Find an experienced gas fitter in Castle Hill NSW

Hi, I recently had a new Rheem 135L External Natural Gas Hot Water Tank (Model 300073) positioned and hooked up at my property in Castle Hill. Unfortunately, the original installer did not complete the legal paperwork and has since disappeared. I need a fully qualified and licensed NSW Plumber and Gasfitter to come out, perform a formal "Rectify and Re-install" job, and officially certify the system. The Scope of Work Involves: Inspection & Testing: Isolate and inspect the existing gas, water, and drainage connections to ensure they comply with AS/NZS 5601.1 and AS 3500. Rectification: Disconnect and properly reconnect/re-commission the unit if any part of the existing installation falls short of NSW regulations or trade standards. Official Certification: Upon verifying or rectifying the work, you must lodge and provide the official digital compliance documents: Gas Certificate of Compliance submitted via the mandatory BCNSW eCert portal. Plumbing & Drainage Certificate of Compliance submitted via MyInspections. Note: The certificates must explicitly include the new Rheem unit's Serial Number so I can secure my 7-year manufacturer warranty. Requirements for Applicants: Must hold a current, valid NSW Contractor License covering both Plumbing and Gasfitting. Please provide your license number in your offer so I can verify it on the Service NSW Public Register before assigning the task. Please confirm that you have an active account on the BCNSW eCert portal to complete the digital lodgement. The unit is brand new, easily accessible externally, and all major hardware is already on site. Looking for someone reliable who takes pride in compliant, safe workmanship. Thanks!

Install an electric Induction cooker. Switchboard need to make a cable for cooker. Gas cooktop now.

Need a gas fitter/plumber to connect gas to heater. The pipe is very close so it will be a quick easy job.

Gas stove issue : • The largest burner only ignites when I use a torch/lighter. • The flame doesn’t come out evenly — it spreads irregularly around the burner. • When I release the knob after pressing it down to ignite, the gas shuts off immediately. I dot know the market price, please offer me your service fee

Gas stove issue: The largest burner only ignites when I use a torch/lighter. The flame doesn’t come out evenly — it spreads irregularly around the burner. When I release the knob after pressing it down to ignite, the gas shuts off immediately.

Residential LPG Gas regulator is leaking. Needs replacement.

Replace an existing 90cm gas cooktop with a new one.

My hot water has stopped suddenly

Have an existing gas connection to connect BBQ

Need a certified gas plumber to fix Rinnai Avenger 25. It shows fault 12.

No gas flowing on heaters. Gas supplier came & inspected, no problem with the connection. Gas hasn't been used for a long time.

1) Need to remove & install a new gas top ASKO 75 cm 5 burner 2) Same for an electric oven 60cm

We have a new (November 2024) Rinnai gas water heater. After installation there was an awful smell and the original installer came back to fix it. Now several months later again, there is an awful smell of gas in the surrounding area and filling the nearby garage. Need urgent assistance.

Hi My gas fireplace heater is not starting up anymore. Needs to diagnose cause and repair

Check/fix gas smell in kitchen

Replace the current Gas cook top

Service stove. Two not working out of five. Maybe replace thermocouple.

Hi there - we have a natural gas top stove but we use propane. The flame is high even on the low setting. We have to replace the jets. We currently have a Westinghouse stovetop. We are looking for a licensed plumber to assist with replacing the jets.

I want to install a gas fitting outlet to run a LPG gas bottle just for one appliance.

Remove the following oven from the crate and then lift up onto customers bench and connect to LPG gas bottle Oven is listed below: https://napoliovenco.com.au/products/copy-of-vesuvio-800-gas-oven