Find an experienced gas fitter in Blacktown

Ignition switch not working for my gas stove

Connect BBQ to the existing gas line in the alfresco

Cooking Gas one of the ignitor just stop to work since few days.Gas is coming but ignitor flam not working.

Remove the four existing rusty gas rail burners from the built-in BBQ, supply and install four suitable new replacement gas rail burners. Check all connections, ensure the burners are correctly fitted and aligned, and test the BBQ to confirm safe and proper operation after installation.

Need a gas connection in my kitchen. I have a gas bottle in my backyard. There is a connection established already at my backyard one is going to the living room for heater. Heater I need extension from there to my kitchen also I need replace my electric stove to a gas stove. Pictures attached for reference. Please guide me how much this going to cost. Thanks.

Need to get Gas burner cleaned/ serviced. Few knobs seem to be loose.

I have Electrolux gas cook top want to do service . No issue .

I have Gas stove, need to fix, Very low flemming. and lighter also not working from gas stove.

Description: ​Looking for a fully licensed gas fitter to extend a natural gas line for a new freestanding cooker in Rouse Hill. ​Job Details: ​Scope: Extend the existing gas line (coming out of the wall on the right) using surface-mounted copper piping. ​Route: Run copper pipe down the wall to near floor/foot level, then horizontally underneath the unit over to the bottom-left inlet connection point. Total distance is approx. 1.5 metres. ​Requirements: ​Must supply all copper piping, brass fittings, and connection components. ​Must perform pressure testing, check for leaks, and connect the cooker. ​Must provide a NSW Gas Compliance Certificate (CCLI) upon completion. ​Licensed gas fitters only please. ​Photos of the current wall outlet and freestanding cooker setup are attached for reference.

Household Westinghouse 5 Gas stove requires usual maintenance, nobs not functioning as expected, requires multiple tries to get ignition

I need someone to recertify my gas connection and provide a compliance plate as my gas provider will not supply gas without it.

gas cooktop burner not staying lit the main burner malfunctioning repair if possible otherwise replace with new

I'm looking for a licensed plumber and gas fitter to supply and install the plumbing and gas connections for a new outdoor kitchen at my residential property. Scope of work: Supply and install a hot water line extending approximately 17 metres (around 3 metres above ground and the remaining 14 metres underground). Supply and install a cold water line extending approximately 12 metres (around 3 metres above ground and the remaining 9 metres underground). Supply and install a gas line extension of approximately 5.5 metres. Trench and backfill underground pipework where required (please confirm if this is included in your quote). Connect all water and gas services to the designated outdoor kitchen location. Pressure test all new water and gas lines and check for leaks. Supply all standard pipes, fittings, valves and consumables required to complete the installation. Ensure all work complies with current Australian Standards and local regulations. Provide any required compliance certificates upon completion. Additional information: The work is at a residential property. The outdoor kitchen location has already been determined. Site inspection can be arranged before quoting if required. Please provide a quote for labour and materials, or itemise them separately. Only licensed plumbers/gas fitters should apply. Please include your estimated timeframe and earliest availability.

I need a licensed gas fitter to confirm the reason why my gas meter is not registering usage. The meter shows the same reading since last couple of months. On approaching the gas distribution company they have advised to get this checked with a licensed plumber or a licensed gas fitter to confirm if the fault is in gas installation or in the gas meter. If the fault is in gas meter they will replace it but they need confirmation on this first

Electrolux Gas Cooktop burning with yellow flame - just one burner has this issue.

One of the valves on my gas stove cooktop is stuck in down position. I need it fixed so i can turn gas on and off for that burner.

Hi, I need a licensed plumber/gasfitter to disconnect an existing gas oven and safely cap off the gas line. Details: Scope: Disconnect the gas oven and cap the gas line securely. Compliance: Must be able to provide a certificate of compliance/compliance plate update if required by local NSW regulations. Requirements: You must be a licensed plumber/gasfitter. Please state your license number or confirm you are licensed when making an offer. Appliance disposal: Not required (I will handle disposal/moving the oven myself)

New gas outlet to be installed on same wall as the existing gas heater outside

Gas line inspection from Jemena found weep holes which need sealing up

Looking for someone to connect my gas pipe (already installed) to the cooktop. About 60CM between connection to Gastop (2).