Hire a trusted appliance repair service in Inner South West Sydney

Dryer turns off after a few minutes.

The dishwasher door doesn’t close. Need help with it please. Model: Smeg

We have a burnt cord for our gas heater. It'd be lovely to have it repaired ?ie, cut of the offending part and rewire to a new plug? Or if easier, replace the cord of the entire unit. See photos. Be lovely to have it done this weekend, we're in Rockdale and will be around home whenever you need us.

Plug is working. Power is going to motor but it won’t switch on

Dishwasher not working F24 heat relay

Fix E02 of ever fit treadmill

LG washing machine repair Water is not entering the drum, water is leaking through the actual machine

Smeg dishwasher (approx 3.5 years old) leaks periodically at some point during the cycle. Does not leak constantly, nor does it seem as every time. When it does leak, there’s almost always water left in the bottom of the unit. It also leaked once when the unit was not in a cycle, and had the door ajar (just spontaneously began pumping to waste with no lights lit at all). It’s quite a slow leak from low on the front right side.

Looking for an appliance repair technician to diagnose and repair a Smeg dishwasher (10+ years old). Symptoms: * Dishwasher powers on normally. * Cycles can be selected normally. * Dishwasher fills with water and appears to start a wash cycle. * Water remains in the bottom of the machine. * Dishwasher faults part way through the cycle with flashing lights and beeps. * Drain cycle produces only a very faint hum. * Water level does not decrease. Troubleshooting already completed: * Filters removed and thoroughly cleaned. * Sump inspected for obvious blockages. * Drain hose checked for kinks (one kink was found and corrected). * Dishwasher completed one cycle after hose was straightened, then fault returned. * Drain hose disconnected from sink plumbing and tested directly. * During drain cycle, no water exits the drain hose and water level in the dishwasher does not drop. Based on troubleshooting, the fault appears likely to be related to the drain pump or drain system, but I would like a professional diagnosis and quote before proceeding. Please advise: * Call-out fee * Diagnostic fee (if separate) * Experience with Smeg dishwashers * Earliest availability

I have a Kogan remote that has seen better days and now needs repairing to turn my tv on and off. It is not a simple ‘change of battery’ problem. Obviously it won’t cost $10 but please Reach out and let me know the service charge.

Repair washer dryer Bosch error code 23

The dishwasher's hose (top one on the photo) is leaking when draining water, probably needs replacement

Nordic Track 40, purchased in 2021. After losing power yesterday, the console has not come back on.

My air dryer seems to be warming up but not drying my clothes. The clothes have steam coming out of it because it’s hot but they’re still wet. It’s like the air is not blowing through maybe? There’s dampness

My Bosch Series 4 dishwasher is showing error code “ER-09” at the end of the cleaning cycle and doesn’t dry the dishes. Looking for someone that is experienced with this issue and is able to fix it.

Washing machine Hisense HWFM8012 door seal is leaking water

Bosch washing machine approx 2 years old. An error 36 code is appearing with loud beeping sounds. Apparently error 36 refers to - Error E36 (or E36-10) on a Bosch washing machine indicates a drainage issue, meaning the machine cannot empty water, often due to a blocked filter, clogged drain hose, or a faulty drain pump. Resolve this by cleaning the drain pump filter, checking the hose for kinks, and clearing any obstructions

Just moved into a new place and it looks like the dishwasher is not working properly. It looks like it is not draining properly - please see photo.

Hired movers to move the washing machine from old place to new and in the process they dropped it upside down and one of the spring got out of the drums and the seal got out of place aswell.

Our dishwasher isn’t draining nor getting water in We have tried to look into it but we couldn’t find the issue Need asap