Find experienced local fencing contractors in Schofields

Hi, I need a handyman to supply and install a dual-sided gate latch (like a D&D LokkLatch Deluxe) on an existing metal side gate and metal post at my home on Mary Jane Parade.The latch needs to open from the outside and have the option to be locked from the inside.I am currently away from the gate but will upload clear photos of the metal frame, post, and gap tomorrow morning so you can see the setup.Please provide an estimated quote for labor + supplying the lock hardware. Thank you!

I’m looking for an experienced fencing professional to remove an existing wooden fence and install a new Colourbond fence approximately 15–16 metres long. Scope of work: * Remove and dispose of the existing wooden fence. * Establish a new fence line approximately 300mm away from the existing fence. * Install the new fence along the new alignment. * Fence length is approximately 15–16 metres. * One side only. * Supply and install new Colourbond fencing, including posts, rails, sheets/panels and concrete footings as required. * Ensure the new fence is straight, level, secure and properly finished. * Remove all old fencing materials and construction waste from site. Important: The new fence is not being installed in the existing fence line. It needs to be shifted approximately 300mm from the current fence, so please allow for this when assessing the job and pricing. Please include in your quote: * Labour and materials * Removal/disposal of existing fence * Colourbond fence supply and installation * Concrete/post installation * Any additional costs associated with creating the new fence line I can provide photos and access details to shortlisted Airtaskers. Approx. length: 15–16m Fence: Colourbond Sides: One side only New alignment: 300mm offset from existing fence line

28 Panels. Clean & Clear: Remove any existing pigeon nests, debris, and droppings from underneath the solar panels before installing the mesh. Install Mesh: Install PVC-coated galvanized steel mesh around the outer perimeter of the solar panel array. Side-by-Side Overlap: Mesh sections must be installed side-by-side with a 2-3 square overlap at the joints to ensure there are absolutely no gaps. No Drilling: You must use non-invasive solar panel clips (no drilling into the frames to avoid voiding the warranty). Mould to Roof: The bottom of the mesh needs to be neatly contoured and flush against the roof profile so birds cannot squeeze under.

Remove partial fence as it’s leaning and dispose the wood. See the area highlighted in yellow - that’s where the edges are. Length - 5.1m long and roughly 1.6m high You’ll need to cut the leaning wooden fence from one pole to the edge and then dispose all the rubbish at no additional cost.

I have a fence in front of my house that I want to remove and relocate to the side of the house

I’m looking for someone to help change the opening direction of a side gate in my backyard. The gate was originally hinged on the right side, and I want to change it so the hinges are on the left side instead. The gate has already been removed, so it will need to be reinstalled with the hinges moved to the other side. New screws will likely be needed, so please bring suitable screws and tools. The gate itself is in good condition. Location: Tallawong. Flexible with timing. Budget negotiable. Photos can be provided if needed.

Task description: Hi, I’m looking for an experienced fencer/handyman to install pre-made white aluminium picket fence panels (with gaps) from Bunnings (or similar) at the front and sides of my house. We will purchase and supply all materials — I need labour + installation only. Fence style (pre-made panels): • White powder-coated aluminium picket panels (like the Bunnings “Aluminium Boundary Fencing & Gates” range) • Pickets with gaps (open style) • Height: ~1.2m (or closest available panel height) • Gate opening: 1.10m Measurements (approx.): • Side (left): 5.70m • Side (right): 6.30m • Front right section: 4.10m • Front left section: 4.80m • Gate opening: 1.10m ✅ Total fence length (excluding gate): 20.90m Scope of work (install only): 1. Confirm measurements and panel count on site 2. Mark the fence line (I will share photos with red markings) 3. Install fence inside our property boundary (not on the boundary line) 4. Dig post holes and set posts with concrete 5. Fit panels straight and level, including corner joins 6. Install 1.10m gate (hinges + latch), ensure smooth operation 7. Clean up and leave area tidy (stack leftovers neatly) Materials we will supply (Bunnings pre-made system): • Pre-made white aluminium picket panels (quantity based on panel width) • Matching posts (end/line/corner posts) + post caps • Gate panel/kit (1.10m) or matching gate from same range • Hinges + latch set (if not included) • Brackets/rails/connectors as required for the system • Screws/fasteners (galvanised/stainless) • Concrete for posts (rapid set) What you must provide: • All tools (post hole digger/auger, level, drill/driver, cutting tools if needed) • Experience installing aluminium panel fencing (preferred) Location: Tallawong NSW 2762 Budget: Please quote (labour only) When: Flexible (weekends/weekday)

Paint backyard fence (one side painting only) 1). Approx 68m x 1.2m high - need to be measured onsite. Two top coats needed as it’s old weathered fence 2). Replace few timber panels of existing fence with new panels - 28-30 off approx. 3). Reseal spray seal concrete path - 2x7.5m & 3x4m

Old colour-bond fence with wooden post that are now all falling down and ect. We have new posts and will provide cement and screws. Just need someone to come and make do with what we have to have fences that aren’t always falling down or flapping away.

Build an.iron gateat the entrance of the house

The fence came off due to the wind and want it to be uprooted back

Need help to repair the fence.. it may require putting few new poles/posts to secure the fence.

I would like to have a 2.2-metre double-fold clothesline installed in my backyard. The clothesline will need to be secured into the ground. Please provide me with a quote for supply and installation.Thank you

Dig 50 cm deep put concrete and drill timber posts, material will be supplied

At the backside of the house, I need to install a 13-meter timber/colorbond fence, which includes a gate of about 2 to 2.5 meters. * Total length: 13 meters * Fence length: 10.5–11 meters * Gate: 2–2.5 meters * Height: 1.8 meters Please provide me with a quote for timber and colorbond fences, including supply of all required materials.

Looking for Privacy fence (as per the image) to be installed on existing colour-bond fence: 4 * 400mm high * 2.4m length 3 * 400 mm high * 2.4m length 1 * 400 mm high * 3 m length Total of 8 Privacy fence / screens You will supply the material, labour and anything else that is required to do the job a nice way.

Need to install wooden fence about 10m to cover electric substation at the ponds.

Need repairs to a panel of colour bond fencing that has moved.

I want a fence installed at the side of the property with a gate. The length of the space is 10m and i am after 1.2m high fence. Aluminum or white timber fence is fine

Install 5* decorative screen panels like the picture - on top of exisiting colour bond fence. I wil supply the decorative screens, rest will be yours(labour + any material like screws etc) .