Find experienced local fencing contractors in Lane Cove

My current front stairs rails need to be replaced (2 x Posts, Balusters, Bottom rails and Handrails); the bottom of the rails has rotted through. I would like to replace the whole lot - Like for Like. I will paint it myself. The measurements are: - total length including posts are 3500mm - bottom post is 1280mm x 90mm - height of rails(not posts) are 840mm and width is 90mm

Looking for someone to stabilise an existing timber boundary fence that is leaning towards my property after recent concreting works. The lean has occurred due to undermined footings and a stepped change in ground level on my side. Details: • Approx. 8 metres of fence needs support • This spans four fence posts that require reinforcement • Work may be able to be carried out from either my side or the neighbour’s side – I’ll leave it to you to assess the most practical approach • Note: There is a stormwater pipe along the fence on my side, so that may affect installation method • The goal is to brace and stabilise the fence using steel supports set into concrete footings • The fence is otherwise in decent condition and does not need replacement • Preference for galvanised steel materials for durability • In addition, I need garden edging installed along the base of the fence to prevent further ground erosion. There is a difference level of about 40cm gradually stepping down to about 10cm along that 8m span. For example, the Jack brand garden edging strip (or similar) could be used

Wooden fence repair (1.8-2m gap)

Need someone qualified to install 60 degree chamfers on boundary fence railing for pool compliance purposes. Fence is roughly 15-20m long.

The side fence has collapsed due to high wind today. We need urgent repair installing posts in the ground to whole the fence

Instal 31m of treated pine fence, 100mm palings, three rail, 1800mm high, 100mm palings. Install only. Fence commences near to rear of the building line and runs to the rear fence line. Photos are of existing fence

Please see certificate of non-compliance and photo of pool below I need an experienced professional to provide a quote for fixing the following non-compliance areas: • Boundary fence • Fence height • Gate closure • Gate latch • Non-climbable zones • Signage (easy!)

Hi everyone! I'm after a basic wooden fence for the communal garden property. The plan is to create a safe area for our resident to plant and garden herbs. I've attached photos of the area we want to surround with a fence. I've also included measurements in some of the photos and a few photos of fencing ideas from other gardens. Please send through quotes for everything including materials. Kind regards, Phil

Lapped and capped fence is rotting and needs replacement. Approx 30m. There is a privacy screen of merbau wood above the lapped and capped fence which has a lean caused by a retaining wall that has bowed underneath it (maybe 15 m long). Retaining wall needs fixing and the privacy screen needs to be taken down and reinstalled once the retaining wall is fixed.

We need someone to install a fence + gate to create an enclosed area. We already have the fencing panels and gate.

We have an existing fence which is slightly tilted because of a tree and it needs to be straightened out

Supply and install new fence. Approx 10 m Take away old palings

Some fencing panels are leaning in. Needs them repaired.

Some minor work to get a pool ready for reinspection 1. Increase the height of part of the pool barrier to be more than 1210mm from highest point on ground. See the first photo for the problem point, measure from some higher ground. Looking to save cost, so can use timber block if that is easier. I think this is a case of putting a 450mm+ treated wooden post along the side for about a meter or so and securing it to the metal so it cannot be knocked off. 2. Cut down any trees and stumps within 500mm of the boundary fence. Rubbish can be put into our green bins or left at the property on the veggie patch. 3. Adjust the timber to have no projections of greater than 10mm. Can talk about how to do this, but I think the easiest way is to move the vertical posts to be in line with the top of the fence, and for the horizontal one (which is covering a gap) fix plywood to it to cover the hold, or put a 60 degree angle piece on top. Would accept an hourly rate and rough estimate of hours (plus materials extra), or a fixed price. Can come today or tomorrow. I am trying to get a reinspection for Tuesday.

We need someone who can measure, purchase and install two side gates to our property in Lane Cove. EDITED TO ADD: The side gates will be on the left and right sides, towards the front of the house. One side is 90cm. The other is 150cm and we would prefer the gates to be aluminium, vertical slats in a dark grey colour. - Due date: Flexible

Remove and replace guide rail on aluminum sliding gate. Must supply aluminum rail which is a right angle bracket 4x4centimetres, length 6.030 metres . Must do aluminum welding on site. - Due date: Needs to be done on Friday, 24 November 2023

Procure and install a compliant pool fence which will be removed after house renovation - Due date: Before Thursday, 30 November 2023

Quote to repair or replace a brushwood fence. Please quote the material used (E.g. colourbond or cheaper), including supply and install. (Approx. 8-10m. Quote based on 10m price)

The paling fence is leaning and needs to be straightened and secured. - Due date: Before Friday, 29 September 2023

I moved into a property without a gate. The street has rallied around and bought one and now we need to get it installed. We require to cut some of the concrete driveway on one side and dig a hole on the other side of the driveway and back-fill with concrete once the 2 posts are in place. - Due date: Flexible