Find experienced local fencing contractors in WA

Replace 2 x colourbond fence panels and bottom rails

I have a wooden fence in my back garden. Id like to have it taken down and a new fence in its place. Preferably steel instead of wood this time.

Two wooden gates swollen in the rain, need repairing and re-hanging. May need to lower paving immediately under the gates

We have a pets electric fence. We need to get somebody to make sure that the fence is free from plants. It's mostly fine -- I am showing in the photos the absolute worst bit. The job is to make sure that the fence is totally clear of plants.

Wanting a timber picket fence built to front garden. Approx 3.5m x10m x7m (including gate) maybe 1200 high? Want old school pickets. Empty yard so nothing to remove first. Open to suggestions. I’m happy to paint it myself once up. Thanks in advance. This is the house and yard with a suggested picture of the fence.

Need a new gate installed, preferably not wood. 1100 wide and 1700 high approx

Pull down and remove 6m of asbestos fencing and 1 lattice full height panel Install 6m x 1800mm high colorbond fencing using ally wall where needed for retaining. Fence to be installed between my unit and my neighbours in the back garden. Fence installation without existing asbestos fence removal can be quoted for, ie separating out the removal and installation.

We had a handyman build a fence and he was going to fix the gate but has become unwell so we need someone to finish the job! We need a garden gate fitted. We will source the gate, but not the hardware to fit it, so you’ll need to source brackets, screws etc.

I am looking for a handyman or tradesperson to install a self-closing spring or hinges and a latch on a garden side gate. Job details: • Install a spring for self-closing function on garden side door • Install/adjust hinges as required • Ensure the gate closes properly and aligns correctly prefer someone with Own tools and equipment.

Small aluminium fence with 2 gates approx 1200mm high x 2100 wide

One of my timber retaining wall posts has failed and needs to be replaced. I’ve already removed the old rotten post (see photos) and taken measurements to assist with quoting. Please: Supply and install 1 new treated post Secure post to support the upper sleeper beam and stop further collapse Must be structurally sound and weather-resistant Preference for someone with landscaping or carpentry experience

11m fence install. Already have the supplies.

Build a fence around veggie garden to stop dog digging holes! It is roughly 7m of fencing needed and no more than 1.5m high. Something super simple made of wood or pallets. Thanks

Install garden barrier to bottom of colourbond fence with tek screws. We have the garden eding and tek screws. Will need to difmf sand back from fence to install. This is a new build. Approx 24 metres.

I need 2 wooden slats reattached to my front garden fence.

For front fenced lawn, I need metal slate gate ( Matching slats). It will be 2 doors of approximately 1 meters by 1 meter.

- Ground is rocky and gravelly in some areas - Ground is hilly in some areas - Can be made how you like as long as it works and is secure

I need my garden gate replaced. Its a standard 90x150 arched timber gate. I would like you to: - Supply the new gate - Swap over any hardware from the original gate to the new gate - Hang the gate - Dispose of old gate

Colour bond garden gate needs lifting as it has dropped and is difficult to open. Scraps on the ground

Jarrah closed picket, wooden gate has been sealed and painted. No hardware or posts included. We need you to create infill for this to fit. Size of gate - 180cm x 90cm Size of gap - 116cm $200 plus costs

I intend to relocate existing fence towards pool. It may need few new panels

Put up a dog fence area (fence materials will be provided) Type of gardening: Other Size of garden: Under 50m² Has green waste bin: No

Needing an area fenced for dogs. Putting $123 for price as open to quotes. Open to both wooden and wire options.

We have a pets electric fence. We need to get somebody to make sure that the fence is free from plants. It's mostly fine -- I am showing in the photos the absolute worst bit. The job is to make sure that the fence is totally clear of plants.

Swing gate relocation (removal and install) to front fence + supply any materials needed for the job.

Drilling small posts into colorbond fence and then the oscillot rollers. 4 x 2m lengths.

