Find a fence installation professional in South Brisbane

Demolish an old timber fence approx. 10m. Take away. Remove gate post/gate. Stake out boundary. Build a timber retainer along the boundary 25m. Position it so that outer sleeper edge is as close to boundary line as possible, with most else inside our property. - Due date: Before Sunday, 7th Nov 2021

Looking at 20lm of pool fence to be installed we will supply

remove damaged gate and build new side fence - 2 m long and 1.8 high- timber palings. Some light landscaping will also be needed - Due date: Flexible

Install 25mtrs colorbond fencing. Materials onsite. - Due date: Flexible

Require a playground removed (can be cut out, owner will did posts out of the ground )at Holland park and re installed at Salisbury . Will need some new posts etc and they all need to be concreted in

Hi, Looking for someone with experience in stalling posts and colorbond fencing to give a hand in installing 14 Meters which is 6 panels and a 3 Meter colorbond gate. I will source all the materials and the posts. Prefer someone with some tools.

Installing a collapsable clothesline against wooden fence posts.. The fence posts are too far apart and you would have to nail in another piece/half a post to support the clothes line Photo attached

Build a timber fence 25m and 1.8m high. - Due date: Before Monday, 8th Nov 2021

Supply and installation of Butted Timber Fencing Must provide all materials and labour etc Pailing required on right hand side gate required on LHS - 2.2m including standard width gate On LHS when facing house from road fencing needs to go around tree (only slight- picture attached) No removal of old chain link fence required Measurements 1800 height with slope at the front yard 10m along rear 43m LHS facing house 40m RHS facing house Must be available to complete in full prior to Christmas. Please provide quote based on information provided in the ad. Thank you 😊

Hi There I need 4 x panels rails which are dented to be replaced with new 4 x rails I bought. Should not be more than a 2 hour job Ideally looking for someone who has done it before Stuart - Due date: Needs to be done on Wednesday, 24th Nov 2021

Hi, need someone to install remaining privacy screen ASAP as seen in picture. I have all materials except screws. The neighbours are aware and happy.

1. Run string line across area 2. Dig two holes (600mm x200mm) and set two metal fence posts (50mm x 50mm (supplied) where red dots are in picture. 3. Screw 2 metal fence posts where yellow dots are (supplied) 4. You to supply all tools and concrete (cannot use rapid set concrete). To be done this weekend ideally (or thurs or Friday)

Needing a side fence 35m long 2m high. Timber with hardwood posts, doesn't need to be lapped but must have no gap for privacy. Also need plinth along the bottom. Need existing chain wire fence removed.

Remove the old fence and install the new colourbond fence and new gate 1. Remove old metal fence and install new colourbond fence (one side) Old Length: 11m~12m Old height: 75cm Install new colourbond fence New height: 1.8m New Length: 11m~12m 2. Remove old wooden fence and install new colourbond fence (another side) Old Length: 19m~20m Old height: 1.2m Install new colourbond fence New height: 1.8m New Length: 19m~20m 3. Remove old wooden fence and install new colourbond fence (front) Old Length: 14m~15m Old height: 1.2m Install new colourbond fence New height: 1.8m New Length: 14m~15m 4. Install new colourbond gate Length: 3.8m~4.2m Height: 1.8m Budget: below $3750 including all materials, cleaning wastes and labor fees and costs Job completion by the end of December 2021

Provide quote to repair timber fence. Install new footings and timber fence palings where needed. - Due date: Before Sunday, 19th Dec 2021

Front gate needs replacing. Has a latch that can be opened from indoors too.

I would like a low gate installed off the side of our house. Ideally aluminium or similar. Depending on cost, I would also like another one on the other side of the house that is a bit taller to replace the wooden one we currently have.

I need 7m long and 1.8m high wooden fence installed in my front yard.

I have a fence that is needing to be replaced - approx 9m long by approx 1.2m high. I think some of it might be salvageable - two posts are fine, needs three posts to be replaced alone with the rails. The majority of the palings should be able to be reused.

Someone to replace the rotten timber post and beam Here is what I measured Beam : 7 meter long Post : 2.2 meter x 3 post Happy to reimburse the supply cost and delivery