Find a reliable appliance technician in Inner South West Sydney

We have a range hood 600mm just need a installation,

Dryer turns off after a few minutes.

The dishwasher door doesn’t close. Need help with it please. Model: Smeg

We have a burnt cord for our gas heater. It'd be lovely to have it repaired ?ie, cut of the offending part and rewire to a new plug? Or if easier, replace the cord of the entire unit. See photos. Be lovely to have it done this weekend, we're in Rockdale and will be around home whenever you need us.

Looking for someone to professionally clean my washing machine. Been using it for everyday with clothes from office worker but also a tradie. About to give birth and want to wash all babies clothes but want to make sure it’s clean and clear of debris

Our fridge door opens from the left… but we would love if it opened on the right! 😀 If anyone has any experience / ability etc. on switching the hinges on a Samsung 427L Bottom Mount fridge, it would be greatly appreciated! ❄️

Plug is working. Power is going to motor but it won’t switch on

Hi, I need someone with experience modifying commercial stainless steel benches. Scope of work: 1. Cut off the lower right-hand shelf/support rails to create enough clearance underneath for a commercial dishwasher. 2. Trim the left-hand side edge of the bench to make it a straight edge (currently it has a return/flange as shown in the photos). 3. Deburr and smooth all cut edges so they are safe to use. 4. Please bring your own tools (angle grinder / stainless cutting tools etc.). The bench is already removed and easy to access. Photos are attached showing: * The lower shelf that needs to be cut. * The left side edge that needs to be trimmed into a straight line. Please let me know: * Your quote. Thanks!

Looking for an appliance repair technician to diagnose and repair a Smeg dishwasher (10+ years old). Symptoms: * Dishwasher powers on normally. * Cycles can be selected normally. * Dishwasher fills with water and appears to start a wash cycle. * Water remains in the bottom of the machine. * Dishwasher faults part way through the cycle with flashing lights and beeps. * Drain cycle produces only a very faint hum. * Water level does not decrease. Troubleshooting already completed: * Filters removed and thoroughly cleaned. * Sump inspected for obvious blockages. * Drain hose checked for kinks (one kink was found and corrected). * Dishwasher completed one cycle after hose was straightened, then fault returned. * Drain hose disconnected from sink plumbing and tested directly. * During drain cycle, no water exits the drain hose and water level in the dishwasher does not drop. Based on troubleshooting, the fault appears likely to be related to the drain pump or drain system, but I would like a professional diagnosis and quote before proceeding. Please advise: * Call-out fee * Diagnostic fee (if separate) * Experience with Smeg dishwashers * Earliest availability

Repair washer dryer Bosch error code 23

New electric oven installed

The dishwasher's hose (top one on the photo) is leaking when draining water, probably needs replacement

Need Spigot Drilled out for Wachine Machine Drain Hose

Gas Cooktop Repair – Gas Valve Stuck Open One of the gas burner control valves on our cooktop has failed and is stuck in the open position. The affected burner is the top right burner. When the gas supply is turned on, gas flows continuously from this burner regardless of the knob position. For safety, the gas has been isolated at the mains. Looking for a licensed gas fitter/appliance repair technician to inspect and replace the faulty gas valve (or advise if another repair is required). Please provide a quote

Fisher & Paykel Heat Pump Dryer. Making a loud squeaking noise.

Nordic Track 40, purchased in 2021. After losing power yesterday, the console has not come back on.

I need someone to install the canopy rangehood for new kitchen

Hi! Need help swapping out my mum's old washing machine for a Miele front loader (been stored in the garage). Here's the job: 1. Collect the Miele from the basement (B1) garage and bring it up to Level 5 via elevator. Please bring a 2nd person and a proper trolley. 2. Shift a few items around in the laundry (small chest freezer + shelving items) to make space — tight space, see photos. 3. Disconnect the old washing machine (Hitachi top loader) and drop it at the building's bulky waste area on B1 (council pickup is next week). 4. Install the Miele and run a quick test cycle to confirm no leaks or excessive vibration. Access: Lift between basement and Level 5. Tight laundry space. Please only quote if you've installed Miele or other premium European front loaders before, it's an expensive machine and I need to get this right for my mum.

My air dryer seems to be warming up but not drying my clothes. The clothes have steam coming out of it because it’s hot but they’re still wet. It’s like the air is not blowing through maybe? There’s dampness

My current rangehood stopped working, I want someone to remove the existing rangehood and install the new one. No cutting Or fitting is required. New Rangehood is exactly the same model and brand.