I need urgent installation of the Oscillot cat‑proof fence system. Details: • Install Oscillot rollers around my Colorbond fence perimeter • Add one small inward‑facing net panel in a corner with tall vegetation • Minor gate tweak (small internal net square or inward cap) Please let me know your earliest availability — the job is time‑sensitive. Thank you.

I need a dog fence installed in my courtyard area (see photo attached with red marked section). Details: • Approx length: 6–8 metres (straight run) • Surface: paved/concrete • Height required: approx 90cm–120cm • Secure enough for a medium-sized dog • Would prefer black powder-coated panels (open to suggestions) • Must be securely anchored (not temporary plastic fencing) Please quote including: • Labour • Materials • Any drilling/bolting required Please quote total cost including materials and installation for approx 6-8m dog fence. Thanks!

New Gate and Fabrication similar to photo below look for measure and quote

I am looking for someone to supply and install a wooden gate/fence (custom built to size) in two outdoor areas of my property. This is not a decorative job — the main purpose is containment for a cat/dog, durability, and safe access. The $1200 budget is inclusive of all materials and labour. Area 1 • Total width: ~ 142 cm • Requires: Gate + fixed fencing • Height: ~180 cm • Minimal gap at bottom (must be pet-proof) Area 2 • Total width: ~ 253 cm • Requires: Gate + fixed fencing • Height: ~180 cm • Minimal gap at bottom (pet-proof) General Requirements Materials: Simple and durable open to suggestions. Finish: Doesn’t need to be fancy functionality over appearance Gate: Lockable or latchable Bottom gap: Must be small enough that a cat or small dog cannot escape Supply & install included Must be suitable for outdoor use I’ve attached photos of both areas for reference. I’m happy with practical solutions and open to suggestions that keep costs down while remaining secure.

In need some Oscillot cat fence toppers installed on about 15m of fence and on top of 3 fence gates

There is around 70m of fencing in our backyard. Looking to install extend fenceline up 400/600mm and install 'lean-in' PVC piping with mesh to deter the dog from jumping. Materials supplied, just looking for labour.

Require relocation of retaining wall and colourbond fence due to encroachment onto neighbors property

Hi everyone I need a side gate installed to stop my dogs escaping. Doesn’t need to be anything fancy just something that will stop them escaping

Addition to cat enclosure involves fastening 7m x 1.2m Catnet mesh to house eaves on one side, to colourbond fence on other, extending to the ground at both ends with entry to existing enclosure at one end.

Need my fence (gaps) patched up to stop my puppy escaping to neighbour house, something like the picture I instal.

Hey everyone! Due to my house being newly built I need a really good handy man to figure out a way to stop my dogs escaping. My dogs are digging under the fence and getting out.

Some basic chicken wire fencing doing. One of our dogs has become an escape artist!

The dogs dig under the fence need some dog proof wire or something installed open to suggestions

Enclosure net, brackets and all other materials have been purchased just needs to be attached to the existing fence. The enclosure doesnt enclose totally as in roof. It is fence extension brackets attached to fence and then a wire netting put along the brackets to extend fence height. Most of the fence is wood, a small part is metal and an equally small part is brick. I have all necessary attachments bought with fence extension wire. I hope this helps. Approx 20 - 25 m In my head it would take 8 hours. I am happy to work as a side kick.

Remove about 3 metres of asbestos fence Remove double gate Replace with colour bond fence and gate

Fencing contractor required - QUOTE I have several fencing jobs I would like quoted at my property. I am looking for an experienced fencing contractor who can inspect the work, discuss options with me and provide a quote. Jobs include removal and relocation, core drilling new fence into limestone, adding plinths etc Please do not make an offer of $10 — the $10 is only being used because Airtasker requires a budget to post the task. I would like to discuss the various jobs with interested fencing contractors and obtain a quote for the work. Photos and measurements can be provided, but I would prefer the contractor to inspect the site before quoting. Please only respond if you are an experienced fencing contractor and are interested in providing a quote.

