Find professional AV technicians near you

I need an AV installer to work as a sub-contractor on 27/10/2025 from 7 am to 4 pm (Maybe start at 6 am and may finish a bit later or earlier too, yet to be confirmed) Must have experience with audio-visual, TV Mounting, your own tools, working rights.

Potential casual job opportunity! Looking for someone experienced with audio visual hardware to assist with various small jobs around Sydney metro. Typical tasks include: - Swapping out circuit boards in AV gear - Replacing/installing interactive display panels (e.g. SMART boards, Clevertouch, etc.) - Mounting panels, running basic cabling - Testing equipment to make sure it's working properly - Taking photos and reporting back once done You’ll need to: - Have some experience with AV, IT, or electronics - Be confident using basic tools and following instructions - Be reliable and professional when on-site - Be able to travel to different locations across Sydney Bonus if you have: - Your own tools - Working with Children Check - White Card - ABN for repeat work

Hello, We are looking for an experienced handyman, AV installer, or joiner to gain access to the back of a large digital advertising screen at our retail store, in Ellenbrook. The Issue: A large vertical advertising screen in our store is offline due to a "Player Error". To fix this, our IT team needs to physically access the TV setup box and power cables located behind the screen. The problem is that the screen is built into a custom floor-to-ceiling black pillar and is completely inaccessible. We have been unable to slide or pull the screen out. It seems to be on a mounting rack, but it is stuck fast and will not budge. The release mechanism may be jammed/inaccessible, or the internal cables may be snagged. The Job: The ultimate goal is to gain access to the equipment behind the screen. There are two potential paths to success: 1. Investigate and Release (Preferred Method): Assess the mounting system and find a way to safely release and slide the screen out without damage. This may require specialized tools or knowledge of commercial display mounts. 2. Create an Access Panel (If Method 1 Fails): If the screen cannot be removed non-destructively, the task will be to carefully cut a neat, square access panel in the rear of the black casing. The cut must be clean and professional, large enough to reach the power cables and media player inside. Please note: Your job is to create access. You are not required to perform the IT fix itself. Requirements: - You MUST have experience with commercial AV installations, digital signage, or custom joinery. - You must have your own tools. - Must be able to work carefully within retail environment. - Public liability insurance is required. Location & Timing: Location: Ellenbrook Central, 11 Main Street, Ellenbrook WA 6069 (exact location will be provided once the task is assigned). When: This is a long-standing issue that we need resolved as soon as possible. Please state your availability in your offer. Thank you.

This is a pre-wiring job only. I am preparing the room for future home theatre upgrades. 1. HDMI and Conduit Run (Projector) • Supply and install a HDMI 2.1 Active Optical Cable (48 Gbps) from the AV rack location to the ceiling projector location (approx. 10 to 15 metre cable run) • Cable must be installed in the correct direction, with the source end at the AV rack and the display end at the projector • Install 50mm conduit in the ceiling cavity to support this cable run • Include a CAT6 cable alongside the HDMI for future projector control or firmware updates • Include a pull string or draw wire in the conduit for future cable upgrades • Test the HDMI cable using either a dedicated tester or by temporarily connecting a 4K source and display • Label both ends clearly: “HDMI – Source End” and “HDMI – Display End” 2. Speaker Cable Wall Terminations • Use the existing in-wall speaker cables for a 7.1 channel setup • Supply and install a 7.1 speaker wall plate at the AV rack location • Wall plate must be compatible with banana plugs • Terminate and label each channel: FL, FR, C, SL, SR, SBL, SBR, SUB • Use a multimeter or continuity tester to confirm: • Each run is continuous and unbroken • Polarity is correct • Channel labels match destinations 3. CAT6 Cable • Run one CAT6 cable from the AV rack to the projector location alongside the HDMI • Label both ends of the CAT6 • Test with a network cable tester to confirm pin continuity Please include in your quote: • What materials you will supply (HDMI cable, CAT6, conduit, wall plates) • Estimated time to complete the job • Confirmation of signal and cable testing • Any access requirements, such as ceiling entry

15 coaxial cables (Canare LV-61S Cable Video Coax 75-Ohm flexible) need to be terminated with appropriate BNC connectors (you would supply). These are for 12G SDI applications The cables would need to be tested so you will need a reliable cable tester.

Need the following installed for my 79 Series Landcruiser 2023 - Install Door Pods (Pods supplied by me) - Install 2 side trims (supplied by me) - Install 2 6 x 9 (supplied by me) - Install 2 splitters (supplied by me) - Install 2 tweeters (supplied by me) - Install Mic for head unit (Head unit already in place) - Install GPS for Head unit (Head unit already in place) Thanks,

Install and set up the TV (Wall-Mounted) and connect it via cable /LAN to the speakers, amp, and Antenna(currently absent) for free-to-air channels.

I am looking for installer for home theatre system. Looking for 7 speaker ( 3 wall +4 ceiling) installation. 1 sub woofer Amplifier 125” Screen

I need an av installer to upgrade our sound system in our church

I need an AV set up in our office. advice about equipment also welcome

It's 12 rooms (some very simple, a couple with slightly more complexity) across 3 sites. You'd be working with other full time guys from our team. They are all Microsoft Teams Rooms systems. Involved some cable running and some TV and equipment mounting.

Pull speaker cables, under false ceiling. Shift ceiling mounted projector to 2 meter, cut gypsum false ceiling 200mm to fix the ceiling speakersx4

Installation and set up of Logitech Conference System and tap control panel. TV is already wall mounted, will need to be removed for Logitech bracket to be installed. Will screw in. Need a hole in the table drilled for Tap control panel and connection to the camera unit.

Looking for an electrician or audio visual installer to install a sound system and 8 x LED light strips into a gym. All equipment provided and most outlets already installed as we were previously operating in the same room.

Assistance with installation of AV equipment Running cables through brush ports in rooms. Mounting Camera's above TV's Full days work - so hourly rate

We are looking for an installation technician to install professional audio visual equipment for high end government clients across Sydney. You will need to be able terminate cables and fit off projectors, displays, speakers in meeting rooms. You will need a NSW Police check and Working With Childrens check.

Ongoing AV installation work - Due date: Flexible

Wall mount two TV’s and setup AV - Due date: Needs to be done on Friday, 25 August 2023

Reseting up the av installation between sound bar - tv- Netflix - other apps - Due date: Flexible

We have just moved to Kilsyth and need the TV, amplifier and speakers to be wired up ASAP. Foxtel is on Wi fi already ! Also need my printer 🖨️ installed to the wi fi at the same location - Due date: Before Friday, 21 July 2023