Find trusted local electricians in Kelvin Grove

Electrical subcontractor wanted – $100 per hour including GST I’m an electrical contractor looking for another fully licensed electrical contractor to assist with roughing in a new build, starting Friday, 9 October, with approximately two weeks of work available. Must hold a current electrical contractor licence and electrical work licence, with your own ABN and insurance. Please get in touch with your availability and experience.

One aircon in the kitchen and one EV Charger in the garage. Both with existing connection.

One gpo recessed and a coax to ethernet terminated

Installing a new breaker 25 amp ( breaker included). All price inclusive.

Seeking Solar PV Replacement LABOUR ONLY- to remove existing 20 panels (2 array with 2 existing strings) and install 28 panels across the same two faces (16 + 12 panel arrays) on a highset tin roof. We will supply new 475w panels, rails and tin kits as well as our SAA electrician to supervise and connect. Existing rails may need to be moved due to panel sizing and ample rails and mounts will be supplied. Experienced installers only, with potential for more work

Subject: Power Tripping Issue – Request for Assessment and Quote Hello, I’ve been experiencing ongoing power tripping issues since first turning on my dishwasher about five days ago, and I’m hoping you can advise on the cause and provide a quote for repair. Before using the dishwasher, all appliances in my home were working normally. Since then, the power has been tripping frequently, especially when using appliances such as the kettle or microwave. I’ve tried a few tests to isolate the issue: • Even with all other appliances unplugged, turning on the dishwasher causes the power to trip. • Unplugging the dishwasher does not stop the power from tripping when using other appliances. • I tested the dishwasher on its own (with all other appliances off) and also tried a different power point, but it still caused the power to trip. Based on this, I’m unsure whether the issue is with the dishwasher itself or the electrical system. Could you please advise whether I need an electrician or appliance repair, and provide a quote for inspection and/or repair? Thank you

It is water leaking, seeking to fix it.

New light fittings and fans have been purchased and need a sparky to replace/install them. 4 x new light fittings and 2 x ceiling fans. Need completed asap before 04/03

Start pilot light on heater

I need a licensed electrician to replace my 2 x existing AC ceiling fans with new DC ceiling fans that I have already purchased. Scope of work: Remove existing AC ceiling fans (2) Install new DC ceiling fans (already onsite) (2) Remove existing fan speed regulators/dimmer switches Replace regulators with standard wall on/off switches. You have to provide this. (fans will be controlled by remote) Ensure constant power supply to DC fan receivers Make all wiring safe and compliant Test and confirm all fans are working correctly Requirements: Must be a Licensed Electrical Contractor Must provide a Certificate of Compliance / Electrical Safety Certificate upon completion for both fans Details: All fans and remotes are already onsite Ceiling height: standard residential Property type: residential house

Make 2 GPOs in my 2 story house. One in each floor. Please put your offer

Make 4 new power points. Replace fan. See photos and videos Bed 3 move the power point to the cross. Music room. Move the power point under or behind the cabinet and make new one close to the desk. Master bedroom. Make a new power point behind the blinds. Office. Move the power point to a place under the table top Replace the fan Please put your offer

Task Description: I need a licensed electrician to remove a standard ceiling light fitting and install a ceiling fan in its place. Details: Current fitting: standard flush-mount ceiling light (see photo). New fitting: ceiling fan (with/without integrated light – please advise if a particular type is recommended). The fan will need to be safely mounted on a proper ceiling bracket. Please check whether additional support is required to handle the fan’s weight and vibration. Confirm existing wiring and install the necessary switch/control: Option A: Replace current wall switch with a fan + light controller. Option B: Set up remote control operation for the fan/light. Ensure the fan is installed in compliance with Australian electrical standards and that it clears height requirements (minimum 2.1 m from floor). Requirements: Licensed electrician only. Provide all tools and safety equipment. Supply and fit a fan-rated mounting bracket if the current ceiling point is not suitable. What I Will Provide: The ceiling fan unit (please confirm model suitability before installation). Access to the property and clear workspace. Preferred Date & Time: Flexible, but sooner is better. Please confirm availability. Additional Notes: If you can also recommend a good quality ceiling fan model (quiet, energy-efficient, with or without light) before the job, that would be helpful.

I need a single phase EV charger to be installed at my property. Main power source is located close to where charger is to be installed

My bearded dragon is freezing cold in this weather due to the power to her heat lamp not working. One prong is broken from the plug (see photo).

I have a 100cc 2-stroke motor that powers my push bike. The electrical system is not working - there is no spark in the plug when I turn the engine over. I think the magneto section of the bike is busted ?

I want to swap hot and cold pipe of the hot water

Put in 2 dimmer switches or advise if we should change from cool to warm light to reduce glare.

The Contgactor is noisy and needs to be replaced. The task is to replace Contactor in appropriately sized enclosure. Strip and terminate corresponding cable. Loom and tidy cable. Test and commission.

Need a licensed electrician for a hws circuit breaker upgrade. Must be licensed Job to get done tomorrow morning New hot water system is 3.6kw Job is in Kelvin grove Photos attached