Find a professional lattice installation service in Inner West Sydney

Attaching timber lattice to timber paling fence. Approximately 8m. Would suit someone with nail gun. Lattice already purchased

Thick, quality, charcoal shadesail fabric possibly custom made to be fixed around carport as privacy wall-screens down 2 sides and across one (road) end only (not house-end; this to be left untouched) to be off floor and possibly just below carport roof (you decide) with said outer road-end made into a 2-door swing-in fabric covered lightweight gate-frame, or lattice pieced gate-frame (or other lightweight method?) for rare brief single car access (carport used for seating area). My EasyShed flat roof 2.25mW by 0.78D by 1.82H (arriving soon) to be put up by you therein resting on thin pavers you recommend. Photo is not my single carport but is same, also as those seen in distance opposite. Note: all double carports are for two houses to share being divided down middle by two steel pole supports at either end ie the double carport seen in far distance is for two houses to share, as is mine. Only half of the double carport, including its shared middle section, is to be screened and gated. Carport measurements are: 450m/177" = the 2 down sides (each) and 300m/118" = road end going across (for your custom-made gate across bottom). The carport roof at outer edges (from ground) is 207m high, at interior 210m high. Suggested lattice (if not making fabric covered gate-frame or other method?) for double gate, is perhaps: Bunnings Jack Matrix charcoal plastic reeded diamond lattice; sizes include: 2410 x 1205 x 5mm 2410 x 1205 x 7mm 1800 x 1200 x 7mm 2400 x 600 x 9mm None of the carports are screened. Mine will be the first. As I have no frame of reference to guide me, any knowledgeable advice, economy saving tips, and helpful suggestions will be appreciated.

Require painter to paint exterior lattice work, approx 5 sqm, the lattice is already fixed to the wall. Its 3.7M high by 0.9M wide, ladder and paint provided. Two coats of paint will be required Photo attached - Due date: Flexible

Install a lattice under deck and install polycarbonate and angle to block off near wall - Due date: Flexible

Measure up, purchase and install wood lattice on top of back fence shared with neighbours. It’s awkward to access due to a hedge in front. Lattice is $45 from Bunnings. Bunnings is a 15min walk away, 5min drive. - Due date: Flexible

Looking for someone to supply tall lattice fencing on my low balcony for privacy and also safety. - Due date: Flexible

Take away hardwood posts and pieces of lattice Take to tip or use yourself in projects Pick up Summer Hill - Due date: Needs to be done on Monday, 13 March 2023

Three (3) rattan lattice styled chairs need repair. I have provided two photos. In good state and another in need of repair. - Due date: Flexible

Frame and lattice (square) to fill in an end of a patio to visually screen a fence and give dappled sunlight. Lattice and frame needs to be painted to match upright posts (grey colour).

Cut a small section of Lattice down - Due date: Flexible

Looking for a professional to install 1800mm lattice along the left hand side boundary (as per attached floor plan) and the aluminum tubular pool fencing around the balance of the perimetre to child-proof this rooftop terrace. - Due date: Flexible

Remove old lattic, replace with new lattice which we have bough onto of fence with new supports 2 x 2 4m pieces.

Need landscaper/handyman to build a lattice (preferably timber) along the corner of my backyard fence. Would also be required to plant roses to grow up the lattice. Back fence/corner is approx 7-10m. Job is incl of materials and labour.