Find a local electronics repairer in NSW

Two lamps, one works but shorts so needs rewiring. The second won’t turn on despite getting a new bulb, so we are not sure of the cause.


Need a handyman to get two IKEA Bestå cupboards to our 2nd-floor apartment in Ashfield. The cupboards are already on-site on the ground floor. Tomorrow (Sunday) is optimal as they are sitting in a common area, or as quickly as possible. 2 x IKEA Bestå storage units (approx. 193cm H x 120cm W x 42cm D)

 Task 1. Disassemble/flat-pack the cupboards on the ground floor so the pieces can clear the stairwell landing. 2. Carry the pieces up 2 flights of stairs to our apartment. 3. Reassemble both cupboards inside our unit. 4. Also a little assistance realigning some similar cupboard doors which we have had difficulty assembling the hinges. Assistance: We can give some assistance carrying up stairs
 Please bring your own tools (screwdrivers, hex keys/drill). Thank you!


Silicon kitchen cabinets (1 place), benchtop, 2 shower areas. Front gate has come off hinge. One bathroom door knob needs some sticking.

Looking for an experienced carpenter, cabinet maker or timber finisher to professionally sand and seal newly installed Specrite pine timber panels in a newly fitted office in Gordon, NSW. The work has already been installed and requires a smooth, high-quality furniture finish. Scope of works Floating shelves * 6 shelves * Each approximately 2200 mm (L) × 300 mm (D) × 22 mm (T) L-shaped desks * 5 custom L-shaped desks, each consisting of: * Main desktop: 2200 mm × 600 mm × 22 mm * Side return: 750 mm × 600 mm × 22 mm Job includes * Light sanding/preparation * Supply and application of a premium water-based clear polyurethane * Matte or satin finish (not gloss) * Light sanding between coats as required * Protect surrounding cabinetry, walls and flooring * Clean, even finish with no drips or visible brush marks Please include in your quote: * Whether materials are included * Brand and type of polyurethane you intend to use * Number of coats included * Estimated completion time * Photos of similar timber finishing work

Need to remove some tree stumps, there are around 8 - acess yo the backyard ones are upstairs through a gate

Change sink taps, bathroom

My GHD heats up but after a few minutes the on/off button goes red and it rings

Installation of hand rails on this step for my elderly parents

This job is to remove existing taps and replace with a pair of ¼ turn shower taps and mixer valves Ceramic valve core New tap part components are provided

Replace glass and doors,

Change taps and spout in 2 x bathroom vanities. Already have the taps and spouts.

I need three hedge tree stumps completely removed. Note: We will be planting new trees in the exact same spot, so the stumps and root systems need to be completely and properly removed/ground down.

Door closes then pops open not sure if need new tongue or adjusting

2 leaking taps that need to be fixed. They leak at the bottom of the handle when in a particular position.

I have 4 old Sonos Amps which need to be disconnected, and then connect up 3 new Sonos Amps. For one of the new amps, it will be going to the wires where one has already been disconnected. All speakers are in ceiling/behind vents and all work, so just need Amp’s swapped. Thanks!

Remove & Trash IKEA Items: Drawers, Two 2-Meter Countertops, Table & Chair

There are two stems to be removed, please find attached photos. Its very small and not too big.

I need some new taps installed in the bathroom. A plumber has already replaced the pipe and got it ready but the taps I bought had a fault. Should be very straight forward.

I need the power point installed. Tile has been cut and the wall behind is gybrock.

• Replace the kitchen tap with a like-for-like tap set. • Replace the laundry taps with like-for-like taps. • Install and plumb in a new laundry tub. All labour cost only.