Find trusted mechanics in Windsor VIC

I am looking for someone to remove my old fuel pump and install new one which I have already. 2 of the screws holding in the old fuel pump have been stripped and I can not get them out, so would need to know how to get them out.

Need experienced mechanic service 2 cars – must follow exact oil change method. Oil and filters Supplied Description: Looking for someone to do an oil and filter service on 2 cars. This is not just a normal quick oil change. I want the job done exactly to a specific method step by step, so I need someone who is careful, patient, mechanically minded, and happy to follow instructions properly. Please only apply if you’re confident doing the below exactly as requested: Required oil change procedure: 1. Start with the engine completely cold. 2. Add about 1 litre / 1 quart of fresh oil to the existing oil as a pre-flush. 3. Start engine and let it idle for exactly 5 minutes. 4. Turn engine off and wait 10 minutes. 5. Then drive the car 10–15 minutes to full operating temperature. 6. Park on level ground, let it idle 2 more minutes, then drain the oil immediately while hot. 7. After the first drain, leave it for 30 minutes, then remove the drain plug again and do a second drain. 8. Fit new oil filter, but pre-fill the filter to about 60–70% with fresh oil first. 9. Apply a thin film of oil to the rubber gasket and hand tighten only. 10. Refill engine slowly with about 80% of oil capacity first. 11. Wait 5 minutes, then top up slowly in small amounts, checking the dipstick each time. 12. Final oil level should be around halfway between low and full, not overfilled. 13. After refilling, do not start the engine straight away. 14. Turn ignition on without starting, wait 10 seconds, then turn it off. 15. Repeat that 3 times. 16. Then start engine and let it idle for exactly 3 minutes without touching the accelerator. 17. Check for oil leaks around drain plug and filter. 18. Turn engine off, wait 2 minutes, then re-check oil level and top up if needed. Must Have • has experience servicing cars, or is very mechanically capable • has their own tools • works cleanly and carefully • is happy to follow this exact process, not their usual rushed method

I have a 2013 Alfa Romeo Giulietta. I need to replace the head unit. Unfortunately this model has a bespoke design and fascia. I've spent a lot of time looking into my options on various alfa forums and the option that is quite common is to install a 8.9 inch single din floating screen. This doesn't require cutting the fascia but does require a new mounting bracket and wiring adaptor. Luckily some people have put together a brief how to guide which I can provide. I can also provide the head unit, bracket, and wiring adaptor. I don't however have any installation skills or knowledge. I've put some photos up to show the current set up and a completed install.

on a Mitsubishi Pajero 2011

Front brake pads done on my ebike

Just like the description says, need somebody to come change the oil in the Volvo. It's a 2020 model, needs Castrol 0W-20 full synthetic

just have done e service today, and this is what they recomand

There is an oil stain in the carpark that was caused by a leak from my car. The stain needs to be cleaned and removed completely by the 8th of January. The task involves ensuring that the stain is fully removed so that the area is restored to its original condition, as it is important to address this issue promptly and responsibly.

I serviced my car myself and I have a bad oil leek. I think it’s the oil plug needs a proper tightening… would love someone to be able to help me plug it up correct! Cheers

Installing a new basic music head unit into a Hyundai Getz - Due date: Flexible

1) Install Sony XAV-AX5000 Head Unit (Apple Carplay/Android Auto) in a 2006 Honda Jazz 2) Install Pioneer Reverse Camera - Due date: Before Thursday, 6 October 2022