Find an experienced builder in QLD

12x4.3m shed. Delivered in 7th of October. Would like to have it built. Can get someone else as well as I assume it’s a 2 person job at the minimum. I don’t know the price so just adding a random figure.

I need 25m x 5m excavated down by a metre or so, and then a retaining wall build. Retaining wall about 25m long 1m high I’m not sure on price so I’m going to put $50.

Need quotes for retaining wall. Either concrete or sandstone

G’day, my name’s Ben and I’m looking for a builder for a retaining wall project in a sloped yard at Mooooka. The area has just been cleared out by an excavator and roughly cut in. It’s approx 10-12m wide, 1m high walls planned as part of a two tier shelf design. It’s a large area retained so need an experienced builder who can design the drainage and structural support needed. Ready to start when schedule allows, please get in touch to discuss. Cheers Ben

3x2 easy shed assembly in Benowa

Job Description We’re looking for a licensed electrician to complete electrical works for a new pool installation. All trenching will be organised by us – we just need the wiring, installation, testing, and compliance handled. Scope of Works • Disconnect power to rear pergola area adjacent to shed. • Supply, wire and install new 32 A single-phase circuit from main switchboard to pool shed (approx. 25 m run – to be confirmed on site). • Switchboard: Supply and install RCBO (safety switch/circuit breaker combo) to protect the new pool shed circuit. Clearly label. • Pool Shed Power: • 1 x 15 A weatherproof GPO (IP-rated). • 1 x double weatherproof GPO (IP-rated). • Pergola Power: Relocate existing GPO with extra switch to post closer to shed, rewire as required. • Equipotential Bonding: Supply and install earth bond cable from switchboard to pool. Pool contractor will provide earth lug ready to connect. • Testing & Certification: Test all works, provide Certificate of Electrical Safety/Compliance. Exclusions • Trenching and conduit (by customer). • Pool contractor’s provision of bond connection. • Any unforeseen switchboard upgrades or asbestos panel replacement. ⸻ Site Details • Location: Carseldine, QLD • Trench: 600 mm deep, conduit and drawstring to be ready. ⸻ What We Provide • Trenches completed prior to your arrival. • Clear access to shed, pergola, and switchboard. • Must be a licensed electrician (provide licence number). • Must provide certificate of compliance. • Supply all materials (cable, RCBO, weatherproof GPOs, etc.).

Please message a detailed quote for 2 Plain Concrete Driveway Crossovers including driveways, front yard and side walkway. Total Area for New Plain Concreting 32MPA , minimum 100 mm thickness with SL82 Mesh is approx 340 Square meters, and removal of old Concrete driveway with one cross over and walk way is approx 120 square meters. Two Sliding Gates will be installed at both the drive ways once concrete task is completed. Please ensure the leveling for gates is straight levelled for the gates to slide open and close correctly once the gates are installed. It’s a Plain Concrete Driveways Project for a residential house at Jindalee. Thank you

We have two steel ramps on our driveway; on one, the welding has broken and needs to be re-welded. Job is to re-weld the ramp.

Need a sealer applied to driveway to protect it from cracking and UV. The driveway has been cleaned this weekend. So just need applying sealer. Can purchase sealer. Need to bring tools.

I need someone to knock down / dismantle and remove a wooden pergola from next to our house.

Install shed 3.2x2.2 and anchors

QUOTE PLEASE Looking for someone to visit property, look at scope of work and provide a quote to build a 5 M( H) X 3.5 m ( W) brick wall - approx not measured . fix kitchen tiles on the wall. Job required around the outdoor BBQ area at our home. Also need installing a garden shed on a new concrete pad Quote needed

Garden Shed Install - Brand New

(Pls give me offers and ignore budget) This area gets damaged as I work here 12 hours a day using a wheeled desk chair so I need below the vinyl to be solid prior to vinyl floor board being replaced

EasyShed 3m x 1.5m assembly. Have on site and ready to go. Flexible on dates.

Looking for someone to water blast my side paths and driveway in Robina. Needs to be completed tomorrow (Tuesday 19 August). Prefer it if you have your own water blaster as ine will probably be in use in another area.

I’m I’m looking for someone to build a protective structure around my sauna so it can be placed outside and kept safe from the rain. I’ve attached a photo of the weatherproof design I’d like to duplicate. Materials I already have: • Tin roof (photo) • Pallet for the sauna to sit on (photo) • Metal beams for the frame (photo) What’s still needed: • Water-resistant wood for the wall panels I’ve unfortunately had two previous Airtasker bookings where the person didn’t show up, which was really disappointing. I’m hoping to find someone reliable who can commit and get this done ASAP. If you’re dependable and ready to bring this project to life, let’s do it. Located in Currumbin Waters

Move 10 cubic metres of soil from a pile in our driveway to 7 raised garden beds about 20 metres away. We have one large wheelbarrow and shovel for you to use, but feel free to also bring your own equipment. The soil will be delivered on Monday 4 August from 11am-12pm. Therefore, the job cannot be done until after then. The work would need to be done across Monday afternoon and Tuesday day, or just on Tuesday day.

Repair 3 rusted posts as shown in pictures

I need a tim shed assembled. I have done about half of it and just need all the walls and roof assembled.