We are looking to have nine sheets of paperbark colourbond fencing replaced. There are three panels and associated rails, posts and footings as per the photo in the advert. The old fencing is to be removed and disposed of as part of the job.

Total of 3 panels (7 MTRS) fence to be installed. Digging for post, concrete and fence installation to be done. Fencing materials+ concrete will be supplied. Must have own tools for digging and installing 2 panels at rear of house. 1 panel side of house.

16M of colorbond fencing supply and installation

Pull down and remove existing fencing 23m hardifence Install 18m x 1800mm, 1m angled down section and 4m x 900mm high Colorbond fencing with 1 x plinth per bay to retain soil levels.

Colourbond fencing 30 meters approx needs to be installed, and internal garden fencing aprox 15 meters with gate

Looking for an experienced fencer to remove our existing Hardie fence and replace it with a new Colorbond fence. Scope of work includes: Remove and dispose of approximately 13.5m of existing Hardie fencing Supply and install approximately 13.5m of 1.8m-high Colorbond fencing Supply and install 6 retaining plinths under the Colorbond fence to accommodate height differences Allow for approximately 24 × 20kg bags of cement for installation Remove all related waste and leave the area tidy upon completion Please provide a quote including materials, labour and disposal. Preference for someone experienced with Colorbond fencing who has the necessary tools and equipment. Please include your availability and Quote . Thank you

Install a section of fencing at 1.8 metres, to then rake down to 1.2 metres, dividing front neighbouring properties. Length 8-10 metres

Hi getting price for my brother who lives in marangaroo need to get rid of old broken fence and replace with 1.8 high colorbond

Replace 2 colorbond posts. Top rail and bottom rail and 3 sheets all in good order.

Remove under 1 meter brickwork and supply and fit approximately 9 meters of colourbond fence and gate.would like colour and profile to match existing fence if possible.new fence to go up to first corner of unit ( right side of window)

Supply & install a 1m x 1.8m high single Colorbond gate with posts and an approx .6m x 1.8m high colorbond return panel to the LHS of the house across to the next-door house wall behind M/Box,RWP,NBN Box and Tap on the wall. A Deluxe Key Lock latch fitted Colour and profile of gate to match boundary fence Thank you! Looking forward to your response.

Would like approx 5m of colourbond fence replace (Basalt) reposted and two plinths added. Photo has been added to display what fence you will be replacing

One Colorbond fence panel has come loose and is leaning after a storm (see photo). I’m looking for someone experienced with Colorbond fencing who can inspect it and reinstall/repair the existing panel if possible. I believe the panel may just need to be re-secured, but I’m happy for you to assess the best repair. * Located in Aveley WA 6069. * Easy side access. * Flexible with days and times. * Please bring any tools and fixings required. * If additional materials are needed, let me know before completing the work. Please provide your experience with Colorbond fencing and your total price to complete the repair.

Remove existing sqaure panel fence and install a colourbond fence kit from Oxworks. I am happy to remove existing fence on the day if easier. 2 x 2400mm wide x 1800mm high sections which fill in between Linestone pillars. Can secure into Linestone Wall so no digging required.

I want to partially enclose my garage with one large colourbond panel in Grey Ridge. Supply and install needed, suggest site visit to confirm measurements etc. Solid brick wall to one side and post or similar will need to installed into concrete/paver.

I am looking to get someone to assemble a Colorbond gate kit (from Teamwork Fencing) and install it in place of an existing wooden gate (removal of old gate will be done by me). I have purchased the kit and have it ready for assembly. Please note that the gate posts will not be concreted in to the ground and therefore, will require cutting to size.

Install PA gate with side panel - colorbond 1.8 high 1.7 width PA gate - approx 1m width Side panel- approx .7m width Belmont area

We are wanting someone to supply and install 1 x plinth to the bottom of our colourBond fence 2380 wide