Find a local Tasker to inspect your Holden in NSW

New roof lining installed Holden 1980 rode type, old one is out windscreens out ready to go

I can come to you if you're not too far. I live on a main road. I can buy the parts myself. Just looking for an affordable option. One taillight is out. And both headlights are dim. Quote me for just the taillight and oil change, and for all 3 lights.

I think there is a Screw or a hole in my back tyre ( need it fix tomorrow after 3:00 pm)

Need someone to come out and change the tire for my vehicle so I can take it to the tire shop please and bring the tire asap

Need a new clutch supplied and installed in a 2006 Holden rodeo

Install 2 x 6.5" new speakers front of 2011 Holden Commodore VE Series 2 may need spacers. Speakers to install are Kicker CSC65 speakers to replace standard front door speakers

Need someone to come look at sons ute and see if able to fix if it is and you can do it jobs yours

Driver side needs new door handles put inside and outdoor. I have the new door handles 2003 Holden commodore Both old handles are broken If it can be done this arvo or tomorrow would be good

Qualified experienced mechanic wanted for a job is marsden park. The job is to replace 2 cv boots on my 2007 holden rodeo. Parts will be supplied. This weekend preferably

Camera works very intermittantly

Hi Looking for a reliable mechanic or someone to service my Holden commode 2003 and put in new door handles on the driver side inside and out and put in the new switch ordered the parts thanks

front bumper corner pushed out and jagged plastic edge , smash repair.

Find out what is causing the 3rd cylinder to misfire (spark plug or coil) fix the problem and replace all 6 spark plugs while plenum is off. Quote Tools and labour, All materials supplied by me.

Both headlights (right and left) on my Holden Captiva are blown. The high-beam bulbs are fine. So just need the low-beam bulbs replaced - which I believe are H7 bulbs. I'm hoping someone can supply the bulbs and come to install them in Pyrmont this weekend.

I’m need a mechanic to do front break pads replacement. I also need them to supply the parts if possible. I’ve been quoted by 2 other mechanics so know the price range that’s usual i won’t repsond to higher then usual prices.

Essential Tools Hydraulic floor jack (preferably 2–3 tonne) Heavy-duty jack stands Socket and spanner set Ball joint separator (pickle fork or ball joint puller) Pry bar Hammer Torque wrench Spring Installation Tools Internal Coil Spring Compressor Internal coil spring compressor designed for front suspension springs Safety chain through the spring as an additional precaution This is the safest method, especially if the front end is fully assembled. Or Jack Under Lower Control Arm Many HQ restorers install springs by: Removing the shock absorber. Positioning the spring correctly in the upper seat. Supporting the lower control arm with a floor jack. Slowly jacking the control arm up until the ball joint can be connected. Reinstalling the ball joint and shock. A safety chain through the spring is strongly recommended because HQ springs store a huge amount of energy. Helpful Extras Penetrating oil Long punch or drift Workshop manual Impact gun (optional) Important Safety Note HQ front springs can be dangerous if released unexpectedly. Never rely solely on a jack. Use quality jack stands and, ideally, a spring compressor or safety chain. If the lower control arm is disconnected and the spring is not restrained, it can eject with significant force.

Battery clamp Rear shock 2 tyre Vtec valve Rear brake Park brake check

2015 Holden Captiva P0010 Fault Code Repair

Rear indicator bulb needs changing. Old one is completely stuck. I have the replacement bulb. Hopefully today as I need to drive it to work in the morning.

Please remove faulty existing upper radiator hose and install new radiator hose from radiator to engine block already have the hose just need the labour to fit it please