Find trusted local electricians in ACT

Registered electrician only: Supply and replace the cracked bathroom light/fan/heat switch plate and switches/mechanisms as required, secure properly, and test all functions. 2. Supply and fit a new cover plate / faceplate to the other wall switch/socket and confirm it is safely mounted. 3. Inspect the Omega SOH1SS slide-out rangehood, which is sagging on the left, and re-level/resecure it by checking and tightening or replacing mounting screws, brackets and cabinet fixings as required. 4. Fit the replacement rangehood bulb supplied by owner and test the light. 5. Test all items on completion and advise if any extra parts are required.

I currently have an LED downlight setup (see attached image), and I would like to convert or modify it so I can use a standard incandescent light bulb instead. I need a qualified electrician or experienced handyman Note: Budget is not the correct amount. You can post your budget with the offer

A list of lighting items: • New LED light strips for our kid's activity cubes • New LED light strips for our tarot card shelves • New plug in fairy lights for the arch behind our counter • New filament globe for the helmet light

Hi there, I’m looking for someone to assist with the following in my home: • Replace approx. 8–9 existing light fixtures with modern LED fittings • Replace 2 power point covers (no rewiring required) • Create 1 new ceiling light point in a bedroom (cutting access in ceiling + install) • Fix a bathroom heat lamp that is no longer sitting flush with the ceiling • Check bathroom exhaust fans (2x) – one not functioning another quite loud Notes: • Light fittings can be supplied • Please bring any other required materials/tools • Most items are straightforward swaps

Hi i am trying to get electrical safety done just for pool area. All work is done properly last year but electrician has moved from the place.

Hi, I need a licensed electrician to upgrade/install 20A weatherproof power outlets in my alfresco area for heavy-duty dryer that requires 20a outlet. Please quote including: - Labour - Materials - Any switchboard work

1. Carry out safe assessment and remediation of existing wiring that is non-compliant with AS/NZS 3000 standards and may present safety hazards, and re-route/prepare cabling to required new positions. 2. Install a new dedicated cooktop circuit (6mm² cable) running directly to the switchboard, protected by a 32A RCBO. 3. Install 6 new double power points and a cooktop isolation switch. 4. Provide and install a dedicated 15A power outlet for the new oven, and replace the existing 25A RCBO with a 16A RCBO suitable for the load.

Have an 8 kW split system that’s second hand I need installed. Electrical work is already done. It’s just the mechanical work and refrigeration systems that need to be installed.

（10mins job）Electrician needed to change a battery smart meter/smart power sensor, model ADL400N-CT, tech support from manufacture will provide you a new meter and instruct u to do this.

Electrician to replace two light switches in my home: • One four-gang switch in the bathroom • One single-gang switch in the bedroom I already have the replacement switches ready, this job is simply to install/swap them over

Supply and replace 2 x fluorescent lights to new 1200mm led baton lights . Supply and replace 2 gang switch

Need a new power point put in for my work station

The external unit is not starting properly. Indoor units work fine, but the outdoor fan was not spinning and now only spins slowly / intermittently. No loud noises. Likely run capacitor or electrical issue. Looking for diagnosis and repair ASAP.

I request a qualified electrician to install two pendant lights as per the circled green colour and deactivate (so they don't turn on) the two ceiling lights as per the circled red colour. In short: you would need to make the circled-red ceiling lights completely non-operational—so that only the pendant lights turn on when I use the switch—you would need to disconnect the wiring that supplies power to those ceiling lights. The wiring should be inside those individual red-circled lights.

I just need a light globe change - but it is an old socket. The switchboard has been upgraded.

All quotes welcome. I need 2 indoor lights replaced. One is a bathroom vanity light, and the other is a dining room ceiling light that has already been removed. The other two are outdoor wall lights that have already been removed. I already have the light fittings. There is existing wiring at the locations. I'm home all day Friday so flexible with timing, but perhaps not at the crack of dawn, and no later than 4pm please. I'll add photos shortly.

Two skylights side by side. Raked ceiling, exposed beams, tiled roof. 780x1400 fixed VELUX skylights M08. Have EKW01&03 side by side kits and solar blinds to fit. Need experienced installer.

Hi! We’re looking for a professional electrician or handyman to install four solar-powered security cameras at our home. All equipment comes in the box and is designed for easy installation — we just need someone experienced to set them up properly. Photos are attached for reference. If you're available, please let us know. Thank you!

I need two 70s wooden standard lamps to be rewired. Both have bayonet sockets for bulbs that look in good shape. Both have had cords cut at the base. I don’t have the replacement cord or wall socket. I’m in Wanniassa but I can drop these off Southside, especially Fyshwick.

An artwork fell and damaged the electrical socket, it has come away from the wall and the wooden mount is broken. Not needing exact match on style / wood, just need it fixed and working!