Find experienced local fencing contractors in Baulkham Hills & Hawkesbury

Wanted help in setting up a trellis on this frame. The length is around 6mts and there will be 5 horizontal rows. Would need two more rows of wire so the total rows will be 7. The ends need to have the turnbuckle for tension.

Require experience with pool fence certification. A few small fixes around the pool fence. Will require a trip to Bunnings at Dural for wood section and stake and maybe screws. Ideally a handyman/gardener with experience meeting pool compliance rules: - use a shovel to level out the ground under pool fence in 4 small some sections of fence, where the ground is too high. - hammer wooden stake/plank in one small section (50cm section) where gap under fence is too large - check around the fence for any loose screws. See images of the pool certification fixes needed. Should take 1 hour.

Remove old fence and replace new fence about 19 meters with metal pillar every 2 meters

Need a carpenter to fix the fence and help to build a few steps in the backyard, timber provided.

In the garden gate the lock latch is apart from the post, big gap and can’t close with pat loch the gate. - Due date: Flexible

My garden gate need install after new fen ce swapped.

Looking for someone to install a garden gate Labor + Parts Width between house & fence approx. 105cm

Build an area for my dogs to play while being protected by snakes

(Negotiatiable on price) I need a section of my backyard fully fenced and snake-proofed for my two miniature dachshunds. The area is a narrow strip beside my house (see attached photos) — the ground is mostly dirt with a few uneven spots, rocks, and existing partial fencing that may need reinforcement or replacement. Requirements: • Install secure fencing around the section to keep dogs safely contained. • Reinforce or replace existing mesh where needed. • Make the area snake-proof (fine mesh or barrier along the base, sealed gaps, etc.). • Ensure the fence is dig-proof and escape-proof for small dogs. • supply materials (at my cost) Bonus if you can: • Level out the ground slightly • Add a small gate for access. Location: Laughtondale, NSW Access: Easy vehicle access, on rural property. Photos attached for reference.

I need fence to protect dog. one side 280cm and need a gate and othersidee 8ft completely covered no gate

t-post and wire dog mesh fencing for property on bush with some hilly terrain

I have about 20 holes in Brushwood Fencing that I need patched. The holes are caused from dogs and foxes. I need the holes patched with brushwood or alternative. The Patch only needs to last about 12 months until the entire fence is replaced. Attached are some example photos. Job in West Pennant Hills

Build a fence: Total length: 140meters Terrain: sloping Material: open to options Height: 1.2m Design: open to options

Need a fence secured hammered to a back verandah to keep a dog in. Using plywood not mesh

Colourbond fencing for dog yards, can organse fencing material my self if easier and just installation required - Due date: Before Monday, 8 January 2024

I’m putting $5, as I want someone to come and check the place first. Obviously this is not a price for the job. Wanted to get at least 2 quotes. We are moving to a house within 2 weeks and need fencing for my dogs just around the house, not a boundary fence. requirements: - roughly 90 meters around the house - roughly 1.2 meters high to avoid my big dogs jumping over the fence - consideration for the bottom of the fence as well, as I have a small dog who likes digging under the fence We will demolish everything when we start renovation, so this will be a temporary fence only for the next 12 months. Therefore, we want to go with a cheapest fence option, possibly just posts, paling for top and bottom, and wires. Open for professional suggestions. Looking for someone to come and have a look at the property ASAP. Also, want to hire someone who can start working sooner. Located in Dural.

Need to erect 30 meters long color bond fence in my backyard Type of gardening: Other Size of garden: 150m²-300m² Has green waste bin: Yes

Looking for an experienced Colorbond installer to: • Supply & install 7m of Colorbond fencing along the pool area (one side only). This is a temporary install required for council privacy and will be removed after OC. • Install two Colorbond side-access gates later, after OC, once the temporary fence is removed. Only the 7m fence is needed at this stage. The side gates will be a separate paid job after OC. Budget is set to 10 as a placeholder to start the conversation. Final agreed amount will be paid directly in cash.

