148 Hot Water System Installers in QLD

Need an old (had been drained and disconnected) hot water unit cut out of a cupboard. It has been built in and will require cutting out.

Hot water off peak switch has tripped and can’t reset.

We recently got new taps for our shower put in but the hot water one doesn’t seem to turn on properly/get much hot water. We’re just after a plumber to come try to fix it.

Hi, I have a hot water cylinder that is constantly dripping from the overflow. Started slowly but the frequency of dripping water has increased over the past two weeks. If the cylinder needs replacing please send through a quote for a larger system. There are four people in the house and the current 140 litre capacity is too small Need someone to come and sort it out. Thanks

System is leaking water Rheem hot water system One tap/pipe

The old hot water tank is disconnected and sitting on the ground. Needs to be removed and disposed off.

Supply and replace washer in shower-tap leaking.

Looking for a plumber to replace a leaking release valve on a hot water system

I need someone to remove an empty disconnected hot water system. There's a few $$$ in scrapping it at a recycle centre so please take that into consideration when bidding. It's a big 315L system. Pickup on side of the road.

DUX 21 year old 145V-NB (145 litre natural gas, storage) leaking badly, no reignition. Pretty easy access, brick path (only few metres from road), cement slab. No GPO nearby, so Rinnai continuous (preferred) probably not an option.

I need to move my hot water system approximately five meters around the corner of the house. It will require being disconnected and moved and then reconnected. It will require running new pipe work and cable to the new location. I have an electrician who can do all the electrical work. I just need a plumber to do the rest. The house is a low set four year old brick home with access to the roof via the garage.

Need old Rheem 250L electric hot water system removed, new one placed in (Also Rheem 250L electric). New system is in a box, hasn't been unpacked, unit to be installed indoors, will require a stand/ground insulation of some sort as old one might be a bit busted

To supply labour and materials to replace existing 1000kpa TPR valve. Isolate water at HWS. Partially drain tank to facilitate installation. Disconnect and remove old faulty valve. Install new temperature and pressure relief valve to suit system. Reconnect relief drain, turn on water and test. To supply labour and materials to replace existing 15mm valve with new 850kpa Cold water expansion valve. Isolate water at HWS. Partially drain tank to facilitate installation. Disconnect and remove old faulty valve. Install new temperature and pressure relief valve to suit system. Reconnect relief drain, turn on water and test.

Hi. I’m in Holland Park West. My hot water tank is not heating water. It’s approximately six years old and is electrical. I have tried turning the main switch off and on again to reboot it but have not had much luck. I’m available before 7.30am or after 5.30pm on weekdays. Thanks.

Need plumber to move a hot water system a car is, stuck behind it

Need to replace 250l hot water system.

5yr service of solarhart roof top solar hot water system. Tank on roof. 2 story house. To be serviced as per solarhart recommendations.

Replace an existing 250L hot water system with new unit (straight forward swap). On the wall there’s the pressure relief valve, as is the stop cock and the pressure relief valve for the tank is included in the box/package. Disposal of old system (dump voucher provided). Experience doing this before is necessary.

Hot water system has a leak

Looking for a qualified tradesman to uninstall and remove an existing hot water cylinder and install an new 250L cylinder. Must supply all necessary pipes, fittings and consumables.