Find professional electric boiler installation & repairs in Manchester

I have an EHC Comet Combi electric boiler power control PCB that is not energising the heating elements. The boiler display shows heating demand, pump and valves operate, but there is 0 volts on all three element outputs (T2, T4, T6) relative to neutral while heating is commanded. This confirms the triac output stage on the PCB has failed. The PCB is fully removed and can be supplied loose for bench testing and repair. What I need: Component-level diagnosis Repair or replacement of the failed triac/driver section Board tested to confirm 230V outputs under load simulation Board details: Electric boiler power PCB 230V AC mains Three switched element outputs via triacs I’m based in Salford and can drop the board off locally.

There is a leakage around boiler as well as the roof in the conservatory is also leaking

Hot water is working. Navien Boiler Heating isn't working, possible air lock

Full boiler service for Vailant Protec Combi Boiler by Gas Safe Engineer. Service needs to include cleaning boiler components and provision of a full report.

Need following doing on budget please Boiler service(working fine now but has service warning pop up) Fix some 10 radiators not warming properly 1 new 1800x600 radiator install with new pipework Got most of pipes etx Just price and day you can do this Thanks

Boiler pressure keeps dropping to 0.3 - 0.2

Boiler is leaking from the underneath of it.

My boiler is leaking from the casing, most likely the sump need replacing. I can provide the part i just need someone to replace it

Hi, I need a heating engineer to install my ESI ESRTP4RFW thermostat + receiver. Thermostat is wireless (batteries only). Receiver needs wiring to boiler’s call-for-heat terminals. Hot water works, heating doesn’t. Please wire, pair, and test. No boiler internal work needed.

I have the kitchen sink tap that needs replacing I have bled the radiators and topped up the pressure again and again, so seems like there is either a leak and/or the prv will need replacing Both tasks to be completed on same day

Water comes cold and hot, sometimes completely cold

Gas boiler needs fixing. urgently

Boiler is not working need urgently fixed

Boilers not working need to fix asap

Alpha E-tec 30nxs boiler with E-10 error code - low pressure

Water keeps coming and cold and hot, not stable

Go into my loft, take a photo of the error message on my boiler and turn it off at the wall

All ufh pipes installed. Manifold mounted all parts here. Just need to complete final connections / setup. Carry out connection to boiler and wiring. Set up ufh timers etc and show me how to use.

I am not getting hot water

I need assistance with repressurising my electric boiler (Electromax system) using the existing filling loop. The filling loop (silver braided hose) is already installed and connected with a black-handled valve on one end and a white plastic-handled valve on the other. When I try to top up the pressure, the black valve doesn’t seem to turn, and I’m unsure whether it’s already open or seized. The boiler currently shows low pressure, and I’d like a qualified plumber or heating engineer to: Check the filling loop valves and confirm correct operation.