket. * Connect the fan and light to the existing power supply. * We would prefer to use the existing wall switch for power, with the fan/light operated via the supplied remote. * Please check the existing ceiling mounting/support and advise if any additional support is required. * Clean up after installation.

Needing hexagonal LED light installed in a panel shop. It is 4.85 x 2.45 m

7 floodlights to install for a single storey house. Have access to ceiling from inside the house via ceiling door. 2 at front of the house, install on eaves, need to install a new switch indoor to control the lights. 2 at the back of the house, also need to install a new switch indoor to control the lights. The rest 3 need to install on different sides of the house, they need to wire to the existing floodlight/outdoor loop, so they will light up together with the exisiting floodlights.

Hi, I need 6 led downlights and one hanging light installed. Please provide a quote.

Hi we have 2x LED ceiling lights that need to replace our current ceiling lights please.

2 ceiling fans need to be installed into the bedrooms. I already have the ceiling fans and they are getting installed into where the bedroom lights already are located.

Installation of pendant over kitchen island. 2 pendants needs to be installed. Wired Junction box already exist in ceiling hence no wiring is needed. Junction box is wired to switch already.

I have purchased an up/down light that I’m wanting installed at our front entry which is located under our carport

Needing the below 1 x neon light removed from SOUTH MELBOURNE Needing the below installed in Middle Park - 3 pendant lights removed and replaced (lights supplied) - neon light from other place (this needs a lead to convert into a plug for wall power socket) it cannot be run into the wall as its double brick - another neon which just needs to be hung and plugged into wall power (again brick wall so cannot go internally)

Hi I need outdoor lights install all ready have sensor lights install. Need new lights install on garage side pillars. I will supply the lights.

Need new headlights installed

Just need someone to wire in a hanging light in a bedroom

I have a large skylight I would like to install on my roof. I am looking for experienced help to oversee and assist installation. I am handy and happy to do most of the heavy lifting etc but specifically looking for someone who is either in the industry or WELL versed in this kind of installation to help with the finiky side of things. I am specifically NOT looking for a second well to do handyman like myself. PLEASE ONLY MESSAGE IF THIS IS SOMETHING YOU ARE AN EXPERIENCED PRO AT. Additionally I have two other skylights which have been leaking and i would like some friendly professional advice on how to fix. To clarify I am only seeking help installing, watertight, onto roof. No need for shafting/plastering etc on the inside. Skylight is a standard Velux and I currently have the corresponding flashing. Roof is a pitched Terracotta Tile (1st Floor)

Need some aftermarket headlights fitters to my 79 series landcruiser, old headlights will be out and just need to put these in will need to connect a couple of wires that come with it

Uninstall a faulty ceiling light and install a new one

Need to install 2 up down coolum lights for our front pillars. Lights have normal plug but the pillar have only sockets with wire provided.

Licensed electrician required to install 2 x Philips Hue Akari downlights in my Melbourne CBD apartment. Scope of works: * Remove 2 existing downlights * Enlarge existing ceiling cut-outs from approximately 63mm to 90mm * Convert existing hard-wired connections to plug-base connections suitable for the new lights * Install 2 x Philips Hue Akari downlights (lights supplied by me) * Test operation and ensure installation complies with Victorian electrical requirements Details: * Apartment with plasterboard ceiling * Existing lights are currently wired directly into the electrical circuit (not plug-based) * New lights require 90mm cut-outs and plug-base connections * Looking for a neat, professional finish with clean cut-outs and no ceiling damage * Licensed electrician only * Please include any parts required (e.g. plug bases) in your quote and advise whether a Certificate of Electrical Safety will be provided

3x white downlights and 2x three spotlight black ceiling lights need to be installed.

Currently has downlight need heating 3in1 heating light installed

Two wall mounted lights installed on wall and connected. They will be installed ons brick wall so there will need to be some conduit run from ceiling. There is easy access to ceiling directly above proposed installation spot. There is also power and a pre existing switches that could also be used