My colorbond fence door has come off the wall because the post got detatched from the wall. Have a look at the pictures and let me know if you can drill new holes to fix it? Thanks

I would like to install a few fence extensions on both sides of my house. Fence extension to be purchased via bunnings (Matrix 2400 x 600mm Charcoal Rainforest Fence Extension). Image 1: 3.5 panels to be installed at side walk Image 2: One old extension to be removed and replaced. 3 panels to be installed here We would also like to have the extension installed above the gate (Image 3) but we would need to discuss whether this is possible

Currently timber fencing and needs replacement Need to install Colorbond fencing or Vinyl fencing 1.8m height. 29m + 26m + 15m Old fence to be removed

Looking for someone to supply and install 6.8m of concrete sleepers with Colorbond fencing on top. Job includes: • Supply & install concrete sleepers + steel posts • Install Colorbond fence (1.8m or advised height) • Excavation + concrete footings • All materials + labour • Clean up after work Area is between two driveways (see photo). Slight slope, sleepers needed to level it. Please quote full price and share past work. Flexible with date. Preferred colour of fence example attached in photos

Three colorbond fences are falling over. Looking to straighten them up and reinforce the base with concrete and post.

Add a two door gate to the existing colorbond fence. Full width about 3m. Can be used existing sheets or add new sheets. Week end is preffer.

42 metres of colorbond fencing to be done in a house in Cherrybrook. 1.2m high fence. Willing to pay $100 per metre including material cost.

It is a two level fence. Overall length is 25 m in one side and 25 m on other side. So 50 m of colour bond fence

Colorbond Fencing for sharing the cost with my neighbours quote for 46 Mushroom Street, Oakville, NSW 2765. The split is I wanted a quote to build 35.92m of fencing on 46 Mushroom Street NSW 2759 which I am sharing with my neighbours however we have a retaining wall 8-10ft which drips to my neighbours and the fence will be built in my side of the property Could you also kindly break the fencing quote down into 4 parts: Lot 57 - 10 Stringybark Road Oakville - 10m Lot 56 - 8 Stringybark Road Oakville - 10m Lot 55 - 6 Stringybark Road Oakville -12m Lot 54 - 4 Stringybark Road - 3.92m As I have different neighbours I would like the quote to be split: please provide your price as I had to put a budget amount but I need the real cost as a quote Thanks

I have the 8 panel colourbond top extension kit and require it installed and the lattice cut. Once the extension panels are intalled, i need a side gate measured and built to suit. I have attached images of one side that is complete and also images of the side that needs doing

I need 18m colour bond fencing done supply and install in Kellyville and removal of old timber fence removed and dispose by you plz quote

Replace existing wire fence with approximately 20 linear metres of new Colourbond 1800mm high fence on south boundary of residential property. Must have fencing contractor licence, expertise and insurance.

Description: Looking for an experienced fencer to supply and install a Colorbond fence around my property in Box Hill, NSW. Details: • Preferred colour: Monument (may consider Woodland Grey as second option) • Dimensions: • Rear boundary: approx. 12.5 m • Side boundaries: approx. 30.4 m (one or both sides may be shorter depending on layout) • Access gates required on both sides of the property • All materials to be supplied by you • Must include removal of any waste/rubbish from site Requirements: • Experienced in Colorbond installation • Able to provide examples of previous work or references • Licensed and insured Location: Box Hill, NSW Please provide a detailed quote including: • Cost of materials • Labour charges • Estimated completion time

hi, can someone please install 2x colorbond gates (monument) for me gate 1- 1.6m wide gate 2- 1.2m wide double sided lock please

2400mm wide x 1800mm high section of existing Colorbond fence damaged by wind and a falling tree. All vertical fence posts still good and solid, and would like to re-use most of the panels if possible. Seem to be readily available at Bunnings(Colour- Pale Eucalypt). However top and bottom rails completely twisted and need to be replaced. Don’t care how it looks, just want to keep the cost down and make it safe again.

Supply and install colourbond "Basalt" double gate (incl posts) between brick veneer house and colourbond fence. Approx length 2.5m. required Height 1.8m. First picture shows gap where gate is to be installed, Second picture shows sample of what we want installed. Gate needs to be installed low enough to ground to keep dog in yard.

Colorbond fence install, approx 20m long. Removal of old wooden fence and supply and install new colorbond fence 2m high. Woodland grey color

I have an old slightly bent wooden fence of approx length 15 meters, which I want to replace with a strong color bond fence. Area has slightly sloping ground, and I don't want the new fence to bend. Please suggest a way to make it stay straight. Please share a quote for this work or a range of price that you charge on per meter basis. I am flexible with days of the week but would prefer to get it done during next one month.