Find experienced local fencing contractors in Glenroy VIC

Hi, I’m looking to get a quote to repair and straighten my front fence. The fence is currently leaning/titled towards the footpath and needs to be straightened and secured properly. I only want the bottom timber/base section (the red circled area in the photo) replaced/repaired, not the whole fence. The wire/mesh panels can stay if possible. Work needed: -Straighten leaning fence panels/posts -Replace or repair damaged/rotted bottom timber/base section -Reinforce and secure fence so it stands straight and stable -Check posts/supports and fix where needed Please provide an estimated cost for repair only, not full replacement.

In front and behind garage. I can provide material and my time to help

I have a metal side gate where the latch/bolt goes into a brick wall. The brick has worn out and been patched previously and the bolt can now be forced out, wearing away the brick. I need a proper, long-lasting fix. I believe we need to drill into the brick and install a steel receiver/sleeve (tube) for the bolt or something similar to fix the issue. Open to other ideas!

Fence has fallen apart as can be seen in the uploaded pic. It needs a horizontal post as it is rotten as seen in pic. Need the post to be replaced and fixed. Time - 5-6 PM on 25 Feb.

10m by 1.8m timber fence is wobbly and needs repair or replacement

The fence in the front yard has aged, leaning down and needs to be lifted and supported. We want a quick fix, nothing major( maybe a support stump, or something similar)

Looking for someone to remove this fence (and dispose) and rebuild it. Will need to completely rebuild, including digging in new posts. Price is for complete job: labour and materials and disposal of old fence . ***note: Currently the posts holes ahave concrete around them, however it might be better to swap the direction around so that the posts are on the opposite side of the fence and the new posts can be dug into grass/earth instead. Your call 😊

My cat keeps climbing the wooden fence so I want to install a barbed wire or chicken mesh wire pens on top of wooden peeling fans on three sides of property boundary.

In yesterday's strong winds the end of the side timber fence that joins a brick garage along the boundary between our house and next door has come away from the join and needs to be re-attached

i need a dog run build asap for my dog and i can’t do it myself

I'm a fencer and I need some help to lift a few heavy panels in place

Remove about 10m of existing timber fence without damaging them so that I can build a garage about 5cm from boundary. The plan is to reinstall the timber fence after construction finishes

Approximately 6m of fence needs to be removed and replaced.

Side fence needs replacing due to wind damage. It’s not a large fence

Fence needs to be made straight and needs to add about 6 meters of fence, which will need to be transported from Pascoe Vale, as I have some from another place. (can organise transport )

It seems that the wooden fence was attached to the back of the garage by cement or some sort of bonding thing. After many winds it has come loose and now seems somewhat dangerous. I think a bolt or two into the brick would. Probably fix it. You can see in the photos the gap that appears during high winds.

Replace small wooden fence * Dimensions: 1.2m width x 1.8m height * Palings material: Treated timber palings * Requires new structural support posts to be concreted in. * Requires new rails and kickboard. * No staining required.

Please make an offer $$$. Remove and dispose of old timber fence. Replace with 16m new timber fence. New posts need to be installed. No neighbouring home so work at ease.

I need to install metal gate 900 mm wide with two post. One post goes in the ground and another one on the wall. The gate needs to be assembled. All materials supplied.

Hi, I need a new fence and I'll also like 2 large trees planted to cover the windows . I would like the fence to have a gate and build a simple footpath to the door. I'd also like a quote to add a gate. Thanks.