Find a professional tv antenna installation service in NSW

The home made vertical antenna is presently on my rear balcony. I need it removed and taken to the top of the roof. Where there is, presently a wooden post. Also. The required coaxial cable is in position. It needs to be shifted along the roof. So, it can run into my radio room. Downstairs.

I need a certified rigger + installer to install 2 mounts into a concrete ceiling. One will be an aerial suspension point for Lyra, silk, hammock etcand the other is a permanent mount for a dance pole. I already have the pole mount but still need to source the aerial mount. Budget is just a place holder, please provide quotes and whether you can assist in providing the aerial rigging point also.

Install tv antenna on double storey home. Builder has already installed tv sockets inside home.

Old tv antenna broken. Installing new tv anntenna on roof.

I have a clothesline and aerial that need to be mounted. I will need two wooden posts fixed to the concrete/tile slab. Then the clothesline attached to those posts. Then the aerial attached to one of those posts.

Move PowerPoint and antenna/data point 400mm down from current position in a wall

Install existing uhf radio and aerial on Mitsubishi MV Triton Bonnet bracket required for Aerial mount

I am looking for someone with experience in automotive trim or mechanics to fix the shark fin antenna on my Kia Sorento. I accidentally bumped the antenna against a garage door while reversing. There is now a small gap between the antenna base and the roof. The Task: • Access the antenna mounting bolt by partially dropping the rear of the interior headliner (lining). • Note: This car has a panoramic sunroof, so the headliner is rigid and needs to be handled carefully to avoid creasing. • Tighten the mounting nut to reseal the antenna against the roof. • Ideally, apply a small amount of automotive silicone sealant to ensure it is 100% watertight. • Ensure no damage to the headliner or the sunroof drainage tubes. Details: • Vehicle: Kia Sorento with Panoramic Sunroof. • Location: Gregory Hills, NSW. • Tools: You will need your own tools (likely a 19mm/22mm ratcheting wrench or deep socket)

Uninstall and removal of tv antenna and foxtel dish from 2 storey roof

I’m looking for an experienced professional to install a secure rigging point in my garage ceiling for an aerial hoop (lyra). The ceiling is solid concrete, so this will require proper drilling and installation of heavy-duty anchor points suitable for dynamic load (not just decorative use). I’m after someone who has experience with: • Installing ceiling anchors / rigging points • Working with concrete ceilings • Understanding weight load and safety requirements for aerial equipment What I need: • Installation of a strong, safe ceiling anchor (e.g. eye bolt or rigging plate) • Advice on the best hardware if I don’t already have the correct equipment • Ensuring it is safely installed and weight-rated for aerial use This will be used for aerial hoop, so safety is very important. Please only apply if you have relevant experience with rigging, structural installs, or similar work.

We have a working antenna in a two story house. There are two working points in the house but not where we need them. We either need these relocated or new ones installed.

Need this Antenna removed off the roof. Since it’s never used anymore. Should be a pretty simple job for someone who has done this before. I can take it to the tip myself. I just need it taken off.

Need the existing bracket removed, remove the electrical socket and rewire the antenna connection back down to bottom of wall. Then hang TV

Need antenna checked as free to air channels are not stable and cut in and out of service

The Tv channels are not working properly

replace antenna on my single storey roof (new antenna on-site already). Mast is in full working order, no adjustment required. Please bring ladder and tools. Can be done any day.

Aerial connection to TV has dropped out. I was having internet issues which was subsequently corrected but after a power outage the aerial is no longer connected to the TV. The TV itself is still operating fine but not for Live TV

I’m looking for someone to install an RJ45 (Ethernet) and TV antenna wall plate as shown in the attached photos. Details: Existing Ethernet and TV coax cables are already in the wall Open wall cut-out needs a proper dual wall plate installed Install and terminate: 1 × RJ45 data point 1 × TV antenna point Wall plate must be supplied by you, as I’m unable to source the correct plate from local stores such as Jaycar or Bunnings Wall plate to be flush, secure, and neatly finished. Please include supply of the wall plate in your quote Notes: No new cabling required, termination only Location: Schofields, NSW

Newly renovated but old house. Plugged the TV in to the antenna port but unable to get channels.

Install second free to air tv aerial on second story of house