Find a reliable appliance technician in Inner South West Sydney

Looking for an appliance repair technician to diagnose and repair a Smeg dishwasher (10+ years old). Symptoms: * Dishwasher powers on normally. * Cycles can be selected normally. * Dishwasher fills with water and appears to start a wash cycle. * Water remains in the bottom of the machine. * Dishwasher faults part way through the cycle with flashing lights and beeps. * Drain cycle produces only a very faint hum. * Water level does not decrease. Troubleshooting already completed: * Filters removed and thoroughly cleaned. * Sump inspected for obvious blockages. * Drain hose checked for kinks (one kink was found and corrected). * Dishwasher completed one cycle after hose was straightened, then fault returned. * Drain hose disconnected from sink plumbing and tested directly. * During drain cycle, no water exits the drain hose and water level in the dishwasher does not drop. Based on troubleshooting, the fault appears likely to be related to the drain pump or drain system, but I would like a professional diagnosis and quote before proceeding. Please advise: * Call-out fee * Diagnostic fee (if separate) * Experience with Smeg dishwashers * Earliest availability

Deinstall Ariston washing machine and take it out to the road or you can have it and installing New Haier washing machine today before 1PM

I have a Kogan remote that has seen better days and now needs repairing to turn my tv on and off. It is not a simple ‘change of battery’ problem. Obviously it won’t cost $10 but please Reach out and let me know the service charge.

Need to replace the Colton and freezer seal as it’s all worn out

The belt needs tightening as when in use the belt stops Send how much in text please

washing machine blinking and the water doesn’t drain

Installation of a pullout 60cm rangehood

Repair washer dryer Bosch error code 23

I need someone can fix the washing machine , i could not find the issue, its got water dropping from the rubber seal

New electric oven installed

The dishwasher's hose (top one on the photo) is leaking when draining water, probably needs replacement

Need Spigot Drilled out for Wachine Machine Drain Hose

Gas Cooktop Repair – Gas Valve Stuck Open One of the gas burner control valves on our cooktop has failed and is stuck in the open position. The affected burner is the top right burner. When the gas supply is turned on, gas flows continuously from this burner regardless of the knob position. For safety, the gas has been isolated at the mains. Looking for a licensed gas fitter/appliance repair technician to inspect and replace the faulty gas valve (or advise if another repair is required). Please provide a quote

Fisher & Paykel Heat Pump Dryer. Making a loud squeaking noise.

I need someone to install the canopy rangehood for new kitchen

Hi! Need help swapping out my mum's old washing machine for a Miele front loader (been stored in the garage). Here's the job: 1. Collect the Miele from the basement (B1) garage and bring it up to Level 5 via elevator. Please bring a 2nd person and a proper trolley. 2. Shift a few items around in the laundry (small chest freezer + shelving items) to make space — tight space, see photos. 3. Disconnect the old washing machine (Hitachi top loader) and drop it at the building's bulky waste area on B1 (council pickup is next week). 4. Install the Miele and run a quick test cycle to confirm no leaks or excessive vibration. Access: Lift between basement and Level 5. Tight laundry space. Please only quote if you've installed Miele or other premium European front loaders before, it's an expensive machine and I need to get this right for my mum.

My air dryer seems to be warming up but not drying my clothes. The clothes have steam coming out of it because it’s hot but they’re still wet. It’s like the air is not blowing through maybe? There’s dampness

My current rangehood stopped working, I want someone to remove the existing rangehood and install the new one. No cutting Or fitting is required. New Rangehood is exactly the same model and brand.

Need some that can fix my dishwashing machine

Looking for someone with kitchen cabinet experience to help install a new 900mm x 300mm sliding rangehood. The new rangehood vent area is larger than the existing one, so the surrounding cabinetry will need careful adjustment to accommodate it. We need someone who can handle both the installation itself and make the necessary modifications to the existing cabinets, keeping everything looking neat and intact. The cupboard is 300 deep, the current air vent area is 200, but new one is 300 deep, so the lower shelf area needs to be adjusted out effectively. New Range hood is a Westinghouse Model Number: WRR904SB, dimensions attached in image.