Find professional pool maintenance in NSW

Hi looking for a pool expert to replace my sand filter with a brand new sand filter. Also needing a premium pool clean. I would like to restore my pool. Its been out for a month and abit and now I want to get it back to running

Replace 40mm one way check valve in pool pump piping. Replacement valve already purchased.

POOL motor humming but doesnt start. If it's gone, need to be replaced. Need quote for both fix and replacement

Service of pool and spa. Checking the setting on the spa as its cutting out.

RolaChem 9 pool system fix leaks If parts required will pay with receipt

Need to replace the swimming pool salt chlorinator

Our pool pum was making too much noise. The advice is to replace it. Any one can supply and replace the pump please help

I am looking for someone experienced with spa repairs (spa technician preferred, or electrician with spa experience) to diagnose and repair a fault on a Signature Spa Mirage III. The spa was fully operational when inspected and collected from a previous owner's home a few weeks ago. It has since been relocated and reinstalled. Current issue: Spa powers on normally. Water begins circulating and jets start running. After approximately 5 seconds, the power trips. This occurs consistently each time it is restarted. The spa is connected to a newly installed 15A outlet. I am looking for someone to: Diagnose the cause of the fault. Check pumps, heater, control pack and electrical components. Identify whether the issue is related to moisture from transport, heater element, pump motor, wiring, or another fault. Provide a quote for any repairs likely required. Please only respond if you have experience working on spas, hot tubs, pumps, heaters, or spa control systems. Please include: Your experience with spa repairs. Whether your quote is for diagnosis only or diagnosis plus repair. Give a quote for diagnosis and replacement of heater as we think this is highly likely to be the problem.

Looking for a pool leakage expert to repair the pool.

Need a spa technician / plumber / someone handy and presentable to help fix saunas and ice baths on an ongoing basis

The pool pump is not working. It may have been caused by air in the system.

The spa bath powers on and makes a buzzing/humming noise when the button is pressed. However, the water jets do not work.

My pool pump is leaking from the PVC pipe connection/joint area above the pump housing. The leak appears to be around the pipe fitting/joint, as shown in the attached photo. I need someone experienced with pool pumps or pool plumbing to inspect and fix the leak properly. This may involve resealing, replacing the fitting, or repairing the pipe connection if needed. Details: - Leak is around the PVC pipe joint connected to the pool pump - Pump is installed and accessible - Please bring the tools and materials needed for diagnosis and repair - Experience with pool equipment and PVC pipe repairs preferred Scope of work: - Inspect the leaking joint - Identify the cause - Repair or replace the faulty fitting or pipe section - Test to make sure it no longer leaks Please include in your offer: - Your experience with pool pump or pool plumbing repairs - Whether materials are included Attached photo shows the leak location circled.

Pool chlorinator seems clogged with some white residue. this is stopping the pump from circulating - will need cleaned & then bring pool back to blue/swimmable before Easter. Pool is still very clean - just a little cloudy. Needs tiny basic clean.

My pool pump has stopped working. Based on the hum it is likely the capacitor. Need someone who is qualified to do electrical work to diagnose and repair the issue.

The pool water has turned green. I need the water cleaned and filtration tank replaced. Pool size is 7mx5mx1.5m.

I need my pool filter to be replaced with a new glass media system. I can play for the filter and parts separately or acquire it separately or the whole lot replaced and installed. $15 to get the bid going.

I’m looking for an experienced pool technician to: Replace the broken handle (or multiport top, if required) on my sand/media filter. Filter: Fluidra CA 280 Media Filter (40mm) Valve: 40mm multiport for CA filter – top mount MPV Give the pool a full clean (surface and bottom debris removed, walls/steps cleaned, baskets emptied, etc.). Test the water and bring the chemicals into balance (pH, alkalinity, chlorine and other key levels). Easy access down the side of the house to the equipment area. Please include labour and an estimate for any parts and chemicals in your offer (or note if parts/chems are additional).

Noticed the pool pump is not working after coming back from holiday. Need an experienced technician to have a look, troubleshoot and fix the issue for us.

Pool pump humming but not starting – likely capacitor Pool pump: Waterco Supatuf 1.0HP MK2 Pump powers on but only hums, does not spin and no water flow. Pump lid is seized and cannot be opened by hand. Suspect failed start capacitor or seized impeller (possibly after running dry). Looking for a technician who can: – Safely open the pump lid – Check if impeller spins freely – Test and replace start capacitor if required – Re-prime system Please advise availability, experience with pool pumps, and call-out cost.