Find experienced local fencing contractors in Baulkham Hills & Hawkesbury

Require experience with pool fence certification. A few small fixes around the pool fence. Will require a trip to Bunnings at Dural for wood section and stake and maybe screws. Ideally a handyman/gardener with experience meeting pool compliance rules: - use a shovel to level out the ground under pool fence in 4 small some sections of fence, where the ground is too high. - hammer wooden stake/plank in one small section (50cm section) where gap under fence is too large - check around the fence for any loose screws. See images of the pool certification fixes needed. Should take 1 hour.

Remove old fence and replace new fence about 19 meters with metal pillar every 2 meters

Need a carpenter to fix the fence and help to build a few steps in the backyard, timber provided.

In the garden gate the lock latch is apart from the post, big gap and can’t close with pat loch the gate. - Due date: Flexible

My garden gate need install after new fen ce swapped.

Looking for someone to install a garden gate Labor + Parts Width between house & fence approx. 105cm

The current wood gates of my garage are collapsing. The width is approximately 310cm and the height is 180cm. I still need access through therefore prefer a side gate + fence solution. Other options are welcomed as long as it meets my budget. This task will include material and labour. This work needs to be performed by qualified people with corresponding license. A tax invoice is requested. Due to the COVID restriction, with all due respect I need to make sure the compliance to the NSW rule to avoid possible fine. Please visit below hyperlink for information. https://www.nsw.gov.au/covid-19/rules/authorised-workers/renovations-repairs-maintenance-and-cleaning#greater-sydney Thank you so much.

Hi, I have the tasks as below: 1. You provide the garden gate as per the attached bunning timber gate type as well as all necessary auxiliary materials(adequate gate pole, latch, hinge, cement, painting the same colour as the fence, etc.) and installation. The access point is 1200mm in width, and 1500mm in hight. 2. Little carpentry works as per the attached points about scratch fix, replacement, and painting. I have got the batten and the wrap angle. 3. Carpentry license holder preferred. Thanks Zeek

I have about 20 holes in Brushwood Fencing that I need patched. The holes are caused from dogs and foxes. I need the holes patched with brushwood or alternative. The Patch only needs to last about 12 months until the entire fence is replaced. Attached are some example photos. Job in West Pennant Hills

Build a fence: Total length: 140meters Terrain: sloping Material: open to options Height: 1.2m Design: open to options

Need a fence secured hammered to a back verandah to keep a dog in. Using plywood not mesh

Colourbond fencing for dog yards, can organse fencing material my self if easier and just installation required - Due date: Before Monday, 8 January 2024

I’m putting $5, as I want someone to come and check the place first. Obviously this is not a price for the job. Wanted to get at least 2 quotes. We are moving to a house within 2 weeks and need fencing for my dogs just around the house, not a boundary fence. requirements: - roughly 90 meters around the house - roughly 1.2 meters high to avoid my big dogs jumping over the fence - consideration for the bottom of the fence as well, as I have a small dog who likes digging under the fence We will demolish everything when we start renovation, so this will be a temporary fence only for the next 12 months. Therefore, we want to go with a cheapest fence option, possibly just posts, paling for top and bottom, and wires. Open for professional suggestions. Looking for someone to come and have a look at the property ASAP. Also, want to hire someone who can start working sooner. Located in Dural.

Hi need to fence a small area for a dog ... will need someone to come and give quote

Replace existing wire fence with approximately 20 linear metres of new Colourbond 1800mm high fence on south boundary of residential property. Must have fencing contractor licence, expertise and insurance.

Description: Looking for an experienced fencer to supply and install a Colorbond fence around my property in Box Hill, NSW. Details: • Preferred colour: Monument (may consider Woodland Grey as second option) • Dimensions: • Rear boundary: approx. 12.5 m • Side boundaries: approx. 30.4 m (one or both sides may be shorter depending on layout) • Access gates required on both sides of the property • All materials to be supplied by you • Must include removal of any waste/rubbish from site Requirements: • Experienced in Colorbond installation • Able to provide examples of previous work or references • Licensed and insured Location: Box Hill, NSW Please provide a detailed quote including: • Cost of materials • Labour charges • Estimated completion time

hi, can someone please install 2x colorbond gates (monument) for me gate 1- 1.6m wide gate 2- 1.2m wide double sided lock please

2400mm wide x 1800mm high section of existing Colorbond fence damaged by wind and a falling tree. All vertical fence posts still good and solid, and would like to re-use most of the panels if possible. Seem to be readily available at Bunnings(Colour- Pale Eucalypt). However top and bottom rails completely twisted and need to be replaced. Don’t care how it looks, just want to keep the cost down and make it safe again.

Supply and install colourbond "Basalt" double gate (incl posts) between brick veneer house and colourbond fence. Approx length 2.5m. required Height 1.8m. First picture shows gap where gate is to be installed, Second picture shows sample of what we want installed. Gate needs to be installed low enough to ground to keep dog in yard.

Colorbond fence install, approx 20m long. Removal of old wooden fence and supply and install new colorbond fence 2m high. Woodland grey color

I have an old slightly bent wooden fence of approx length 15 meters, which I want to replace with a strong color bond fence. Area has slightly sloping ground, and I don't want the new fence to bend. Please suggest a way to make it stay straight. Please share a quote for this work or a range of price that you charge on per meter basis. I am flexible with days of the week but would prefer to get it done during next one month.

I need 2 colorbond gates supplied and installed. One needs to be approximately 104cm wide and the other approximately 95cm wide. Standard height. To match fence colour on photos. Located in Box Hill.

Hi there, I need 2 colorbond gates to match existing fencing. One gate approx 104cm wide, the other approx 95cm wide. Standard height.

Colourbond fence. Two wooden posts has rot at the base and is loose. Need to be replaced. I need the quote please.

Need to extend the height of my existing rear fence by 600mm. Total length of the fence is 15mts and is on a flat land. Access not a issue as the site is under construction. Would like colorbond panels color and pattern to match existing fence.

Install side gate on newly laid concrete walk path. Area is 2050mm (width), will need 1800mm (H) gate. Can have double gate or single gate (wide) with fixed panel, depends on quote.

Looking for licence trademan to supply and install new colorbond fence to replace existing timber fence. Approx. length 26m. Work also include removal of old fence and all rubbish. Land is flat except 7m slightly sloping towards the back. One new 100x100mm steel post is needed to hang existing garden gate.

Colorbond fence is wobbly and makes rattling noises when it’s windy. Seeking for help to get it fixed. Number of fence posts affected 2 Length of the fence to be fixed around 10m

I need to have my current boundary fences which comprises of colour bond mostly and a timber fence to spray painted in monument. We just had one of our neighbouring boundary fence replaced with a monument colour bond fence. We want all the fence colours to be the same.

I need my house left hand side colourbond fences to be replaced 1 m outside by adding wooden sleepers on the bottom to make the top of the fence at the same height. Total fence length is around 22 m. Will need 1 extra sheet (1 m) to close the extension.

The colorbond gates at our new property aren't secure and our dogs will be able to fit through the gap. I would also like a secure locking system

Replace Existing Wooden Fence with New Colorbond Fence I am looking to replace my existing wooden fence with a new Colorbond fence. The total length of the fence is approximately 20 meters. The current fence is old and needs to be removed and disposed of. Please provide a quote that includes all costs (labor, materials, disposal, etc.). Previous experience with fence installation is preferred. If possible, please share examples of similar work you have done.

Replace and supply Colorbond fence sheet and dispose old , size is around 1.8m (H)

Need a new colorbond fence. Land dimensions 33m length and 9m wide.