Find professional pool maintenance in WA

Heat pump is gone, I think

There are 3-4 cracks on bottom of concrete pool, which needs repair, water has been drained

Davey StarFlo pool pump is not priming due to air and water leak at unions. Need someone to help fix and get it primed. No internal leaks as I have fixed this.

Push start button not working

I have a pool water leak around the skimmer box. All the pavers have sunk in that area and lossing water out of the pool

Doesn’t turn on the motor after long time without use. It was working perfectly but we went away for couple of months and when we came back, cleaned it but the motor or pump doesn’t turn on. The display still turns on but not the spa itself.

Pool pump makes buzzing noise when it turns on for minute it so then doesn’t pump. It did this a while ago then started working again. Think it’s the capacitor or potentially debris jamming it. Need someone to come fix it and have a look

I urgently need someone to inspect a leak and repair in my pool. I am pretty sure the leak is coming from a light recently installed. It just needs to be sealed properly

Pool cover has came off and light requires fixing, please see attached pictures and let us know should require anything else from my end, thanks Vik

Pool repair, jackhammer pool concrete remove rust and seal and reconcrete

Replace Gearbox / Worm Drive – Elite Pool Cover (Manual Handle) Budget: $200 labour (parts additional) Description: Location: Bicton I need an experienced technician to inspect and likely replace the worm drive / gearbox on an Elite pool cover manual handle system. The gearbox appears to be failing — suspected stripped worm gears, with the shaft slipping under load. Scope: Inspect manual handle gearbox assembly Confirm worm gear failure Supply and replace correct worm drive / gearbox (parts additional) Reassemble and test full operation Requirements: Proven experience with Elite pool cover systems Confirm you have access to the correct replacement parts Not seeking trial-and-error repairs Please confirm your experience and availability when responding. --- This will filter properly for someone competent rather than a general handyman.

I’m looking for an experienced pool technician / plumber to find and repair a suspected leak in my backyard concrete pool. What I need done: • Inspect pool + equipment (pump/filter/plumbing) for leaks • Locate leak (dye test / pressure test etc.) • Repair leak (quote first if major) • Confirm pool is holding water after repair

I had an old pump which stopped working , I got new pump but it has different adaptors , I meed to cut the pipes woth the old adaptors and fit and install the new ones

Hi how much is your charges to find a concrete vinyl below ground small size L shaped saltwater pool leak? I don't have the exact specs but it's about 4-6m long and 1.9m wide. I suspect the leak to be the return water jet hole/s based on lack of bubbles or water return in one of them and also the leak is 70mm loss of water level within 24-36hours in recent weeks or two it was identified. Pump has been turned off for now with no decrease in issue. Water has been topped up every few days in interim. How much would it cost you to find and fix the leak?

Can someone help me with repair two areas in my pool that were previously patched. Current patchwork has some soft polyuthane-like material. I need someone with experience in this, and that is able to dig concrete, cut rebar/install fibreglass rod, seal and re cement. Only two portions not the entire step, please don't make and offer to redo the all pool or the whole step. I need someone hands on that can assist in this for a 1 day job. No re-paint needed as I will do the whole lenght step at another time. Just need it fixed and patched.

Fit replacement sand filter and chlorinator

The spa is leaking behind one of the jets. Looking for a spa repair person who can fix it ASAP please

I need to get the pool in working condition.

Git a davey spa got it working well bought of market place the guy I bought it of said it all works got it home worked.once well.heated up with bubbles but then it comes.up now on display error 6 can you please come and tell me what to do to.solve the problem it could be airlock or something they said on you tube or.could be something else need some advise from an expert asap thanks

Repair pool pump only (there is air in the filter ) or also cleaning pool if the cost difference is not extreme. I can put chemicals in advance.