Find a local electronics repairer in Canterbury VIC

Looking for someone experienced in ceramic/enamel basin repairs to repair multiple chips around the bathroom basin, as shown in the photos. * Chips have accumulated over several years * Improve or redo the existing repairs as needed so they are smooth and professionally finished * Colour-match the repairs as closely as possible * Please provide photos/examples of similar repairs you’ve completed

The hose pops off at the gerni connection

Task: Connect solar CT clamps from basement inverter to main switchboard Description: I have a 3-phase FoxESS solar inverter and battery installed in the basement. The current transformer (CT) clamps were incorrectly installed on the basement sub-board rather than the main switchboard. I need a qualified solar electrician to: Install the 3 CT clamps on the incoming mains at the main switchboard (ground floor) so the inverter can measure total house load. Run Cat5/Cat6 signal cable from the main switchboard down to the inverter or sub board in the basement. Connect the CT wiring to the inverter and ensure correct orientation/polarity. Confirm the system is reading whole-of-house consumption correctly. Notes: 3-phase house. Inverter and battery located in basement next to basement switchboard. Main switchboard is on the ground floor. CT clamps already supplied with the system (may just need relocating). Cable run likely required between the two boards. Requirement: Must be a licensed electrician with solar experience.

The issue with it is that it doesn’t heat up, and the button flashes red showing error. GHD Soft Curl Tong Hair Curler

Location: Front entry steps / base of exterior wall A few tiles have detached from the vertical surface under the step edge Some old adhesive / render behind the tiles has crumbled Area is exposed to weather, so it needs to be repaired properly for outdoor use I’ve attached photos to show the current condition

We need to inspect our roof for a tapping noise during windy weather. Our roof is very difficult to access, that's why we are thinking about a drone. We don't know what causes the noise. Before we can call any trades for repairs, we need to figure out what is damaged or loose or broken.

Install an alpine amp and standalone amplifier. This is for a 97 Audi A3 with an afternarket head unit. I have the amplifier kit too soni don’t think any additional parts are required. The sub had its own amp (underseat thing) so the amp will power the 4 speakers.

The Clipsal switch inside the electricity box of the solar panels keeps flicking off every few days. I keep putting it back on. Panels seem to be working fine as I can track on the AGL app. Not sure why the safety switch turns off - other electric switches are as normal and no power outage.

Removal of 5 stumps at various sizes

One side of the stairs to our decking has moved resulting in the steps becoming disconnected from the edges and not usable. We need someone to realign and secure the steps so this doesn’t happen again. The wood is in good condition.

Remove 4 large portions of tree trunk (heavy will need trolley), a few additional branches, cut / grind clothes line and remove from property (will require grinder)

RCB switch keeps tripping after 2-3 mins even though nothing is connected to the sockets. I have narrowed down the problems with sockets but not sure which socket. So want someone to look at it and fix

40sqm Epoxy floor coating. Perhaps flake. - Due date: Flexible