Find a professional gyprocker contractor in Australia Square

Gyprock plasterboard install - angled ceiling (Newtown) Looking for an experienced plasterer/gyprocker to supply, install, set and sand plasterboard to a paint-ready finish. Scope: • Angled ceiling approx. 3.4m x 1.2m • Ceiling height ranges from ~2.8m to 3.3m • Supply plasterboard and all materials • Install sheets to framing • Tape, set and sand joints • Finish ready for painting (smooth, no visible joins) Location: Newtown NSW Access: Easy indoor access, but will require ladder/appropriate equipment for height

Insert three small pieces of gyprock that were cut for air conditioner installation. Repair gyprock pieces, sand and paint wall.

Just had 2 skylights re-installed and required new gyprock to be added to go up to the two skylights (around 50cm on 4 sides) and gyprock finished off professionally (rest for painting by someone else). * Quote to include all fees and materials.*

Looking for someone to do one gyprock wall and have door for the toilet 1.90 wide and 2.35 height

Jobs 1 and 2 are simple. Fill the holes with plaster and then paint over. Job 3 is more complex. Cut out the gyprock (may be fire rated gyprock, am not sure), replace-gyprock that square, plaster and paint. We will provide paint. Other materials provided by you.

I need gyprock installed to the lower third of an exposed brick wall to prepare the wall for installation of wainscotting. The section of wall to be covered is 270*90cm You will need to include all materials in the quote.

Gyprock the ceiling of a re-roof

We removed sliding door wardrobes in two bedrooms and cut the gyprock 30 cm higher in one room and 20cm higher in the other room. We need the cut part of the wardrobes patched and plastered before the new ones get installed on 7 October. We will paint once you are finished.

Remove existing gyprock Install new gyprock and cornice Cut holes for light and fan. Patch and paint All materials will be supplied and no rubbish removal required. Ceiling is approx 2mx3m.

1x sunscreen blind to be installed in study 1x double blind to be installed in guest room 1x double blind to be installed in main room 1x hanging rod to be installed in lounge room No tools provided, all blinds come with required nails etc, no holes have been done to walls and will need to be done as part of install please

We need you to remove 2 blinds and detach a security sensor to enable the ceiling to be repaired. Approx 4sqm of damaged ceiling needs to be replaced with new gyprock and prepared ready for painting. Approx 36sqm of ceiling needs to be painted so the repair is seamless and invisible. The blinds then need to be reinstalled and sensor reattached. We need you to supply all ceiling repair materials and remove all waste. We will supply the paint which will be Dulux.

Cut out the current gyprock/plasterboard around the shower head approx 40 cm2, check there is no leak in the water lines that feed to the shower head, replace with a new piece of white gyprock (you will need to supply) that is water resistant/rated to use in bathroom, and replace the shower head (I have already purchased the new shower head, see photos).

The Chiprock ceiling in my attic space which is used for storage and as an office, was damaged by water. I hope this is clear from the photos that I have posted. I would like to have it repaired.

Hi there, I’m looking for a gyprocker who can redo 2 ceilings at [Content Moderated] Newtown. One is 1.5 x 1.5m The other one is 2.5x3m. Ceiling grit is 3.3m Install and set joints. Old material has to be moved from site.

Mount TV 32 Inch - Gyprock

Two small holes cut in gyprock need to be patched up. 1. 30mm x 30mm 2. 200mm x 100mm

I am looking for person ,do the setting on Gyprock been install ,including Attic room with bathroom ceiling ,second Bathroom ceiling and close it ,Bulk heads Trade person need to supply all the angles ,Base coat and Top coats

Water leak is fixed, just need to replace damaged gyprock kitchen ceiling. Approx 4x2m in size.

Need someone to pickup Gyprock base coat 45 10kg and Gyprock top coat 2.25kg from Bunnings and bring to me in Newtown ASAP. Will need to be paid for at bunnings. These are $37.46 and 21.55 each So I have allowed cost of goods plus $100 delivery inclusing Airtasker fee - Due date: Needs to be done on Wednesday, 15 November 2023

Supply and install Gyprock wall and archway for door We are in need of a skilled professional who can assist us in the installation of a Gyprock wall to separate a specific space and build a door archway for the room door. Below, you will find the measurements for this project: H -2380mm W -3180mm NOTE: Door will be supplied by us. - Due date: Needs to be done on Thursday, 2 November 2023