Find professional mobile scratch repair near you

i got an accelerated program on my moped

Vauxhall grandland 2020 when car engine hot car shows all fault lights in dash then stop car . Keep 15 to 20 minutes car starts again normal. I have small OBD2 the code is U0073

I need a Full Post-Repair Audit with a focus on lateral impact damage to the nearside rear. Specifically, I want the hub run-out checked and a full geometry report to ensure the subframe hasn't shifted.

I need someone to diagnose and repair an intermittent no crank starting issue on a 2006 Mazda 2 in SE8. The car has already had a new starter motor and new battery fitted, but the issue still happens. A breakdown technician checked it and found the likely fault is the small starter solenoid trigger wire / terminal. They found corrosion where the wire is crimped into the terminal, and when they moved/wiggled the connection, the car started again. A temporary clean/tighten was done, but I was advised the proper repair is likely: replace the corroded terminal end or replace the short section of loom/wiring coming off the starter I am looking for someone who can: inspect and confirm the fault repair or replace the starter solenoid trigger wire terminal / short loom test it properly after repair Important: The starter motor and battery are already new, so I am not looking for more parts to be replaced unless properly diagnosed. Please only respond if you are confident with auto electrical / starter wiring repairs.

The material lining the roofing of the vehicle and the door area is coming off

the camera sometimes works but frequently freezes!

Looking for an experienced vehicle body repair specialist / welder to repair damage on a long wheelbase van. Work required: Cut out and replace damaged lower side/sill panels (replacement panels supplied) see both photos panels need replace are photos with arrows Weld in new panels and grind smooth Treat rust and seal properly Pull out dent on mid-side panel photo that is circled (prefer repair rather than replacement) Tools required: MIG welder Grinder and fabrication tools Dent puller (stud welder or similar) Location: Kings Norton Looking for someone experienced bodywork or restoration. Open to quotes — likely 1–2 days work.

Repair alloy wheel 2 cracks

Brought a used Honda 110 nsc vision 2013 was running fine then stopped had a mobile mechanic come out got it started then stopped a dsy later when I questioned him he said my connections need tighten n repaired and that my starter motor was bad n need a new one but I don’t have a replacement

Scratches on plastics and side of vehicle

The electrics for the lights and indicators need finishing and the sparks need looking at on my Kawasaki Vulcan VN750 trike

Someone keyed car on rear side

Halfords - e scooter puncture repair

I have a neco borsalino 50cc that wont start and it needs an Mot. I would need it collecting , repaired and mot'd

repair of this leather seat cover

We have 2 ford transit vans both with Rollershutter doors one of the Rollershutter doors will not go up sounds like the chain has snapped and the other shutter door will not go down

Seized power steering pump and new auxiliary belt needed

Casing broken and feed needs repairing

Ford Focus Zetec- Windscreen washers not squirting properly

Car port roof fix on the roof