Find an experienced retaining wall contractor in NSW

I would like to build a decking platform across the back of the backyard. Over the retaining wall gap

I need about 15-20 holes dug to installed posts for retaining wall. Expected to be done on 18-19 July. Job is in Glen Alpine. Access via gate about 1m wide - 2 access - one on higher house, another one on lower ground. A bit of slope on the lower ground one. Thanks.

1. Demolish & dispose of ex brick retaining wall, dimensions (Length x Height x Width)in mm. 2300x250x110, 2200x340x110, 2500x400x200, 2200x440x200, 2900x600x200 .

Remove old retaining wall posts and timber sleepers Description: * Remove approx 10-11 galvanised steel retaining wall posts/ concrete footings * Remove approx 11 timber sleepers Notes: Concrete footings appear relatively small. * Steel posts are in good condition and should be retained where possible (not disposed of). * Please quote separately for: 1. Labour only 2. Labour + disposal of timber and concrete, some gravels Photos attached.

I have a front yard that needs red brick edging laid in. Job will consist of: - leveling the ground - clearing some concrete around a drain near the edge - laying brickwork (height will be about 2 to three bricks) Bricklayer to provide bricks (will be paid for ofcourse) No idea what the going rate is so please quote accordingly, or let me know if you want to visit before quoting. See image for outline of what needs doing - red is brickwork. Blue is a drainage trench we intend to dig underneath.

The timber retaining wall is being pushed from the dirt and considering there is only 1 timber post for about 2-2.5m it is unable to hold on and has been leaning. Looking for quotes to temporarily remove the fence panel, dig some of the dirt from behind the wall, remove the existing timber post that is leaning and replace it, add another 2 posts and put back the fence panel.

Installation of concrete sleeper retaining wall. Concrete sleepers,  posts and concrete supplied). The wall will be 2x1.5m sleepers in length and 2x0.2m sleepers high. Posts may need to be cut and 1 post needs to be attached to existing retaining wall.

The three timber posts in the backyard retaining wall have rotted and need to be replaced. I’d like to replace them with galvanized steel retaining wall posts rather than timber for better durability.

Cut metal post to size. Already installed retaining wall. Need the top cut to match length. Total post 25+ Need to cut the top off to make it a straighter line

3 steps/platforms each (approximately) 800 wide X 900 long X 250 deep for a total length 2700

Labourer Required – Digging Holes for Retaining Wall Posts Scope of Work * Dig multiple holes for steel retaining wall posts to help level the backyard. * Hole depths will vary from approximately 200 mm to 900 mm, with most holes being around 600 mm deep. * Hole diameters will be approximately 450–500 mm. * Soil conditions are a mix of clay and sandy soil. * This job is for digging the holes only. Site Details * Backyard is approximately 9 metres wide. * The sides are roughly 4 meters long. * The gap between most posts will be roughly 1.57m some will have shorter gap. *The backyard slopes from front to back. * Retaining walls will be installed to level the backyard. Requirements * Experience with manual excavation for post-hole digging and landscaping. * Own tools and equipment and preferably landscaping license so they know the digging requirements for my job and if I want to use them for future work I can to build the retaining wall.

1. Make a concrete base first. And add reinforcement/pillars. 2. Make a Brick/Block retaining wall in garden. 1.4 meters high and several meters in length (+30meters). Give me a "Material + Labour" quote for per square meter. Good if you can also do or arrange excavation.

11m retaining wall, concrete sleeper, 600mm above & below deck line (1200 total), 100mm Ag pipe, mesh, aggregate etc, battleaxe block so limited room to work say 1.5m from fence. I will remove trees before job start.

Refresh paint on retaining wall approx 50m long x 0.5m high

I am building a retaining wall to level backyard and need help to dig 600mm deep holes for posts. Need about 8 holes at back and 6 on side. Side one depth will reduce as we move towards the flat surface.

Need someone to fix water pooling and possible seepage issue in backyard concrete area beside retaining wall. Water appears to be coming through gaps near pavers/retaining wall from neighbouring side and pooling on concrete. Looking for practical drainage solution such as: - spoon drain - small channel drain - concrete grinding for better fall Would like inspection and quote first. Prefer experience with drainage and concrete work. Please message with ideas and previous similar jobs.

Paint timber retaining wall and stairs

Looking for an experienced tradesperson to repair and re-render an external retaining wall. Details: * Approx. 4m long x 0.8m high * Remove loose/damaged render * Surface already pressure washed * Patch cracks and prep surface * Apply new cement render for a smooth, weather-resistant finish * Includes small stair section on one side Notes: * Easy access * Please bring tools and materials * Open to suggestions on best finish Photos attached.

Need double brick retaining wall on the side of the car park 4 x layers of bricks only just to create plantation area Material provided Granville area

Run agi pipe (slotted and socked) behind old existing brick retaining wall. Max depth required is ~400mm. There are a few small roots around. Price can be inclusive or exclusive of parts. I can supply all parts if required. Note: Can use Megaflo product placed vertically so that the trench required is slim.