Find skilled builders in WA

Need someone to assemble a flat-pack EasyShed 3m x 1.5 (no anchoring required yet as it will go on a deck later).

Assemble my 4.5m x 2.25m EasyShed workshop shed. The shed will be supplied in flat-pack form and includes a portal frame kit. Please ensure the shed is assembled correctly, is square, and the doors open and close properly. No slab or anchoring is required.

To fill up a hole in my driveway.

I have a low concrete retaining wall with 6 posts where I need a neatening of the shallow concrete at the base

cutting part of garage to make a driveway to the back yard

Need someone to demolish brick pantry. Need to remove all waste materials. Need to have all equipment. Experience is required

Repair broken driveway wall, can reuse existing bricks once cleaned, I can source replacement bricks for broken bricks. See photos Wall is approx 4m by .8m, 10 course high approx.

Easy Shed assembly. 2.2m x 0.8m shed with no instructions so seeking someone with experience

I’m looking to have a 55sqm concrete pad broken up and removed from my rear garden. The concrete is 80mm deep. There is good access for machinery etc. I’m based in Bicton. Is this something you would consider?

Need Pagola and decking installed

Looking for someone to complete a demolition and waste removal job for a 6m2 room in Success.The task includes:Tile Layer Removal: Fracturing and popping the top surface finish away from the floor bed.Screed Bed Demolition: Jackhammering the thick underlying sand-and-cement mortar bed right down to the solid concrete slab.Waste Removal & Clean Up: Shoveling, clearing, and loading all the rubble into your own vehicle/trailer and carting it away.also remove toilet and plug it

Bathroom strip outy at spear

Duties include: * Removing demolition waste and loading it into a skip * General labouring * Final clean-up of the property * Assisting with basic demolition tasks as required Requirements: * Reliable and punctual * Physically fit * Steel cap boots and PPE preferred * Demolition or construction experience is a bonus but not essential

Cut back overhanging trees from driveway and take green waste away

Looking for someone to assemble a Stratco Handi-Mate Sliding door shed (1.86m wide, 0.85m deep and 1.90m high). It also comes with a shed floor beam kit that needs to be fitted. It will sit on pavers and no need for anchoring. This will be behind the house in a corner. Area will be cleared prior to the assembly.

FIREWOOD to be moved from driveway (with wheelbarrow) and stacked neatly in woodshed. Clear path to shed. There is a ramp to navigate down with wheelbarrow. Must have ABN

Need the shed frame pulled apart and emptied to skip bin. Frame is steel to be cut to the ground. Will need tools to cut it up to size to be stacked or placed in a skip/back of ute. Plus tear down a wooden pergola attached to the side of the house. This requires a team of 2. Should not be more than 3-4 hours for an experienced team.

I have purchased a garden shed 3m x 1.5m Gable Roof form easy shed and require is to be installed out the back on pavers and anchored down with the bolts provided

I require someone to remove all cupboards and remove the floor and wall tiling. Floor is approx 13sqmt, wall tiles is approx 8sqmt. Thisis an apartment on the first floor, there is a stair case next to the door and a walkway to the driveway. You remove all rubbish. I will be onsite to assist with the job as a labourer. No plumbing or electrical work is required. I have reposted the job as I left out it was on the first floor with stairs.

I need a trailer load of brick that has already been demo’d taken offsite. Little bit of sand as well. Must be done tomorrow, Wednesday, around lunch time.