Find a professional gate installation in South East Perth

to fix the one door of the metal gate to the wall, as the screw has become loose and come out partially due to the impact of the dog care van hitting the gate

gate door hinges need to get fixed or replace but as you can see there isnt much space for replacement

Pool Gate do no close automatically as issues with hinges. Also need to decrease gap at one pool gate to comply with regulations

A fuse keeps blowing in a rental property. I suspect it is a result of the tenants appliances, or simply overloading the circuit. The home was built in the 70s so it's also possibly a wiring issue. Just need an electrician to take a look, and provide a report as to the probable cause (or a quote if works are required). You'll need to be able to provide an invoice for the job (less the airtasker fee).

Remove the steel fence and the colorbond gate Dismantle Dispose

I need a quote to install a gate at the front of my property.

Supply and Installation of approximately 5 m of fencing and 2 gates

We need someone to install 3 gates and close off one side of carport with fencing panels. It needs to be done neatly and professionally. Supply and installation. Measurements: Gate 1- 180*135 Gate 2 - 180*140 Gate 3- 180* 140 Panel only - 180*165

Using 90% water proof, uv resistant cream shadecloth enclose the side of the house to the laundry door for the cat run. Take it from the wall approx 3 bricks below gutter to the inside top of the fence. Must have a gate or door to access to clean. Fully enclosed. Will provide materials

I need both hinges on a front gate replaced

70s house fuse keeps blowing. Fuse wire has been replaced 3 times but continues having issues. This is a rental property, you’ll need to provide an electrical certificate if works are done, and also an invoice for the amount (less the Airtasker fee). I’ll be needing an electrician so future work is also likely.

The strong wind broke the post of my Colorbond gate in the yard. The base of the post was rusted, and it snapped due to the wind.

I need a small gate to be supplied and installed at my entrance. Please see the attached photo and let me know your offers

Please remove rusted screws from the gate (as pictured) and install new gate drop pin lock

I need two jobs completed: 1. Roller Shutter: The belt on my manual roller shutter has snapped and needs replacing. The shutter curtain itself is fine – only the belt needs to be fitted. 2. Side Gate/Door: My current side gate (arched, set between two brick walls) needs replacing. The timber panels are completely rotted, and the metal frame is rusted at the bottom. I need a new gate supplied and installed.

Need a baby gate installed asap, pic attached

Hi, Please help me take off the pole of the bar (photo 1), then move the caravan to the back of the house. The caravan is about 25ft. Then put back the gate (photo 2). I don't have the car to tow the caravan. Thanks

Bottom hinge on Side gate of house needs to be welded back on

Mechanical person that is able to replace damaged 2013 holden captiva 7 boot/tailgate. Have new boot ready for install

Electric motor on sliding driveway gate has stopped working. Request is for call-out for inspection and assessment of the issue causing the gate not to work.